[PATCH 3/6] drm/i915/guc: Do not wait for firmware load atomically

[Tvrtko Ursulin <tvrtko.ursulin@linux.intel.com>]

From: Tvrtko Ursulin <tvrtko.ursulin@intel.com>

It does not look like this code needs to wait atomically?

Higher in the call chain it calls the GEM API and I do
not see that the section is under any spin locks or such.

Signed-off-by: Tvrtko Ursulin <tvrtko.ursulin@intel.com>
Cc: Alex Dai <yu.dai@intel.com>
---
 drivers/gpu/drm/i915/intel_guc_loader.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_guc_loader.c b/drivers/gpu/drm/i915/intel_guc_loader.c
index 3accd914490f..82a3c03fbc0e 100644
--- a/drivers/gpu/drm/i915/intel_guc_loader.c
+++ b/drivers/gpu/drm/i915/intel_guc_loader.c
@@ -199,7 +199,7 @@ static void set_guc_init_params(struct drm_i915_private *dev_priv)
  * the value matches either of two values representing completion
  * of the GuC boot process.
  *
- * This is used for polling the GuC status in a wait_for_atomic()
+ * This is used for polling the GuC status in a wait_for()
  * loop below.
  */
 static inline bool guc_ucode_response(struct drm_i915_private *dev_priv,
@@ -259,14 +259,14 @@ static int guc_ucode_xfer_dma(struct drm_i915_private *dev_priv)
 	I915_WRITE(DMA_CTRL, _MASKED_BIT_ENABLE(UOS_MOVE | START_DMA));
 
 	/*
-	 * Spin-wait for the DMA to complete & the GuC to start up.
+	 * Wait for the DMA to complete & the GuC to start up.
 	 * NB: Docs recommend not using the interrupt for completion.
 	 * Measurements indicate this should take no more than 20ms, so a
 	 * timeout here indicates that the GuC has failed and is unusable.
 	 * (Higher levels of the driver will attempt to fall back to
 	 * execlist mode if this happens.)
 	 */
-	ret = wait_for_atomic(guc_ucode_response(dev_priv, &status), 100);
+	ret = wait_for(guc_ucode_response(dev_priv, &status), 100);
 
 	DRM_DEBUG_DRIVER("DMA status 0x%x, GuC status 0x%x\n",
 			I915_READ(DMA_CTRL), status);
-- 
1.9.1

_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx