linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Schrempf Frieder <frieder.schrempf@kontron.De>
To: "linux-mtd@lists.infradead.org" <linux-mtd@lists.infradead.org>,
	"boris.brezillon@bootlin.com" <boris.brezillon@bootlin.com>,
	"linux-spi@vger.kernel.org" <linux-spi@vger.kernel.org>,
	Shawn Guo <shawnguo@kernel.org>, Li Yang <leoyang.li@nxp.com>
Cc: "dwmw2@infradead.org" <dwmw2@infradead.org>,
	"computersforpeace@gmail.com" <computersforpeace@gmail.com>,
	"marek.vasut@gmail.com" <marek.vasut@gmail.com>,
	"richard@nod.at" <richard@nod.at>,
	"miquel.raynal@bootlin.com" <miquel.raynal@bootlin.com>,
	"broonie@kernel.org" <broonie@kernel.org>,
	"david.wolfe@nxp.com" <david.wolfe@nxp.com>,
	"fabio.estevam@nxp.com" <fabio.estevam@nxp.com>,
	"prabhakar.kushwaha@nxp.com" <prabhakar.kushwaha@nxp.com>,
	"yogeshnarayan.gaur@nxp.com" <yogeshnarayan.gaur@nxp.com>,
	"han.xu@nxp.com" <han.xu@nxp.com>,
	"Schrempf Frieder" <frieder.schrempf@kontron.De>,
	Rob Herring <robh+dt@kernel.org>,
	"Mark Rutland" <mark.rutland@arm.com>,
	"linux-arm-kernel@lists.infradead.org" 
	<linux-arm-kernel@lists.infradead.org>,
	"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
	"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>
Subject: [PATCH v5 2/9] arm64: dts: Reflect change of FSL QSPI driver and remove unused properties
Date: Tue, 13 Nov 2018 13:47:21 +0000	[thread overview]
Message-ID: <1542116782-13118-3-git-send-email-frieder.schrempf@kontron.de> (raw)
In-Reply-To: <1542116782-13118-1-git-send-email-frieder.schrempf@kontron.de>

The FSL QSPI driver will be moved to the SPI framework and it then
acts as a SPI controller. Therefore the subnodes need to set
spi-[rx/tx]-bus-width = <4>, so quad mode is used just as before.

Also the properties 'num-cs' and 'bus-num' were never read by the
driver and can be removed.

The property 'fsl,qspi-has-second-chip' is not needed anymore
and will be removed after the old driver was disabled to avoid
breaking fsl-ls1046a-rdb.dts.

Signed-off-by: Frieder Schrempf <frieder.schrempf@kontron.de>
---
 arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts  | 3 ++-
 arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts  | 4 ++--
 arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts  | 6 ++++--
 arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi | 4 ++++
 4 files changed, 12 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts b/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts
index dff3d64..8a50094 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts
@@ -135,7 +135,6 @@
 };
 
 &qspi {
-	bus-num = <0>;
 	status = "okay";
 
 	qflash0: s25fl128s@0 {
@@ -143,6 +142,8 @@
 		#address-cells = <1>;
 		#size-cells = <1>;
 		spi-max-frequency = <20000000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
 		reg = <0>;
 	};
 };
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts b/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts
index e58a8ca..2f220ec 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts
@@ -163,8 +163,6 @@
 };
 
 &qspi {
-	num-cs = <2>;
-	bus-num = <0>;
 	status = "okay";
 
 	qflash0: s25fl128s@0 {
@@ -172,6 +170,8 @@
 		#address-cells = <1>;
 		#size-cells = <1>;
 		spi-max-frequency = <20000000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
 		reg = <0>;
 	};
 };
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
index a59b482..07c665c 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
@@ -99,8 +99,6 @@
 };
 
 &qspi {
-	num-cs = <2>;
-	bus-num = <0>;
 	status = "okay";
 
 	qflash0: s25fs512s@0 {
@@ -108,6 +106,8 @@
 		#address-cells = <1>;
 		#size-cells = <1>;
 		spi-max-frequency = <20000000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
 		reg = <0>;
 	};
 
