* Re: IDE CD writer fails on 2.4.x
[not found] <KBEGKECBDMGLJNPFNJACKEEECBAA.glen@ausnet.com.au>
@ 2001-05-17 19:01 ` Frank van de Pol
0 siblings, 0 replies; 2+ messages in thread
From: Frank van de Pol @ 2001-05-17 19:01 UTC (permalink / raw)
To: Glen Morris; +Cc: fvdpol
sorry, not sure which of my CDR trouble you're refering to, but I still am
not succesful in burning cdroms from my linux box (2.4.4-ac5). The hardware
runs fine using older versions or MS windows though.
Regards,
Frank.
On Wed, May 16, 2001 at 12:46:38PM +1000, Glen Morris wrote:
> Frank
>
> I'm having exactly the same problem with my Ricoh CD-RW since moving from
> kernel 2.2.17 to 2.4.4.
>
> Did you find the solution?
>
> Kind regards,
>
> Glen
>
> Glen Morris
> PO Box 183
> Kurrajong 2758
> Tel. 02 4576 1404
> Fax. 02 4576 0005
--
+---- --- -- - - - -
|Frank van de Pol -o)
| FvdPol@home.nl /\\
| _\_v
|Linux - Why use Windows, since there is a door?
^ permalink raw reply [flat|nested] 2+ messages in thread
* IDE CD writer fails on 2.4.x
@ 2001-02-04 23:59 Frank van de Pol
0 siblings, 0 replies; 2+ messages in thread
From: Frank van de Pol @ 2001-02-04 23:59 UTC (permalink / raw)
To: linux-kernel
Though I was successfull using my cdwriter under the pre series and win98 it
fails using 2.4.x (i tested it with 2.4.0 and 2.4.2-pre1).
cd writer software in use:
Cdrecord 1.9 (i686-pc-linux-gnu) Copyright (C) 1995-2000 Jörg Schilling
caps according to hdparm:
/dev/hdd:
Model=PHILIPS CDD3610 CD-R/RW, FwRev=V:003.01,
SerialNo=4VO22985121772100210
Config={ Removeable DTR<=5Mbs DTR>10Mbs nonMagnetic }
RawCHS=0/0/0, TrkSize=0, SectSize=0, ECCbytes=0
BuffType=unknown, BuffSize=3900kB, MaxMultSect=0
(maybe): CurCHS=0/0/0, CurSects=0, LBA=yes, LBAsects=0
IORDY=yes, tPIO={min:208,w/IORDY:127}, tDMA={min:127,rec:127}
PIO modes: pio0 pio1 pio2 pio3
DMA modes: sdma0 sdma1 sdma2 mdma0 *mdma1
scsi1 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: E-IDE Model: CD-ROM 36X/AKU Rev: U21I
Type: CD-ROM ANSI SCSI revision: 02
Vendor: PHILIPS Model: CDD3610 CD-R/RW Rev: 3.01
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0
Detected scsi CD-ROM sr1 at scsi1, channel 0, id 1, lun 0
sr0: scsi3-mmc drive: 0x/36x cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
sr1: scsi3-mmc drive: 2x/6x writer cd/rw xa/form2 cdda tray
VFS: Disk change detected on device sr(11,1)
attempt to access beyond end of device
0b:01: rw=0, want=34, limit=2
isofs_read_super: bread failed, dev=0b:01, iso_blknum=16, block=16
Uniform CD-ROM driver unloaded
hdb: timeout waiting for DMA
ide_dmaproc: chipset supported ide_dma_timeout func only: 14
hdb: irq timeout: status=0x58 { DriveReady SeekComplete DataRequest }
scsi : aborting command due to timeout : pid 0, scsi1, channel 0, id 1, lun
0 Write (10) 00 00 00 04 5c 00 00 1f 00
hdd: timeout waiting for DMA
ide_dmaproc: chipset supported ide_dma_timeout func only: 14
hdd: irq timeout: status=0xd0 { Busy }
hdd: DMA disabled
hdd: ATAPI reset complete
hdd: irq timeout: status=0xd0 { Busy }
hdd: ATAPI reset complete
hdd: irq timeout: status=0xd0 { Busy }
hdd: status timeout: status=0xd0 { Busy }
hdd: drive not ready for command
hdd: ATAPI reset complete
scsi1 : channel 0 target 1 lun 0 request sense failed, performing reset.
SCSI bus is being reset for host 1 channel 0.
/proc/ide/ide1/hdd/settings:
name value min max mode
---- ----- --- --- ----
bios_cyl 0 0 1023 rw
bios_head 0 0 255 rw
bios_sect 0 0 63 rw
current_speed 33 0 69 rw
ide_scsi 0 0 1 rw
init_speed 33 0 69 rw
io_32bit 0 0 3 rw
keepsettings 0 0 1 rw
log 0 0 1 rw
nice1 1 0 1 rw
number 3 0 3 rw
pio_mode write-only 0 255 w
slow 0 0 1 rw
transform 1 0 3 rw
unmaskirq 0 0 1 rw
using_dma 0 0 1 rw
--
+---- --- -- - - - -
|Frank van de Pol -o)
| FvdPol@home.nl /\\
| _\_v
|Linux - Why use Windows, since there is a door?
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2001-05-17 19:02 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
[not found] <KBEGKECBDMGLJNPFNJACKEEECBAA.glen@ausnet.com.au>
2001-05-17 19:01 ` IDE CD writer fails on 2.4.x Frank van de Pol
2001-02-04 23:59 Frank van de Pol
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).