From: Linus Walleij <linus.walleij@linaro.org>
To: Charles Keepax <ckeepax@opensource.cirrus.com>
Cc: Liam Girdwood <lgirdwood@gmail.com>,
Mark Brown <broonie@kernel.org>,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
"open list:GPIO SUBSYSTEM" <linux-gpio@vger.kernel.org>,
patches@opensource.cirrus.com, Lee Jones <lee.jones@linaro.org>
Subject: Re: [PATCH] ARM: s3c64xx: Tidy up handling of regulator GPIO lookups
Date: Mon, 14 May 2018 07:54:22 +0200 [thread overview]
Message-ID: <CACRpkdahS9VGvRKKedfgAqa8zpDj3ASGa3atwtF=BY794ne5tw@mail.gmail.com> (raw)
In-Reply-To: <20180419150119.5yhf3uupdolg3cnv@localhost.localdomain>
On Thu, Apr 19, 2018 at 5:01 PM, Charles Keepax
<ckeepax@opensource.cirrus.com> wrote:
> From: Charles Keepax <ckeepax@opensource.cirrus.com>
>
> Rather than unconditionally registering the GPIO lookup table only do so
> for devices that require it.
>
> Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
> ---
>
> Do you have any objections to the following?
>
> If we are lucky I might be able to find time to test these early
> next week. Well at least there is reasonable chance I can test
> the 5102 stuff when you resend, not sure I have a device to
> test the wm1277 but will have a look. Also I haven't run up
> Cragganmore in a little while so might depend a little on how
> much people have broken it since last I did :-)
I folded this in on top of my series, also adding the table entries
for wm5102 and wm5102 reva.
Sorry for the delay, I was sidetracked...
Yours,
Linus Walleij
next prev parent reply other threads:[~2018-05-14 5:54 UTC|newest]
Thread overview: 54+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-02-12 13:16 [PATCH 00/21] regulator: switch core to GPIO descriptors Linus Walleij
2018-02-12 13:16 ` [PATCH 01/21] regulator: core: Support passing an initialized GPIO enable descriptor Linus Walleij
2018-02-16 17:12 ` Applied "regulator: core: Support passing an initialized GPIO enable descriptor" to the regulator tree Mark Brown
2018-02-12 13:16 ` [PATCH 02/21] regulator: fixed: Convert to use GPIO descriptor only Linus Walleij
2018-02-12 15:13 ` Andy Shevchenko
2018-04-19 12:36 ` Linus Walleij
2018-02-12 13:16 ` [PATCH 03/21] regulator: gpio: Get enable GPIO using GPIO descriptor Linus Walleij
2018-05-29 14:59 ` Applied "regulator: gpio: Get enable GPIO using GPIO descriptor" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 04/21] regulator: da9055: Pass descriptor instead of GPIO number Linus Walleij
2018-02-12 14:59 ` Lee Jones
2018-02-16 17:12 ` Applied "regulator: da9055: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 05/21] regulator: arizona-ldo1: Look up a descriptor and pass to the core Linus Walleij
2018-02-13 11:06 ` Charles Keepax
2018-04-19 13:43 ` Linus Walleij
2018-04-19 15:02 ` Charles Keepax
2018-02-13 11:51 ` Charles Keepax
2018-02-12 13:17 ` [PATCH 06/21] regulator: da9211: Pass descriptors instead of GPIO numbers Linus Walleij
2018-02-16 17:12 ` Applied "regulator: da9211: Pass descriptors instead of GPIO numbers" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 07/21] regulator: max8973: Pass descriptor instead of GPIO number Linus Walleij
2018-05-24 19:14 ` Applied "regulator: max8973: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 08/21] regulator: max77686: Pass descriptor instead of GPIO number Linus Walleij
2018-02-12 13:37 ` Krzysztof Kozlowski
2018-02-12 13:17 ` [PATCH 09/21] regulator: lm363x: " Linus Walleij
2018-05-24 19:14 ` Applied "regulator: lm363x: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 10/21] regulator: lp8788-ldo: Pass descriptor instead of GPIO number Linus Walleij
2018-02-12 14:59 ` Lee Jones
2018-05-24 19:14 ` Applied "regulator: lp8788-ldo: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 11/21] regulator: max8952: Pass descriptor instead of GPIO number Linus Walleij
2018-05-24 19:14 ` Applied "regulator: max8952: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 12/21] regulator: pfuze100: Delete reference to ena_gpio Linus Walleij
2018-05-24 19:14 ` Applied "regulator: pfuze100: Delete reference to ena_gpio" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 13/21] regulator: s2mps11: Pass descriptor instead of GPIO number Linus Walleij
2018-05-17 16:41 ` Applied "regulator: s2mps11: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 14/21] regulator: s5m8767: Pass descriptor instead of GPIO number Linus Walleij
2018-02-12 14:58 ` Lee Jones
2018-05-24 19:13 ` Applied "regulator: s5m8767: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 15/21] regulator: tps65090: Pass descriptor instead of GPIO number Linus Walleij
2018-02-12 14:58 ` Lee Jones
2018-05-24 19:13 ` Applied "regulator: tps65090: Pass descriptor instead of GPIO number" to the regulator tree Mark Brown
2018-02-12 13:17 ` [PATCH 16/21] regulator: wm8994: Pass descriptor instead of GPIO number Linus Walleij
2018-02-12 14:58 ` Lee Jones
2018-02-13 11:11 ` Charles Keepax
2018-04-19 13:55 ` Linus Walleij
2018-04-19 14:05 ` Mark Brown
2018-04-19 15:01 ` [PATCH] ARM: s3c64xx: Tidy up handling of regulator GPIO lookups Charles Keepax
2018-05-14 5:54 ` Linus Walleij [this message]
2018-02-13 11:52 ` [PATCH 16/21] regulator: wm8994: Pass descriptor instead of GPIO number Charles Keepax
2018-02-12 13:17 ` [PATCH 17/21] regulator: core: Only support passing enable GPIO descriptors Linus Walleij
2018-02-12 13:17 ` [PATCH 18/21] regulator: fixed/gpio: Pull inversion/OD into gpiolib Linus Walleij
2018-02-17 9:59 ` Robert Jarzmik
2018-02-12 13:17 ` [PATCH 19/21] regulator: fixed/gpio: Update device tree bindings Linus Walleij
2018-02-19 2:41 ` Rob Herring
2018-02-12 13:17 ` [PATCH 20/21] regulator: gpio: Convert to fully use descriptors Linus Walleij
2018-02-12 13:17 ` [PATCH 21/21] regulator: gpio: Simplify probe path Linus Walleij
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to='CACRpkdahS9VGvRKKedfgAqa8zpDj3ASGa3atwtF=BY794ne5tw@mail.gmail.com' \
--to=linus.walleij@linaro.org \
--cc=broonie@kernel.org \
--cc=ckeepax@opensource.cirrus.com \
--cc=lee.jones@linaro.org \
--cc=lgirdwood@gmail.com \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=patches@opensource.cirrus.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).