WireGuard Multiple Tunnels/Interfaces Windows

WireGuard Multiple Tunnels/Interfaces Windows

[Matthew]

[-- Attachment #1.1: Type: text/plain, Size: 926 bytes --]

Hi There,

I need the ability to create multiple tunnels/interfaces. If I try to 
start another tunnel the current tunnel disconnects. The reason I need 
separate tunnels is the devices I used on my gateways are fixed port 
numbers. I can't do port forwarding since the programming software of 
the devices doesn't support changing ports (It's fixed at 102) so my 
plan is to use NETMAP on the gateways todo 1:1 NAT and map the entire 
network. I would use Linux, but my software won't run on Linux. If I was 
to have separate tunnels I could just map the whole /24 network and gain 
full access to any device on the gateway local network. Here is a 
diagram showing what I need to achieve.

Thanks,

Matthew

-- 

*Matthew Reed*

Director | Electrician and Automation Engineer
*MR Electrical and Automation*
Mobile: 021 585358
Email: matthew@mrea.co.nz <mailto:matthew@mrea.co.nz>
Website: mrea.co.nz <http://www.mrea.co.nz>

[-- Attachment #1.2.1: Type: text/html, Size: 3941 bytes --]

[-- Attachment #1.2.2: logo 400x150.png --]
[-- Type: image/png, Size: 13392 bytes --]

[-- Attachment #2: SCADA VPN PLC Network.png --]
[-- Type: image/png, Size: 152070 bytes --]

[-- Attachment #3: Type: text/plain, Size: 148 bytes --]

_______________________________________________
WireGuard mailing list
WireGuard@lists.zx2c4.com
https://lists.zx2c4.com/mailman/listinfo/wireguard