* [PATCH] regulator: Fix trivial language typos
@ 2019-01-08 12:12 Krzysztof Kozlowski
0 siblings, 0 replies; only message in thread
From: Krzysztof Kozlowski @ 2019-01-08 12:12 UTC (permalink / raw)
To: Liam Girdwood, Mark Brown, Rob Herring, Mark Rutland,
Jiri Kosina, linux-kernel, devicetree
Cc: Krzysztof Kozlowski
Fix few trivial language typos in core and drivers.
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
---
Documentation/devicetree/bindings/regulator/pfuze100.txt | 2 +-
drivers/regulator/Kconfig | 8 ++++----
drivers/regulator/core.c | 16 ++++++++--------
drivers/regulator/lp8755.c | 4 ++--
drivers/regulator/of_regulator.c | 4 ++--
5 files changed, 17 insertions(+), 17 deletions(-)
diff --git a/Documentation/devicetree/bindings/regulator/pfuze100.txt b/Documentation/devicetree/bindings/regulator/pfuze100.txt
index f9be1acf891c..4d3b12b92cb3 100644
--- a/Documentation/devicetree/bindings/regulator/pfuze100.txt
+++ b/Documentation/devicetree/bindings/regulator/pfuze100.txt
@@ -8,7 +8,7 @@ Optional properties:
- fsl,pfuze-support-disable-sw: Boolean, if present disable all unused switch
regulators to save power consumption. Attention, ensure that all important
regulators (e.g. DDR ref, DDR supply) has set the "regulator-always-on"
- property. If not present, the switched regualtors are always on and can't be
+ property. If not present, the switched regulators are always on and can't be
disabled. This binding is a workaround to keep backward compatibility with
old dtb's which rely on the fact that the switched regulators are always on
and don't mark them explicit as "regulator-always-on".
diff --git a/drivers/regulator/Kconfig b/drivers/regulator/Kconfig
index ee60a222f5eb..7fc1f88e27e7 100644
--- a/drivers/regulator/Kconfig
+++ b/drivers/regulator/Kconfig
@@ -484,7 +484,7 @@ config REGULATOR_MAX8925
tristate "Maxim MAX8925 Power Management IC"
depends on MFD_MAX8925
help
- Say y here to support the voltage regulaltor of Maxim MAX8925 PMIC.
+ Say y here to support the voltage regulator of Maxim MAX8925 PMIC.
config REGULATOR_MAX8952
tristate "Maxim MAX8952 Power Management IC"
@@ -501,7 +501,7 @@ config REGULATOR_MAX8973
select REGMAP_I2C
help
The MAXIM MAX8973 high-efficiency. three phase, DC-DC step-down
- switching regulator delievers up to 9A of output current. Each
+ switching regulator delivers up to 9A of output current. Each
phase operates at a 2MHz fixed frequency with a 120 deg shift
from the adjacent phase, allowing the use of small magnetic component.
@@ -646,7 +646,7 @@ config REGULATOR_PCF50633
tristate "NXP PCF50633 regulator driver"
depends on MFD_PCF50633
help
- Say Y here to support the voltage regulators and convertors
+ Say Y here to support the voltage regulators and converters
on PCF50633
config REGULATOR_PFUZE100
@@ -924,7 +924,7 @@ config REGULATOR_TPS65132
select REGMAP_I2C
help
This driver supports TPS65132 single inductor - dual output
- power supply specifcally designed for display panels.
+ power supply specifically designed for display panels.
config REGULATOR_TPS65217
tristate "TI TPS65217 Power regulators"
diff --git a/drivers/regulator/core.c b/drivers/regulator/core.c
index b9d7b45c7295..3f9d81b6e763 100644
--- a/drivers/regulator/core.c
+++ b/drivers/regulator/core.c
@@ -326,7 +326,7 @@ static int regulator_lock_recursive(struct regulator_dev *rdev,
* @rdev: regulator source
* @ww_ctx: w/w mutex acquire context
*
- * Unlock all regulators related with rdev by coupling or suppling.
+ * Unlock all regulators related with rdev by coupling or supplying.
*/
static void regulator_unlock_dependent(struct regulator_dev *rdev,
struct ww_acquire_ctx *ww_ctx)
@@ -341,7 +341,7 @@ static void regulator_unlock_dependent(struct regulator_dev *rdev,
* @ww_ctx: w/w mutex acquire context
*
* This function as a wrapper on regulator_lock_recursive(), which locks
- * all regulators related with rdev by coupling or suppling.
+ * all regulators related with rdev by coupling or supplying.
