* Looking for very old Katana 752i boot code.
@ 2022-08-30 6:22 Steven J. Hill
0 siblings, 0 replies; only message in thread
From: Steven J. Hill @ 2022-08-30 6:22 UTC (permalink / raw)
To: u-boot
Recently got a hold of a Katana 752i board. I was able to dump the boot
memory and it shows up as:
PPCBoot 1.2.0 (May 30 2006 - 12:54:57)1.5s
In the Katana 752i user manual however, it shows console output as:
PPCBoot 1.2.0 (Oct 31 2007 - 12:52:52)1.7s
CPU: 750GX v1.2 @ 900 MHz
Board: Katana752i
BusHz: 200000000
I2C: ready
DRAM: 512MB DDR SDRAM in slot 0 VM485L6523C-CC Early setup ECC
(Clearing..)
512 MB Reserving 32MB for EDNR at 0x1e000000
FLASH: [512kB@f8000000] [32MB@e8000000] [32MB@ea000000] 64.5 MB
cPCI: Enabled Remap Addr: 0x80000000 Window: 0x1000000
PCI: Bus Host
Waiting For EREADY ('q' to exit w/o enum).
[...]
The board is running a PPCBoot image that is 1.5 years behind what the
manual has. *sigh* There are no fault lights and there are link lights for
the Ethernet ports, but no serial console output. My BDI2000 shows it stuck
in a loop waiting for something. In the user guide, Emerson says the code
is GPL, but none of their Internet domains work anymore. Any chance someone
has a copy of the PPCBoot that ran on their hardware? Older versions of the
Linux kernel supported this board. I have been going through U-Boot git,
but am having no success in finding code. Any help appreciated. Thanks.
-Steve
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2022-08-30 6:22 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2022-08-30 6:22 Looking for very old Katana 752i boot code Steven J. Hill
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).