linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
* [PART1 V5 00/13] KVM: x86: Introduce SVM AVIC support
@ 2016-05-04 19:09 Suravee Suthikulpanit
  2016-05-04 19:09 ` [PART1 V5 01/13] KVM: x86: Misc LAPIC changes to expose helper functions Suravee Suthikulpanit
                   ` (13 more replies)
  0 siblings, 14 replies; 29+ messages in thread
From: Suravee Suthikulpanit @ 2016-05-04 19:09 UTC (permalink / raw)
  To: pbonzini, rkrcmar, joro, bp, gleb, alex.williamson
  Cc: kvm, linux-kernel, wei, sherry.hurwitz, Suravee Suthikulpanit

CHANGES FROM RFCv4:
==================
(https://lkml.org/lkml/2016/4/7/87)

  * Removing the RFC since I think this is getting ready.
  * Rebase to latest tip.git.
  * Rename vm_deinit to vm_destroy.
  * Replace svm_vcpu_avic_enabled() with kvm_vcpu_apicv_active().
  * Fix the cluster logical APIC ID calculation logic.
  * Misc clean up based on previous review comments.
  * (NEW) Rename kvm_lapic_get_reg to kvm_lapic_get_reg.
  * (NEW) Introduce kvm_x86_ops.apicv_post_state_restore hook.
  * (NEW) Re-factor the VMEXIT handling code and reuse
    it in the apicv_post_state_restore to implement support for
    vmsave/restore, which has been tested migrating:
      - from AVIC mode to non-AVIC mode 
      - from non-AVIC mode to AVIC mode
  * (NEW) Add support for the AVIC VMCB clean bit.

GITHUB
======
Latest git tree can be found at:
    http://github.com/ssuthiku/linux.git    avic_part1_v5

OVERVIEW
========
This patch set is the first of the two-part patch series to introduce 
the new AMD Advance Virtual Interrupt Controller (AVIC) support.

Basically, SVM AVIC hardware virtualizes local APIC registers of each
vCPU via the virtual APIC (vAPIC) backing page. This allows guest access
to certain APIC registers without the need to emulate the hardware behavior
in the hypervisor. More information about AVIC can be found in the
AMD64 Architecture Programmer’s Manual Volume 2 - System Programming.

  http://support.amd.com/TechDocs/24593.pdf

For SVM AVIC, we extend the existing kvm_amd driver to:
  * Check CPUID to detect AVIC support in the processor
  * Program new fields in VMCB to enable AVIC
  * Introduce new AVIC data structures and add code to manage them
  * Handle two new AVIC #VMEXITs
  * Add new interrupt intjection code using vAPIC backing page
    instead of the existing V_IRQ, V_INTR_PRIO, V_INTR_VECTOR,
    and V_IGN_TPR fields

Currently, this patch series does not enable AVIC by default.
Users can enable SVM AVIC by specifying avic=1 during insmod kvm-amd.

Later, in part 2, we will introduce the IOMMU AVIC support, which
provides speed up for PCI device pass-through use case by allowing
the IOMMU hardware to inject interrupt directly into the guest via
the vAPIC backing page.

PERFORMANCE RESULTS
===================
Currently, AVIC is supported in the AMD family 15h models 6Xh
(Carrizo) processors. Therefore, it is used to collect the 
perforamance data shown below.

Generaly, SVM AVIC alone (w/o IOMMU AVIC) should provide speedup for
IPI interrupt since hypervisor does not require VMEXIT to inject
these interrupts. Also, it should speed up the case when hypervisor
wants to inject an interrupt into a running guest by setting the
corresponded IRR bit in the vAPIC backing page and trigger
AVIC_DOORBELL MSR.

IPI PERFORMANCE
===============

* BENCHMARK 1: HACKBENCH
For IPI, I have collected some performance number on 2 and 4 CPU running
hackbech with the following detail:

  hackbench -p -l 100000
  Running in process mode with 10 groups using 40 file descriptors each (== 400 tasks)
  Each sender will pass 100000 messages of 100 bytes

                |    2 vcpus     |    4 vcpus 
 ------------------------------------------------
         Vanila |  273.76        |  190.21	
  AVIC disabled |  260.51 (~5%)  |  184.40 (~5%)
           AVIC |  248.53 (~10%) |  155.01 (~20%)

OVERALL PERFORMANCE
===================
Enabling AVIC should helps speeding up workloads, which generate
large amount of interrupts. However, it requires additional logics to
maintain AVIC-specific data structures during vCPU load/unload
due to vcpu scheduling.

The goal is to minimize the overhead of AVIC in most cases, so that
we can achieve equivalent or improvement in overall performance when
enabling AVIC.

* BENCHMARK 1: TAR DECOMPRESSION
This test measures the average running time (of 10 runs) of the following
tar decompression command with 1, 2, and 4 vcpus.

   tar xf linux-4.3.3.tar.xz

                |      4 vcpus 
 ---------------------------------
         Vanila |  10.26  
  AVIC disabled |  10.10 (~1.5%)
           AVIC |  10.07 (~1.8%)

Note: The unit of result below is in seconds (lower is better). 

