From: David Wu <david.wu@rock-chips.com>
To: davem@davemloft.net, heiko@sntech.de, robh+dt@kernel.org,
mark.rutland@arm.com, catalin.marinas@arm.com,
will.deacon@arm.com, olof@lixom.net, linux@armlinux.org.uk,
arnd@arndb.de
Cc: andrew@lunn.ch, f.fainelli@gmail.com, peppe.cavallaro@st.com,
alexandre.torgue@st.com, huangtao@rock-chips.com,
hwg@rock-chips.com, netdev@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-rockchip@lists.infradead.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org, David Wu <david.wu@rock-chips.com>
Subject: [PATCH 10/11] ARM64: dts: rockchip: Add gmac2phy node support for rk3328
Date: Fri, 23 Jun 2017 13:03:38 +0800 [thread overview]
Message-ID: <1498194218-8310-1-git-send-email-david.wu@rock-chips.com> (raw)
In-Reply-To: <1498192929-7519-1-git-send-email-david.wu@rock-chips.com>
The gmac2phy controller of rk3328 is connected to internal phy
directly inside, add the node for the internal phy support.
Signed-off-by: David Wu <david.wu@rock-chips.com>
---
arch/arm64/boot/dts/rockchip/rk3328.dtsi | 25 +++++++++++++++++++++++++
1 file changed, 25 insertions(+)
diff --git a/arch/arm64/boot/dts/rockchip/rk3328.dtsi b/arch/arm64/boot/dts/rockchip/rk3328.dtsi
index 7e69f1f..29b3800 100644
--- a/arch/arm64/boot/dts/rockchip/rk3328.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3328.dtsi
@@ -63,6 +63,8 @@
i2c1 = &i2c1;
i2c2 = &i2c2;
i2c3 = &i2c3;
+ ethernet0 = &gmac2io;
+ ethernet1 = &gmac2phy;
};
cpus {
@@ -391,6 +393,29 @@
status = "disabled";
};
+ gmac2phy: eth@ff550000 {
+ compatible = "rockchip,rk3328-gmac";
+ reg = <0x0 0xff550000 0x0 0x10000>;
+ rockchip,grf = <&grf>;
+ interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "macirq";
+ clocks = <&cru SCLK_MAC2PHY_SRC>, <&cru SCLK_MAC2PHY_RXTX>,
+ <&cru SCLK_MAC2PHY_RXTX>, <&cru SCLK_MAC2PHY_REF>,
+ <&cru ACLK_MAC2PHY>, <&cru PCLK_MAC2PHY>,
+ <&cru SCLK_MAC2PHY_OUT>;
+ clock-names = "stmmaceth", "mac_clk_rx",
+ "mac_clk_tx", "clk_mac_ref",
+ "aclk_mac", "pclk_mac",
+ "clk_macphy";
+ resets = <&cru SRST_GMAC2PHY_A>, <&cru SRST_MACPHY>;
+ reset-names = "stmmaceth", "mac-phy";
+ phy-mode = "rmii";
+ phy-type = "internal";
+ pinctrl-names = "default";
+ pinctrl-0 = <&fephyled_rxm1 &fephyled_linkm1>;
+ status = "disabled";
+ };
+
gic: interrupt-controller@ff811000 {
compatible = "arm,gic-400";
#interrupt-cells = <3>;
--
1.9.1
next prev parent reply other threads:[~2017-06-23 5:00 UTC|newest]
Thread overview: 31+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-06-23 4:41 [PATCH 00/11] Add the mac internal ephy support David Wu
2017-06-23 4:41 ` [PATCH 01/11] net: phy: Add rockchip phy driver support David Wu
2017-06-23 13:55 ` Andrew Lunn
2017-06-23 16:18 ` Florian Fainelli
2017-06-24 2:10 ` Andrew Lunn
2017-06-24 2:19 ` Andrew Lunn
2017-06-24 8:38 ` Heiko Stuebner
2017-06-24 14:04 ` Andrew Lunn
2017-06-24 16:05 ` Heiko Stuebner
2017-06-27 14:44 ` David.Wu
2017-06-27 14:46 ` Andrew Lunn
2017-06-27 15:07 ` David.Wu
2017-06-23 4:42 ` [PATCH 02/11] multi_v7_defconfig: Make rockchip mac phy built-in David Wu
2017-06-23 4:42 ` [PATCH 03/11] arm64: defconfig: Enable CONFIG_ROCKCHIP_MAC_PHY David Wu
2017-06-23 4:42 ` [PATCH 04/11] net: stmmac: dwmac-rk: Remove unwanted code for rk3328_set_to_rmii() David Wu
2017-06-24 2:22 ` Andrew Lunn
2017-06-23 4:59 ` [PATCH 05/11] net: stmmac: dwmac-rk: Add internal phy support David Wu
2017-06-23 16:22 ` Florian Fainelli
2017-06-27 14:21 ` David.Wu
2017-06-27 14:52 ` Andrew Lunn
2017-06-23 17:19 ` Heiko Stuebner
2017-06-27 14:33 ` David.Wu
2017-06-27 15:40 ` Heiko Stuebner
2017-06-24 2:29 ` Andrew Lunn
2017-07-27 12:44 ` David.Wu
2017-06-23 4:59 ` [PATCH 06/11] net: stmmac: dwmac-rk: Add internal phy support for rk3228 David Wu
2017-06-23 5:01 ` [PATCH 07/11] net: stmmac: dwmac-rk: Add internal phy supprot for rk3328 David Wu
2017-06-23 5:02 ` [PATCH 08/11] ARM: dts: rk322x: Add support internal phy for gmac David Wu
2017-06-23 5:02 ` [PATCH 09/11] ARM: dts: rk3228-evb: Enable the " David Wu
2017-06-23 5:03 ` David Wu [this message]
2017-06-23 5:04 ` [PATCH 11/11] ARM64: dts: rockchip: Enable gmac2phy for rk3328-evb David Wu
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1498194218-8310-1-git-send-email-david.wu@rock-chips.com \
--to=david.wu@rock-chips.com \
--cc=alexandre.torgue@st.com \
--cc=andrew@lunn.ch \
--cc=arnd@arndb.de \
--cc=catalin.marinas@arm.com \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=f.fainelli@gmail.com \
--cc=heiko@sntech.de \
--cc=huangtao@rock-chips.com \
--cc=hwg@rock-chips.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=linux@armlinux.org.uk \
--cc=mark.rutland@arm.com \
--cc=netdev@vger.kernel.org \
--cc=olof@lixom.net \
--cc=peppe.cavallaro@st.com \
--cc=robh+dt@kernel.org \
--cc=will.deacon@arm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).