*/
static void regulator_lock_dependent(struct regulator_dev *rdev,
struct ww_acquire_ctx *ww_ctx)
@@ -1003,7 +1003,7 @@ static int suspend_set_state(struct regulator_dev *rdev,
if (rstate == NULL)
return 0;
- /* If we have no suspend mode configration don't set anything;
+ /* If we have no suspend mode configuration don't set anything;
* only warn if the driver implements set_suspend_voltage or
* set_suspend_mode callback.
*/
@@ -1131,7 +1131,7 @@ static int machine_constraints_voltage(struct regulator_dev *rdev,
int current_uV = _regulator_get_voltage(rdev);
if (current_uV == -ENOTRECOVERABLE) {
- /* This regulator can't be read and must be initted */
+ /* This regulator can't be read and must be initialized */
rdev_info(rdev, "Setting %d-%duV\n",
rdev->constraints->min_uV,
rdev->constraints->max_uV);
@@ -1780,7 +1780,7 @@ static int regulator_resolve_supply(struct regulator_dev *rdev)
struct device *dev = rdev->dev.parent;
int ret;
- /* No supply to resovle? */
+ /* No supply to resolve? */
if (!rdev->supply_name)
return 0;
@@ -2409,7 +2409,7 @@ static int _regulator_do_enable(struct regulator_dev *rdev)
* timer wrapping.
* in case of multiple timer wrapping, either it can be
* detected by out-of-range remaining, or it cannot be
- * detected and we gets a panelty of
+ * detected and we get a penalty of
* _regulator_enable_delay().
*/
remaining = intended - start_jiffy;
@@ -2809,7 +2809,7 @@ static void regulator_disable_work(struct work_struct *work)
/**
* regulator_disable_deferred - disable regulator output with delay
* @regulator: regulator source
- * @ms: miliseconds until the regulator is disabled
+ * @ms: milliseconds until the regulator is disabled
*
* Execute regulator_disable() on the regulator after a delay. This
* is intended for use with devices that require some time to quiesce.
@@ -4943,7 +4943,7 @@ regulator_register(const struct regulator_desc *regulator_desc,
* device tree until we have handled it over to the core. If the
* config that was passed in to this function DOES NOT contain
* a descriptor, and the config after this call DOES contain
- * a descriptor, we definately got one from parsing the device
+ * a descriptor, we definitely got one from parsing the device
* tree.
*/
if (!cfg->ena_gpiod && config->ena_gpiod)
diff --git a/drivers/regulator/lp8755.c b/drivers/regulator/lp8755.c
index 244822bb63cd..6d229ad4ef3e 100644
--- a/drivers/regulator/lp8755.c
+++ b/drivers/regulator/lp8755.c
@@ -386,7 +386,7 @@ static irqreturn_t lp8755_irq_handler(int irq, void *data)
if (ret < 0)
goto err_i2c;
- /* send OCP event to all regualtor devices */
+ /* send OCP event to all regulator devices */
if ((flag1 & 0x01) && (pchip->irqmask & 0x01))
for (icnt = 0; icnt < LP8755_BUCK_MAX; icnt++)
if (pchip->rdev[icnt] != NULL)
@@ -394,7 +394,7 @@ static irqreturn_t lp8755_irq_handler(int irq, void *data)
LP8755_EVENT_OCP,
NULL);
- /* send OVP event to all regualtor devices */
+ /* send OVP event to all regulator devices */
if ((flag1 & 0x02) && (pchip->irqmask & 0x02))
for (icnt = 0; icnt < LP8755_BUCK_MAX; icnt++)
if (pchip->rdev[icnt] != NULL)
diff --git a/drivers/regulator/of_regulator.c b/drivers/regulator/of_regulator.c
index ffa5fc3724e4..7b6bf3536271 100644
--- a/drivers/regulator/of_regulator.c
+++ b/drivers/regulator/of_regulator.c
@@ -255,7 +255,7 @@ static void of_get_regulation_constraints(struct device_node *np,
* @desc: regulator description
*
* Populates regulator_init_data structure by extracting data from device
- * tree node, returns a pointer to the populated struture or NULL if memory
+ * tree node, returns a pointer to the populated structure or NULL if memory
* alloc fails.
*/
struct regulator_init_data *of_get_regulator_init_data(struct device *dev,
@@ -547,7 +547,7 @@ bool of_check_coupling_data(struct regulator_dev *rdev)
NULL);
if (c_n_phandles != n_phandles) {
- dev_err(&rdev->dev, "number of couped reg phandles mismatch\n");
+ dev_err(&rdev->dev, "number of coupled reg phandles mismatch\n");
ret = false;
goto clean;
}
--
2.7.4
^ permalink raw reply related [flat|nested] only message in thread
only message in thread, other threads:[~2019-01-08 12:12 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2019-01-08 12:12 [PATCH] regulator: Fix trivial language typos Krzysztof Kozlowski
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).