From: Sasha Levin <sashal@kernel.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Vladimir Oltean <vladimir.oltean@nxp.com>,
Florian Fainelli <f.fainelli@gmail.com>,
"David S . Miller" <davem@davemloft.net>,
Sasha Levin <sashal@kernel.org>,
netdev@vger.kernel.org
Subject: [PATCH AUTOSEL 4.14 06/37] net: phy: mscc: accept all RGMII species in vsc85xx_mac_if_set
Date: Sat, 11 Apr 2020 19:12:55 -0400 [thread overview]
Message-ID: <20200411231327.26550-6-sashal@kernel.org> (raw)
In-Reply-To: <20200411231327.26550-1-sashal@kernel.org>
From: Vladimir Oltean <vladimir.oltean@nxp.com>
[ Upstream commit da206d65f2b293274f8082a26da4e43a1610da54 ]
The helper for configuring the pinout of the MII side of the PHY should
do so irrespective of whether RGMII delays are used or not. So accept
the ID, TXID and RXID variants as well, not just the no-delay RGMII
variant.
Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
drivers/net/phy/mscc.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/net/phy/mscc.c b/drivers/net/phy/mscc.c
index fe81741ab66a3..75b6cdd9d9eb6 100644
--- a/drivers/net/phy/mscc.c
+++ b/drivers/net/phy/mscc.c
@@ -470,6 +470,9 @@ static int vsc85xx_mac_if_set(struct phy_device *phydev,
reg_val = phy_read(phydev, MSCC_PHY_EXT_PHY_CNTL_1);
reg_val &= ~(MAC_IF_SELECTION_MASK);
switch (interface) {
+ case PHY_INTERFACE_MODE_RGMII_TXID:
+ case PHY_INTERFACE_MODE_RGMII_RXID:
+ case PHY_INTERFACE_MODE_RGMII_ID:
case PHY_INTERFACE_MODE_RGMII:
reg_val |= (MAC_IF_SELECTION_RGMII << MAC_IF_SELECTION_POS);
break;
--
2.20.1
next prev parent reply other threads:[~2020-04-11 23:13 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-04-11 23:12 [PATCH AUTOSEL 4.14 01/37] net: wan: wanxl: use allow to pass CROSS_COMPILE_M68k for rebuilding firmware Sasha Levin
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 02/37] net: phy: probe PHY drivers synchronously Sasha Levin
2020-04-11 23:12 ` Sasha Levin [this message]
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 09/37] ath10k: use kzalloc to read for ath10k_sdio_hif_diag_read Sasha Levin
2020-04-11 23:12 ` [PATCH AUTOSEL 4.14 10/37] mwifiex: set needed_headroom, not hard_header_len Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 11/37] Bluetooth: L2CAP: handle l2cap config request during open state Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 13/37] net/mlx5e: Init ethtool steering for representors Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 14/37] Bluetooth: Fix calculation of SCO handle for packet processing Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 15/37] net: rmnet: add missing module alias Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 16/37] Bluetooth: guard against controllers sending zero'd events Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 18/37] net: intel: e1000e: fix possible sleep-in-atomic-context bugs in e1000e_get_hw_semaphore() Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 19/37] net: dsa: bcm_sf2: Also configure Port 5 for 2Gb/sec on 7278 Sasha Levin
2020-04-12 1:15 ` Florian Fainelli
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 25/37] Bluetooth: RFCOMM: fix ODEBUG bug in rfcomm_dev_ioctl Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 26/37] ath10k: start recovery process when read int status fail for sdio Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 29/37] brcmfmac: Fix driver crash on USB control transfer timeout Sasha Levin
2020-04-11 23:13 ` [PATCH AUTOSEL 4.14 37/37] svcrdma: Fix leak of transport addresses Sasha Levin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200411231327.26550-6-sashal@kernel.org \
--to=sashal@kernel.org \
--cc=davem@davemloft.net \
--cc=f.fainelli@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=stable@vger.kernel.org \
--cc=vladimir.oltean@nxp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).