[Intel-gfx] [v9 12/12] drm/i915/display: [NOT FOR MERGE] Reduce blanking to support 4k60@10bpp for LSPCON

[Uma Shankar <uma.shankar@intel.com>]

Blanking needs to be reduced to incorporate DP and HDMI timing/link
bandwidth limitations for CEA modes (4k@60 at 10 bpp). DP can drive
17.28Gbs while 4k modes (VIC97 etc) at 10 bpp required 17.8 Gbps.
This will cause mode to blank out. Reduced Htotal by shortening the
back porch and front porch within permissible limits.

Note: This is for reference for userspace, not to be merged in kernel.

v2: This is marked as Not for merge and the responsibilty to program
these custom timings will be on userspace. This patch is just for
reference purposes. This is based on Ville's recommendation.

v3: updated commit message.

Signed-off-by: Uma Shankar <uma.shankar@intel.com>
---
 drivers/gpu/drm/i915/display/intel_dp.c | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/drivers/gpu/drm/i915/display/intel_dp.c b/drivers/gpu/drm/i915/display/intel_dp.c
index 79a49d1cbb21..1ad4c08f850b 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.c
+++ b/drivers/gpu/drm/i915/display/intel_dp.c
@@ -709,8 +709,10 @@ intel_dp_mode_valid(struct drm_connector *connector,
 {
 	struct intel_dp *intel_dp = intel_attached_dp(to_intel_connector(connector));
 	struct intel_connector *intel_connector = to_intel_connector(connector);
+	struct intel_encoder *intel_encoder = intel_attached_encoder(intel_connector);
 	struct drm_display_mode *fixed_mode = intel_connector->panel.fixed_mode;
 	struct drm_i915_private *dev_priv = to_i915(connector->dev);
+	struct intel_lspcon *lspcon = enc_to_intel_lspcon(intel_encoder);
 	int target_clock = mode->clock;
 	int max_rate, mode_rate, max_lanes, max_link_clock;
 	int max_dotclk = dev_priv->max_dotclk_freq;
@@ -731,6 +733,21 @@ intel_dp_mode_valid(struct drm_connector *connector,
 		target_clock = fixed_mode->clock;
 	}
 
+	/*
+	 * Reducing Blanking to incorporate DP and HDMI timing/link bandwidth
+	 * limitations for CEA modes (4k@60 at 10 bpp). DP can drive 17.28Gbs
+	 * while 4k modes (VIC97 etc) at 10 bpp required 17.8 Gbps. This will
+	 * cause mode to blank out. Reduced Htotal by shortening the back porch
+	 * and front porch within permissible limits.
+	 */
+	if (lspcon->active && lspcon->hdr_supported &&
+	    mode->clock > 570000) {
+		mode->clock = 570000;
+		mode->htotal -= 180;
+		mode->hsync_start -= 72;
+		mode->hsync_end -= 72;
+	}
+
 	max_link_clock = intel_dp_max_link_rate(intel_dp);
 	max_lanes = intel_dp_max_lane_count(intel_dp);
 
-- 
2.26.2

_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx