[PATCH 6/7] drm/msm/dp: do not end dp link training until video is ready

[Kuogee Hsieh <khsieh@codeaurora.org>]

Initialize both pre-emphasis and voltage swing level to 0 before
start link training and do not end link training until video is
ready to reduce the period between end of link training and video
start to meet Link Layer CTS requirement.  This fixes Link Layer
CTS cases 4.3.2.1, 4.3.2.2, 4.3.2.3 and 4.3.2.4.

Signed-off-by: Kuogee Hsieh <khsieh@codeaurora.org>
---
 drivers/gpu/drm/msm/dp/dp_ctrl.c | 36 +++++++++++++++++++++---------------
 1 file changed, 21 insertions(+), 15 deletions(-)

diff --git a/drivers/gpu/drm/msm/dp/dp_ctrl.c b/drivers/gpu/drm/msm/dp/dp_ctrl.c
index 6f8443d..0cb01a9 100644
--- a/drivers/gpu/drm/msm/dp/dp_ctrl.c
+++ b/drivers/gpu/drm/msm/dp/dp_ctrl.c
@@ -1490,6 +1490,9 @@ static int dp_ctrl_link_maintenance(struct dp_ctrl_private *ctrl)
 
 	dp_ctrl_push_idle(&ctrl->dp_ctrl);
 
+	ctrl->link->phy_params.p_level = 0;
+	ctrl->link->phy_params.v_level = 0;
+
 	ctrl->dp_ctrl.pixel_rate = ctrl->panel->dp_mode.drm_mode.clock;
 
 	ret = dp_ctrl_setup_main_link(ctrl, cr_status, &training_step);
@@ -1692,6 +1695,9 @@ int dp_ctrl_on_link(struct dp_ctrl *dp_ctrl)
 		ctrl->link->link_params.rate,
 		ctrl->link->link_params.num_lanes, ctrl->dp_ctrl.pixel_rate);
 
+	ctrl->link->phy_params.p_level = 0;
+	ctrl->link->phy_params.v_level = 0;
+
 	rc = dp_ctrl_enable_mainlink_clocks(ctrl);
 	if (rc)
 		return rc;
@@ -1751,17 +1757,19 @@ int dp_ctrl_on_link(struct dp_ctrl *dp_ctrl)
 	if (ctrl->link->sink_request & DP_TEST_LINK_PHY_TEST_PATTERN)
 		return rc;
 
-	/* stop txing train pattern */
-	dp_ctrl_clear_training_pattern(ctrl);
+	if (rc == 0) {  /* link train successfully */
+		/*
+		 * do not stop train pattern here
+		 * stop link training at on_stream
+		 * to pass compliance test
+		 */
+	} else  {
+		/*
+		 * link training failed
+		 * end txing train pattern here
+		 */
+		dp_ctrl_clear_training_pattern(ctrl);
 
-	/*
-	 * keep transmitting idle pattern until video ready
-	 * to avoid main link from loss of sync
-	 */
-	if (rc == 0)  /* link train successfully */
-		dp_ctrl_push_idle(dp_ctrl);
-	else  {
-		/* link training failed */
 		dp_ctrl_deinitialize_mainlink(ctrl);
 		rc = -ECONNRESET;
 	}
@@ -1771,7 +1779,6 @@ int dp_ctrl_on_link(struct dp_ctrl *dp_ctrl)
 
 int dp_ctrl_on_stream(struct dp_ctrl *dp_ctrl)
 {
-	u32 rate = 0;
 	int ret = 0;
 	bool mainlink_ready = false;
 	struct dp_ctrl_private *ctrl;
@@ -1781,10 +1788,6 @@ int dp_ctrl_on_stream(struct dp_ctrl *dp_ctrl)
 
 	ctrl = container_of(dp_ctrl, struct dp_ctrl_private, dp_ctrl);
 
-	rate = ctrl->panel->link_info.rate;
-
-	ctrl->link->link_params.rate = rate;
-	ctrl->link->link_params.num_lanes = ctrl->panel->link_info.num_lanes;
 	ctrl->dp_ctrl.pixel_rate = ctrl->panel->dp_mode.drm_mode.clock;
 
 	DRM_DEBUG_DP("rate=%d, num_lanes=%d, pixel_rate=%d\n",
@@ -1799,6 +1802,9 @@ int dp_ctrl_on_stream(struct dp_ctrl *dp_ctrl)
 		}
 	}
 
+	/* stop txing train pattern to end link training */
+	dp_ctrl_clear_training_pattern(ctrl);
+
 	ret = dp_ctrl_enable_stream_clocks(ctrl);
 	if (ret) {
 		DRM_ERROR("Failed to start pixel clocks. ret=%d\n", ret);
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project