netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Sasha Levin <sashal@kernel.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Alain Michaud <alainm@chromium.org>,
	Marcel Holtmann <marcel@holtmann.org>,
	Sasha Levin <sashal@kernel.org>,
	linux-bluetooth@vger.kernel.org, netdev@vger.kernel.org
Subject: [PATCH AUTOSEL 4.14 16/37] Bluetooth: guard against controllers sending zero'd events
Date: Sat, 11 Apr 2020 19:13:05 -0400	[thread overview]
Message-ID: <20200411231327.26550-16-sashal@kernel.org> (raw)
In-Reply-To: <20200411231327.26550-1-sashal@kernel.org>

From: Alain Michaud <alainm@chromium.org>

[ Upstream commit 08bb4da90150e2a225f35e0f642cdc463958d696 ]

Some controllers have been observed to send zero'd events under some
conditions.  This change guards against this condition as well as adding
a trace to facilitate diagnosability of this condition.

Signed-off-by: Alain Michaud <alainm@chromium.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 net/bluetooth/hci_event.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/net/bluetooth/hci_event.c b/net/bluetooth/hci_event.c
index 363dc85bbc5c9..5049258d8c50d 100644
--- a/net/bluetooth/hci_event.c
+++ b/net/bluetooth/hci_event.c
@@ -5249,6 +5249,11 @@ void hci_event_packet(struct hci_dev *hdev, struct sk_buff *skb)
 	u8 status = 0, event = hdr->evt, req_evt = 0;
 	u16 opcode = HCI_OP_NOP;
 
+	if (!event) {
+		bt_dev_warn(hdev, "Received unexpected HCI Event 00000000");
+		goto done;
+	}
+
 	if (hdev->sent_cmd && bt_cb(hdev->sent_cmd)->hci.req_event == event) {
 		struct hci_command_hdr *cmd_hdr = (void *) hdev->sent_cmd->data;
 		opcode = __le16_to_cpu(cmd_hdr->opcode);
@@ -5460,6 +5465,7 @@ void hci_event_packet(struct hci_dev *hdev, struct sk_buff *skb)
 		req_complete_skb(hdev, status, opcode, orig_skb);
 	}
 
+done:
 	kfree_skb(orig_skb);
 	kfree_skb(skb);
 	hdev->stat.evt_rx++;
-- 
2.20.1


  parent reply	other threads:[~2020-04-11 23:20 UTC|newest]

Thread overview: 17+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-04-11 23:12 [PATCH AUTOSEL 4.14 01/37] net: wan: wanxl: use allow to pass CROSS_COMPILE_M68k for rebuilding firmware Sasha Levin
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 02/37] net: phy: probe PHY drivers synchronously Sasha Levin
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 06/37] net: phy: mscc: accept all RGMII species in vsc85xx_mac_if_set Sasha Levin
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 09/37] ath10k: use kzalloc to read for ath10k_sdio_hif_diag_read Sasha Levin
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 10/37] mwifiex: set needed_headroom, not hard_header_len Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 11/37] Bluetooth: L2CAP: handle l2cap config request during open state Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 13/37] net/mlx5e: Init ethtool steering for representors Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 14/37] Bluetooth: Fix calculation of SCO handle for packet processing Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 15/37] net: rmnet: add missing module alias Sasha Levin
2020-04-11 23:13 ` Sasha Levin [this message]
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 18/37] net: intel: e1000e: fix possible sleep-in-atomic-context bugs in e1000e_get_hw_semaphore() Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 19/37] net: dsa: bcm_sf2: Also configure Port 5 for 2Gb/sec on 7278 Sasha Levin
2020-04-12  1:15   ` Florian Fainelli
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 25/37] Bluetooth: RFCOMM: fix ODEBUG bug in rfcomm_dev_ioctl Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 26/37] ath10k: start recovery process when read int status fail for sdio Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 29/37] brcmfmac: Fix driver crash on USB control transfer timeout Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 37/37] svcrdma: Fix leak of transport addresses Sasha Levin

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200411231327.26550-16-sashal@kernel.org \
    --to=sashal@kernel.org \
    --cc=alainm@chromium.org \
    --cc=linux-bluetooth@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=marcel@holtmann.org \
    --cc=netdev@vger.kernel.org \
    --cc=stable@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).