Re: [RFC PATCH net-next] bonding: add a vlan+srcmac tx hashing option

[Jarod Wilson <jarod@redhat.com>]

On Tue, Jan 12, 2021 at 01:39:10PM -0800, Jay Vosburgh wrote:
> Jarod Wilson <jarod@redhat.com> wrote:
> 
> >On Thu, Jan 07, 2021 at 07:03:40PM -0500, Jarod Wilson wrote:
> >> On Fri, Dec 18, 2020 at 04:18:59PM -0800, Jay Vosburgh wrote:
> >> > Jarod Wilson <jarod@redhat.com> wrote:
> >> > 
> >> > >This comes from an end-user request, where they're running multiple VMs on
> >> > >hosts with bonded interfaces connected to some interest switch topologies,
> >> > >where 802.3ad isn't an option. They're currently running a proprietary
> >> > >solution that effectively achieves load-balancing of VMs and bandwidth
> >> > >utilization improvements with a similar form of transmission algorithm.
> >> > >
> >> > >Basically, each VM has it's own vlan, so it always sends its traffic out
> >> > >the same interface, unless that interface fails. Traffic gets split
> >> > >between the interfaces, maintaining a consistent path, with failover still
> >> > >available if an interface goes down.
> >> > >
> >> > >This has been rudimetarily tested to provide similar results, suitable for
> >> > >them to use to move off their current proprietary solution.
> >> > >
> >> > >Still on the TODO list, if these even looks sane to begin with, is
> >> > >fleshing out Documentation/networking/bonding.rst.
> >> > 
> >> > 	I'm sure you're aware, but any final submission will also need
> >> > to include netlink and iproute2 support.
> >> 
> >> I believe everything for netlink support is already included, but I'll
> >> double-check that before submitting something for inclusion consideration.
> >
> >I'm not certain if what you actually meant was that I'd have to patch
> >iproute2 as well, which I've definitely stumbled onto today, but it's a
> >2-line patch, and everything seems to be working fine with it:
> 
> 	Yes, that's what I meant.
> 
> >$ sudo ip link set bond0 type bond xmit_hash_policy 5
> 
> 	Does the above work with the text label (presumably "vlansrc")
> as well as the number, and does "ip link add test type bond help" print
> the correct text for XMIT_HASH_POLICY?

All of the above looks correct to me, output below. Before submitting...
Could rename it from vlansrc to vlan+srcmac or some variation thereof if
it's desired. I tried to keep it relatively short, but it's perhaps a bit
less succinct like I have it now, and other modes include a +.

$ sudo modprobe bonding mode=2 max_bonds=1 xmit_hash_policy=0
$ sudo ip link set bond0 type bond xmit_hash_policy vlansrc
$ cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v4.18.0-272.el8.vstx.x86_64

Bonding Mode: load balancing (xor)
Transmit Hash Policy: vlansrc (5)
MII Status: down
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Peer Notification Delay (ms): 0

$ sudo ip link add test type bond help
Usage: ... bond [ mode BONDMODE ] [ active_slave SLAVE_DEV ]
                [ clear_active_slave ] [ miimon MIIMON ]
                [ updelay UPDELAY ] [ downdelay DOWNDELAY ]
                [ peer_notify_delay DELAY ]
                [ use_carrier USE_CARRIER ]
                [ arp_interval ARP_INTERVAL ]
                [ arp_validate ARP_VALIDATE ]
                [ arp_all_targets ARP_ALL_TARGETS ]
                [ arp_ip_target [ ARP_IP_TARGET, ... ] ]
                [ primary SLAVE_DEV ]
                [ primary_reselect PRIMARY_RESELECT ]
                [ fail_over_mac FAIL_OVER_MAC ]
                [ xmit_hash_policy XMIT_HASH_POLICY ]
                [ resend_igmp RESEND_IGMP ]
                [ num_grat_arp|num_unsol_na NUM_GRAT_ARP|NUM_UNSOL_NA ]
                [ all_slaves_active ALL_SLAVES_ACTIVE ]
                [ min_links MIN_LINKS ]
                [ lp_interval LP_INTERVAL ]
                [ packets_per_slave PACKETS_PER_SLAVE ]
                [ tlb_dynamic_lb TLB_DYNAMIC_LB ]
                [ lacp_rate LACP_RATE ]
                [ ad_select AD_SELECT ]
                [ ad_user_port_key PORTKEY ]
                [ ad_actor_sys_prio SYSPRIO ]
                [ ad_actor_system LLADDR ]

BONDMODE := balance-rr|active-backup|balance-xor|broadcast|802.3ad|balance-tlb|balance-alb
ARP_VALIDATE := none|active|backup|all
ARP_ALL_TARGETS := any|all
PRIMARY_RESELECT := always|better|failure
FAIL_OVER_MAC := none|active|follow
XMIT_HASH_POLICY := layer2|layer2+3|layer3+4|encap2+3|encap3+4|vlansrc
LACP_RATE := slow|fast
AD_SELECT := stable|bandwidth|count


-- 
Jarod Wilson
jarod@redhat.com