Re: [PATCH] fix typo in command value in drivers/net/phy/mdio-bitbang.

Re: [PATCH] fix typo in command value in drivers/net/phy/mdio-bitbang.

[Andrew Lunn]

On Fri, Mar 30, 2018 at 02:03:38PM +0200, Frans Meulenbroeks wrote:
> mdio-bitbang mentioned 10 for both read and write.
> However mdio read opcode is 10 and write opcode is 01
> Fixed comment.
> 
> Signed-off-by: Frans Meulenbroeks <fransmeulenbroeks@gmail.com>

Hi Frans

The correct place to send this patch is <netdev@vger.kernel.org> and
David Miller <davem@davemloft.net>. Please can you submit it again, to
these addresses.

In general, if you don't know where to send a patch,
scripts/get_maintainers.pl will tell you.

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew


> ---
>  drivers/net/phy/mdio-bitbang.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/net/phy/mdio-bitbang.c b/drivers/net/phy/mdio-bitbang.c
> index 61a543c..403b085 100644
> --- a/drivers/net/phy/mdio-bitbang.c
> +++ b/drivers/net/phy/mdio-bitbang.c
> @@ -113,7 +113,7 @@ static void mdiobb_cmd(struct mdiobb_ctrl *ctrl, int
> op, u8 phy, u8 reg)
>         for (i = 0; i < 32; i++)
>                 mdiobb_send_bit(ctrl, 1);
> 
> -       /* send the start bit (01) and the read opcode (10) or write (10).
> +       /* send the start bit (01) and the read opcode (10) or write (01).
>            Clause 45 operation uses 00 for the start and 11, 10 for
>            read/write */
>         mdiobb_send_bit(ctrl, 0);
> -- 
> 2.7.4