* BENCHMARK 2: NETPERF w/ virtual network
This test creates a virtual network by setting up bridge and tap device
on the host and pass it into the VM as virtio-net-pci device w/ vhost. 
Then it sets up netserver in the host machine, and run netperf
in the VM with following option:

  netperf -H <netserver ip> -l 60 -t TCP_RR -D 2

                |    1 vcpu      
 ------------------------------------
         Vanila |  21623.887
  AVIC disabled |  21538.09 (~-.4%)
           AVIC |  21712.68 (~0.4%)

Note: The unit of result below is trans/sec (higher is better).

Preliminary result of both benchmarks show AVIC performance are slightly
better than the other two cases.

CURRENT UNTESTED USE-CASES
===========================
    - Nested VM

Any feedback and comments are very much appreciated.

Thank you,
Suravee

Radim Krčmář (1):
  KVM: split kvm_vcpu_wake_up from kvm_vcpu_kick

Suravee Suthikulpanit (12):
  KVM: x86: Misc LAPIC changes to expose helper functions
  KVM: x86: Rename kvm_apic_get_reg to kvm_lapic_get_reg
  KVM: x86: Introducing kvm_x86_ops VM init/destroy hooks
  KVM: x86: Introducing kvm_x86_ops VCPU blocking/unblocking hooks
  svm: Introduce new AVIC VMCB registers
  KVM: x86: Detect and Initialize AVIC support
  svm: Add interrupt injection via AVIC
  svm: Add VMEXIT handlers for AVIC
  KVM: x86: Introducing kvm_x86_ops.apicv_post_state_restore
  svm: Do not expose x2APIC when enable AVIC
  svm: Do not intercept CR8 when enable AVIC
  svm: Manage vcpu load/unload when enable AVIC

 arch/x86/include/asm/kvm_host.h |  26 +-
 arch/x86/include/asm/svm.h      |  12 +-
 arch/x86/include/uapi/asm/svm.h |   9 +-
 arch/x86/kvm/ioapic.c           |   2 +-
 arch/x86/kvm/lapic.c            | 187 +++++-------
 arch/x86/kvm/lapic.h            |  38 ++-
 arch/x86/kvm/svm.c              | 660 +++++++++++++++++++++++++++++++++++++++-
 arch/x86/kvm/trace.h            |  57 ++++
 arch/x86/kvm/x86.c              |   7 +
 include/linux/kvm_host.h        |   1 +
 virt/kvm/kvm_main.c             |  19 +-
 11 files changed, 891 insertions(+), 127 deletions(-)

-- 
1.9.1

^ permalink raw reply	[flat|nested] 29+ messages in thread

end of thread, other threads:[~2016-06-01 18:38 UTC | newest]

Thread overview: 29+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2016-05-04 19:09 [PART1 V5 00/13] KVM: x86: Introduce SVM AVIC support Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 01/13] KVM: x86: Misc LAPIC changes to expose helper functions Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 02/13] KVM: x86: Rename kvm_apic_get_reg to kvm_lapic_get_reg Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 03/13] KVM: x86: Introducing kvm_x86_ops VM init/destroy hooks Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 04/13] KVM: x86: Introducing kvm_x86_ops VCPU blocking/unblocking hooks Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 05/13] KVM: split kvm_vcpu_wake_up from kvm_vcpu_kick Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 06/13] svm: Introduce new AVIC VMCB registers Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 07/13] KVM: x86: Detect and Initialize AVIC support Suravee Suthikulpanit
2016-05-09 10:27   ` Borislav Petkov
2016-05-10  9:14   ` Borislav Petkov
2016-05-10 14:43     ` Paolo Bonzini
2016-05-10 16:24       ` Borislav Petkov
2016-05-10 17:00         ` Paolo Bonzini
2016-05-10 17:06           ` Borislav Petkov
2016-05-04 19:09 ` [PART1 V5 08/13] svm: Add interrupt injection via AVIC Suravee Suthikulpanit
2016-05-10  9:19   ` Borislav Petkov
2016-05-10 14:50     ` Paolo Bonzini
2016-06-01  4:02       ` Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 09/13] svm: Add VMEXIT handlers for AVIC Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 10/13] KVM: x86: Introducing kvm_x86_ops.apicv_post_state_restore Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 11/13] svm: Do not expose x2APIC when enable AVIC Suravee Suthikulpanit
2016-05-04 19:09 ` [PART1 V5 12/13] svm: Do not intercept CR8 " Suravee Suthikulpanit
2016-05-10 15:12   ` Paolo Bonzini
2016-05-04 19:09 ` [PART1 V5 13/13] svm: Manage vcpu load/unload " Suravee Suthikulpanit
2016-05-10 15:43   ` Paolo Bonzini
2016-05-17 12:09     ` Paolo Bonzini
2016-06-01 18:18       ` Suravee Suthikulpanit
2016-06-01 18:37         ` Paolo Bonzini
2016-05-10 14:57 ` [PART1 V5 00/13] KVM: x86: Introduce SVM AVIC support Paolo Bonzini

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).