Re: [PATCH v5 3/3] mfd: dln2: Send restart command if HW init fails

[Jack Andersen <jackoalan@gmail.com>]

I have mixed feelings about making this patch. The device appears to
lose its ability to send command responses when the driver
unexpectedly goes offline (probably overflowing an internal send
buffer).

The restart command is a send-only way to recover the device.
What concerns me is if there's another issue causing init to fail and
a restart doesn't fix, this will trigger an endless probe loop. I'm
not sure if there's a better way to discern this condition.

On 5 July 2017 at 11:12, Jack Andersen <jackoalan@gmail.com> wrote:
> There's an issue with reinitializing DLN2 hardware if ADC channel event
> configurations aren't reset before suspending the driver. A physical reconnect
> of the device solves the problem, but restarting the machine without a power
> cycle leaves the device state inconsistent.
>
> This patch transmits a restart command in the event of a failed init.
> To the kernel's perspective, this is the rough equivalent of a disconnect and
> reconnect, so another probe occurs shortly afterwards.
>
> Signed-off-by: Jack Andersen <jackoalan@gmail.com>
> ---
>  drivers/mfd/dln2.c | 11 ++++++++++-
>  1 file changed, 10 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/mfd/dln2.c b/drivers/mfd/dln2.c
> index a22ab8c..1eb0056 100644
> --- a/drivers/mfd/dln2.c
> +++ b/drivers/mfd/dln2.c
> @@ -40,6 +40,7 @@ struct dln2_response {
>  #define DLN2_GENERIC_CMD(cmd)          DLN2_CMD(cmd, DLN2_GENERIC_MODULE_ID)
>  #define CMD_GET_DEVICE_VER             DLN2_GENERIC_CMD(0x30)
>  #define CMD_GET_DEVICE_SN              DLN2_GENERIC_CMD(0x31)
> +#define CMD_RESTART                    DLN2_GENERIC_CMD(0x43)
>
>  #define DLN2_HW_ID                     0x200
>  #define DLN2_USB_TIMEOUT               200     /* in ms */
> @@ -531,6 +532,12 @@ int dln2_transfer(struct platform_device *pdev, u16 cmd,
>  }
>  EXPORT_SYMBOL(dln2_transfer);
>
> +static int dln2_restart(struct dln2_dev *dln2)
> +{
> +       return _dln2_transfer(dln2, DLN2_HANDLE_CTRL, CMD_RESTART,
> +                             NULL, 0, NULL, NULL);
> +}
> +
>  static int dln2_check_hw(struct dln2_dev *dln2)
>  {
>         int ret;
> @@ -782,7 +789,9 @@ static int dln2_probe(struct usb_interface *interface,
>
>         ret = dln2_hw_init(dln2);
>         if (ret < 0) {
> -               dev_err(dev, "failed to initialize hardware\n");
> +               dev_err(dev,
> +                       "failed to initialize hardware; attempting restart\n");
> +               dln2_restart(dln2);
>                 goto out_stop_rx;
>         }
>
> --
> 1.9.1
>