[PATCH 14/14] ARM: dts: qcom: apq8064: Drop redundant /smd node

[Stephan Gerhold <stephan@gerhold.net>]

The "smd-edge"s for remote processors are typically specified below the
remoteproc nodes. For some reason apq8064 also has them all listed in a
top-level /smd node, disabled by default. None of the boards enable them.

Right now apq8064 only has support for WCNSS/riva, but there the
smd-edge is already defined with the same interrupt etc below the
riva-pil node.

Drop these redundant definitions since the /smd top-level node is now
deprecated.

Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
---
 arch/arm/boot/dts/qcom-apq8064.dtsi | 40 -------------------------------------
 1 file changed, 40 deletions(-)

diff --git a/arch/arm/boot/dts/qcom-apq8064.dtsi b/arch/arm/boot/dts/qcom-apq8064.dtsi
index d2289205ff81..e0adf237fc5c 100644
--- a/arch/arm/boot/dts/qcom-apq8064.dtsi
+++ b/arch/arm/boot/dts/qcom-apq8064.dtsi
@@ -226,46 +226,6 @@ smem {
 		hwlocks = <&sfpb_mutex 3>;
 	};
 
-	smd {
-		compatible = "qcom,smd";
-
-		modem-edge {
-			interrupts = <0 37 IRQ_TYPE_EDGE_RISING>;
-
-			qcom,ipc = <&l2cc 8 3>;
-			qcom,smd-edge = <0>;
-
-			status = "disabled";
-		};
-
-		q6-edge {
-			interrupts = <0 90 IRQ_TYPE_EDGE_RISING>;
-
-			qcom,ipc = <&l2cc 8 15>;
-			qcom,smd-edge = <1>;
-
-			status = "disabled";
-		};
-
-		dsps-edge {
-			interrupts = <0 138 IRQ_TYPE_EDGE_RISING>;
-
-			qcom,ipc = <&sps_sic_non_secure 0x4080 0>;
-			qcom,smd-edge = <3>;
-
-			status = "disabled";
-		};
-
-		riva-edge {
-			interrupts = <0 198 IRQ_TYPE_EDGE_RISING>;
-
-			qcom,ipc = <&l2cc 8 25>;
-			qcom,smd-edge = <6>;
-
-			status = "disabled";
-		};
-	};
-
 	smsm {
 		compatible = "qcom,smsm";
 

-- 
2.40.1