[PATCH v3 3/3] usb: dwc: host: add xhci_plat_priv quirk XHCI_SKIP_PHY_INIT

[Sandeep Maheswaram <quic_c_sanm@quicinc.com>]

Currently the phy init is done from dwc3 and also xhci which makes the
runtime_usage value 2 for the phy which causes issue during runtime
suspend. When we run the below command the runtime_status still shows
active.
echo auto > /sys/bus/platform/devices/88e3000.phy/power/control

dwc3 manages PHY by own DRD driver, so skip the management by
HCD core by setting this quirk.

Signed-off-by: Sandeep Maheswaram <quic_c_sanm@quicinc.com>
---
 drivers/usb/dwc3/host.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/drivers/usb/dwc3/host.c b/drivers/usb/dwc3/host.c
index eda8719..d4fcf06 100644
--- a/drivers/usb/dwc3/host.c
+++ b/drivers/usb/dwc3/host.c
@@ -13,6 +13,12 @@
 #include <linux/platform_device.h>
 
 #include "core.h"
+#include <linux/usb/xhci-plat.h>
+#include <linux/usb/xhci-quirks.h>
+
+static const struct xhci_plat_priv xhci_plat_dwc3_xhci = {
+	.quirks = XHCI_SKIP_PHY_INIT,
+};
 
 static void dwc3_host_fill_xhci_irq_res(struct dwc3 *dwc,
 					int irq, char *name)
@@ -122,6 +128,13 @@ int dwc3_host_init(struct dwc3 *dwc)
 		}
 	}
 
+	ret = platform_device_add_data(xhci, &xhci_plat_dwc3_xhci,
+			sizeof(xhci_plat_dwc3_xhci));
+	if (ret) {
+		dev_err(dwc->dev, "failed to add data to xHCI\n");
+		goto err;
+	}
+
 	ret = platform_device_add(xhci);
 	if (ret) {
 		dev_err(dwc->dev, "failed to register xHCI device\n");
-- 
2.7.4