From: Can Guo <cang@codeaurora.org>
To: asutoshd@codeaurora.org, nguyenb@codeaurora.org,
hongwus@codeaurora.org, rnayak@codeaurora.org,
linux-scsi@vger.kernel.org, kernel-team@android.com,
saravanak@google.com, salyzyn@google.com, cang@codeaurora.org
Cc: Andy Gross <agross@kernel.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
Alim Akhtar <alim.akhtar@samsung.com>,
Avri Altman <avri.altman@wdc.com>,
"James E.J. Bottomley" <jejb@linux.ibm.com>,
"Martin K. Petersen" <martin.petersen@oracle.com>,
linux-arm-msm@vger.kernel.org (open list:ARM/QUALCOMM SUPPORT),
linux-kernel@vger.kernel.org (open list)
Subject: [PATCH v7 7/8] scsi: ufs-qcom: Delay specific time before gate ref clk
Date: Thu, 6 Feb 2020 00:33:26 -0800 [thread overview]
Message-ID: <1580978008-9327-8-git-send-email-cang@codeaurora.org> (raw)
In-Reply-To: <1580978008-9327-1-git-send-email-cang@codeaurora.org>
After enter hibern8, as UFS JEDEC ver 3.0 requires, a specific gating wait
time is required before disable the device reference clock. If it is not
specified, use the old delay.
Signed-off-by: Can Guo <cang@codeaurora.org>
Reviewed-by: Asutosh Das <asutoshd@codeaurora.org>
Reviewed-by: Hongwu Su <hongwus@codeaurora.org>
---
drivers/scsi/ufs/ufs-qcom.c | 22 +++++++++++++++++++---
1 file changed, 19 insertions(+), 3 deletions(-)
diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 85d7c17..39eefa4 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -833,6 +833,8 @@ static int ufs_qcom_bus_register(struct ufs_qcom_host *host)
static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
{
+ unsigned long gating_wait;
+
if (host->dev_ref_clk_ctrl_mmio &&
(enable ^ host->is_dev_ref_clk_enabled)) {
u32 temp = readl_relaxed(host->dev_ref_clk_ctrl_mmio);
@@ -845,11 +847,25 @@ static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
/*
* If we are here to disable this clock it might be immediately
* after entering into hibern8 in which case we need to make
- * sure that device ref_clk is active at least 1us after the
+ * sure that device ref_clk is active for specific time after
* hibern8 enter.
*/
- if (!enable)
- udelay(1);
+ if (!enable) {
+ gating_wait = host->hba->dev_info.clk_gating_wait_us;
+ if (!gating_wait) {
+ udelay(1);
+ } else {
+ /*
+ * bRefClkGatingWaitTime defines the minimum
+ * time for which the reference clock is
+ * required by device during transition from
+ * HS-MODE to LS-MODE or HIBERN8 state. Give it
+ * more time to be on the safe side.
+ */
+ gating_wait += 10;
+ usleep_range(gating_wait, gating_wait + 10);
+ }
+ }
writel_relaxed(temp, host->dev_ref_clk_ctrl_mmio);
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
next prev parent reply other threads:[~2020-02-06 8:34 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <1580978008-9327-1-git-send-email-cang@codeaurora.org>
2020-02-06 8:33 ` [PATCH v7 1/8] scsi: ufs: Flush exception event before suspend Can Guo
2020-02-06 8:33 ` [PATCH v7 2/8] scsi: ufs: set load before setting voltage in regulators Can Guo
2020-02-06 8:33 ` [PATCH v7 3/8] scsi: ufs: Remove the check before call setup clock notify vops Can Guo
2020-02-06 8:33 ` [PATCH v7 4/8] scsi: ufs-qcom: Adjust bus bandwidth voting and unvoting Can Guo
2020-02-06 8:33 ` [PATCH v7 5/8] scsi: ufs: Fix ufshcd_hold() caused scheduling while atomic Can Guo
2020-02-06 10:28 ` Avri Altman
2020-02-10 1:28 ` Can Guo
2020-02-10 1:59 ` Can Guo
2020-02-10 8:23 ` Avri Altman
2020-02-06 8:33 ` [PATCH v7 6/8] scsi: ufs: Add dev ref clock gating wait time support Can Guo
2020-02-06 8:33 ` Can Guo [this message]
2020-02-06 20:33 ` [PATCH v7 7/8] scsi: ufs-qcom: Delay specific time before gate ref clk Bjorn Andersson
2020-02-07 1:09 ` Can Guo
2020-02-07 2:10 ` Bjorn Andersson
2020-02-08 0:10 ` Can Guo
2020-02-06 8:33 ` [PATCH v7 8/8] scsi: ufs: Select INITIAL adapt for HS Gear4 Can Guo
2020-02-06 13:20 ` Avri Altman
2020-02-07 2:56 ` Can Guo
2020-02-07 5:10 ` Can Guo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1580978008-9327-8-git-send-email-cang@codeaurora.org \
--to=cang@codeaurora.org \
--cc=agross@kernel.org \
--cc=alim.akhtar@samsung.com \
--cc=asutoshd@codeaurora.org \
--cc=avri.altman@wdc.com \
--cc=bjorn.andersson@linaro.org \
--cc=hongwus@codeaurora.org \
--cc=jejb@linux.ibm.com \
--cc=kernel-team@android.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-scsi@vger.kernel.org \
--cc=martin.petersen@oracle.com \
--cc=nguyenb@codeaurora.org \
--cc=rnayak@codeaurora.org \
--cc=salyzyn@google.com \
--cc=saravanak@google.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).