@@ -116,6 +116,8 @@
 		#address-cells = <1>;
 		#size-cells = <1>;
 		spi-max-frequency = <20000000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
 		reg = <1>;
 	};
 };
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi
index c11f52e..10d2fe0 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi
@@ -134,6 +134,8 @@
 		#size-cells = <1>;
 		compatible = "st,m25p80";
 		spi-max-frequency = <20000000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
 		reg = <0>;
 	};
 	flash2: s25fl256s1@2 {
@@ -141,6 +143,8 @@
 		#size-cells = <1>;
 		compatible = "st,m25p80";
 		spi-max-frequency = <20000000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
 		reg = <2>;
 	};
 };
-- 
2.7.4

  parent reply	other threads:[~2018-11-13 13:47 UTC|newest]

Thread overview: 26+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-11-13 13:47 [PATCH v5 0/9] Port the FSL QSPI driver to the SPI framework Schrempf Frieder
2018-11-13 13:47 ` [PATCH v5 1/9] ARM: dts: Reflect change of FSL QSPI driver and remove unused properties Schrempf Frieder
2018-11-13 13:47 ` Schrempf Frieder [this message]
2018-11-13 13:47 ` [PATCH v5 3/9] spi: Add a driver for the Freescale/NXP QuadSPI controller Schrempf Frieder
2018-11-14  8:39   ` Yogesh Narayan Gaur
2018-11-14  8:50     ` Schrempf Frieder
2018-11-14  9:03       ` Schrempf Frieder
2018-11-14 10:43         ` Yogesh Narayan Gaur
2018-11-14 10:46           ` Boris Brezillon
2018-11-14 11:07           ` Schrempf Frieder
2018-11-15  6:22             ` Yogesh Narayan Gaur
2018-11-15 11:43               ` Schrempf Frieder
2018-11-15 13:12                 ` Boris Brezillon
2018-11-15 14:01                   ` Schrempf Frieder
2018-11-16  5:41                     ` Yogesh Narayan Gaur
2018-11-16  9:42                       ` Schrempf Frieder
2018-11-16  9:46                         ` Yogesh Narayan Gaur
2018-11-16 10:10                           ` Schrempf Frieder
2018-11-13 13:47 ` [PATCH v5 4/9] dt-bindings: spi: Move the bindings for the FSL QSPI driver Schrempf Frieder
2018-11-16 22:59   ` Rob Herring
2018-11-13 13:47 ` [PATCH v5 5/9] dt-bindings: spi: Adjust " Schrempf Frieder
2018-11-16 22:59   ` Rob Herring
2018-11-13 13:47 ` [PATCH v5 6/9] mtd: fsl-quadspi: Remove the driver as it was replaced by spi-fsl-qspi.c Schrempf Frieder
2018-11-13 13:47 ` [PATCH v5 7/9] ARM: dts: ls1021a: Remove fsl,qspi-has-second-chip as it is not used Schrempf Frieder
2018-11-13 13:47 ` [PATCH v5 8/9] ARM64: dts: ls1046a: " Schrempf Frieder
2018-11-13 13:48 ` [PATCH v5 9/9] MAINTAINERS: Move the Freescale QSPI driver to the SPI framework Schrempf Frieder

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1542116782-13118-3-git-send-email-frieder.schrempf@kontron.de \
    --to=frieder.schrempf@kontron.de \
    --cc=boris.brezillon@bootlin.com \
    --cc=broonie@kernel.org \
    --cc=computersforpeace@gmail.com \
    --cc=david.wolfe@nxp.com \
    --cc=devicetree@vger.kernel.org \
    --cc=dwmw2@infradead.org \
    --cc=fabio.estevam@nxp.com \
    --cc=han.xu@nxp.com \
    --cc=leoyang.li@nxp.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-spi@vger.kernel.org \
    --cc=marek.vasut@gmail.com \
    --cc=mark.rutland@arm.com \
    --cc=miquel.raynal@bootlin.com \
    --cc=prabhakar.kushwaha@nxp.com \
    --cc=richard@nod.at \
    --cc=robh+dt@kernel.org \
    --cc=shawnguo@kernel.org \
    --cc=yogeshnarayan.gaur@nxp.com \
    --subject='Re: [PATCH v5 2/9] arm64: dts: Reflect change of FSL QSPI driver and remove unused properties' \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

This is a public inbox, see mirroring instructions
on how to clone and mirror all data and code used for this inbox