RE: [PATCH v7 RESEND 07/13] spi: imx: fix ERR009165

[Robin Gong <yibin.gong@nxp.com>]

On 2020/05/13 Sascha Hauer <s.hauer@pengutronix.de> wrote:
> This patch is the one bisecting will end up with when somebody uses an older
> SDMA firmware or the ROM scripts. It should have a better description what
> happens and what should be done about it.
Emm..That's true. Timeout will be caught in such case, hence, maybe we can fall back it to pio always.
> >
> > Signed-off-by: Robin Gong <yibin.gong@nxp.com>
> > Acked-by: Mark Brown <broonie@kernel.org>
> > ---
> >  drivers/spi/spi-imx.c | 16 ++++++++--------
> >  1 file changed, 8 insertions(+), 8 deletions(-)
> >
> > diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c index
> > f4f28a4..70df8e6 100644
> > --- a/drivers/spi/spi-imx.c
> > +++ b/drivers/spi/spi-imx.c
> > @@ -585,8 +585,8 @@ static int mx51_ecspi_prepare_transfer(struct
> spi_imx_data *spi_imx,
> >  	ctrl |= mx51_ecspi_clkdiv(spi_imx, t->speed_hz, &clk);
> >  	spi_imx->spi_bus_clk = clk;
> >
> > -	if (spi_imx->usedma)
> > -		ctrl |= MX51_ECSPI_CTRL_SMC;
> > +	/* ERR009165: work in XHC mode as PIO */
> > +	ctrl &= ~MX51_ECSPI_CTRL_SMC;
> >
> >  	writel(ctrl, spi_imx->base + MX51_ECSPI_CTRL);
> >
> > @@ -617,7 +617,7 @@ static void mx51_setup_wml(struct spi_imx_data
> *spi_imx)
> >  	 * and enable DMA request.
> >  	 */
> >  	writel(MX51_ECSPI_DMA_RX_WML(spi_imx->wml - 1) |
> > -		MX51_ECSPI_DMA_TX_WML(spi_imx->wml) |
> > +		MX51_ECSPI_DMA_TX_WML(0) |
> >  		MX51_ECSPI_DMA_RXT_WML(spi_imx->wml) |
> >  		MX51_ECSPI_DMA_TEDEN | MX51_ECSPI_DMA_RXDEN |
> >  		MX51_ECSPI_DMA_RXTDEN, spi_imx->base + MX51_ECSPI_DMA);
> @@ -1171,7
> > +1171,11 @@ static int spi_imx_dma_configure(struct spi_master *master)
> >  	tx.direction = DMA_MEM_TO_DEV;
> >  	tx.dst_addr = spi_imx->base_phys + MXC_CSPITXDATA;
> >  	tx.dst_addr_width = buswidth;
> > -	tx.dst_maxburst = spi_imx->wml;
> > +	/*
> > +	 * For ERR009165 with tx_wml = 0 could enlarge burst size to fifo size
> > +	 * to speed up fifo filling as possible.
> > +	 */
> > +	tx.dst_maxburst = spi_imx->devtype_data->fifo_size;
> >  	ret = dmaengine_slave_config(master->dma_tx, &tx);
> >  	if (ret) {
> >  		dev_err(spi_imx->dev, "TX dma configuration failed with %d\n",
> > ret); @@ -1265,10 +1269,6 @@ static int spi_imx_sdma_init(struct
> > device *dev, struct spi_imx_data *spi_imx,  {
> >  	int ret;
> >
> > -	/* use pio mode for i.mx6dl chip TKT238285 */
> > -	if (of_machine_is_compatible("fsl,imx6dl"))
> > -		return 0;
> > -
> >  	spi_imx->wml = spi_imx->devtype_data->fifo_size / 2;
> >
> >  	/* Prepare for TX DMA: */
> > --
> > 2.7.4
> >
> >
> 
> --
> Pengutronix e.K.                           |
> |
> Steuerwalder Str. 21                       |
> https://eur01.safelinks.protection.outlook.com/?url=http%3A%2F%2Fwww.pe
> ngutronix.de%2F&amp;data=02%7C01%7Cyibin.gong%40nxp.com%7C2f49309
> 819cc4c45418108d7f70e46fb%7C686ea1d3bc2b4c6fa92cd99c5c301635%7C0%
> 7C1%7C637249513003506970&amp;sdata=RoLVnDaCfG20i88OmmlpbMH6lZu
> qqW2CJv4VSSDkPcM%3D&amp;reserved=0  |
> 31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0
> |
> Amtsgericht Hildesheim, HRA 2686           | Fax:
> +49-5121-206917-5555 |