[PATCH] rmem: support for dma_addr different from phys_addr

[Vladimir Kondratiev <vladimir.kondratiev@intel.com>]

On some systems, dma address differs from physical one due to
various reasons.

dma_init_coherent_memory is aware of it, it takes both
phys_addr_t and dma_addt_t arguments for memory block.
However, rmem_dma_device_init passes physical address for DMA one.

Fix this, using phys_to_dma(). This assumes the whole buffer has
same offset between physical and dma addresses.

Change-Id: Ic709312941ee4e1a37afb2ea25cbd759eabc009b
Signed-off-by: Vladimir Kondratiev <vladimir.kondratiev@intel.com>
---
 drivers/base/dma-coherent.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/base/dma-coherent.c b/drivers/base/dma-coherent.c
index 640a7e63c453..5371cb19c918 100644
--- a/drivers/base/dma-coherent.c
+++ b/drivers/base/dma-coherent.c
@@ -292,7 +292,8 @@ static int rmem_dma_device_init(struct reserved_mem *rmem, struct device *dev)
 	struct dma_coherent_mem *mem = rmem->priv;
 
 	if (!mem &&
-	    !dma_init_coherent_memory(rmem->base, rmem->base, rmem->size,
+	    !dma_init_coherent_memory(rmem->base, phys_to_dma(dev, rmem->base),
+				      rmem->size,
 				      DMA_MEMORY_MAP | DMA_MEMORY_EXCLUSIVE,
 				      &mem)) {
 		pr_err("Reserved memory: failed to init DMA memory pool at %pa, size %ld MiB\n",
-- 
2.11.0

---------------------------------------------------------------------
Intel Israel (74) Limited

This e-mail and any attachments may contain confidential material for
the sole use of the intended recipient(s). Any review or distribution
by others is strictly prohibited. If you are not the intended
recipient, please contact the sender and delete all copies.