Re: [PATCH v2] x86/mm/pat: Fix BUG_ON in mmap_mem on QEMU/i386

* [PATCH v2] x86/mm/pat: Fix BUG_ON in mmap_mem on QEMU/i386
@ 2016-04-11 19:36 Toshi Kani
  0 siblings, 0 replies; 3+ messages in thread
From: Toshi Kani @ 2016-04-11 19:36 UTC (permalink / raw)
  To: mingo, bp, hpa, tglx
  Cc: Toshi Kani, ying.huang, x86, linux-kernel, David Vrabel, xen-devel

The following BUG_ON error was reported on QEMU/i386:

  kernel BUG at arch/x86/mm/physaddr.c:79!
  Call Trace:
  phys_mem_access_prot_allowed
  mmap_mem
  ? mmap_region
  mmap_region
  do_mmap
  vm_mmap_pgoff
  SyS_mmap_pgoff
  do_int80_syscall_32
  entry_INT80_32

after commit edfe63ec97ed ("x86/mtrr: Fix Xorg crashes in
Qemu sessions").

PAT is now set to disabled state when MTRRs are disabled.
Thus, reactivating the __pa(high_memory) check in
phys_mem_access_prot_allowed().

When CONFIG_DEBUG_VIRTUAL is set, __pa() calls __phys_addr(),
which in turn calls slow_virt_to_phys() for 'high_memory'.
Because 'high_memory' is set to (the max direct mapped virt
addr + 1), it is not a valid virtual address.  Hence,
slow_virt_to_phys() returns 0 and hit the BUG_ON.  Using
__pa_nodebug() instead of __pa() will fix this BUG_ON.

However, this code block, originally written for Pentiums and
earlier, is no longer adequate since a 32-bit Xen guest has
MTRRs disabled and supports ZONE_HIGHMEM.  In this setup,
this code sets UC attribute for accessing RAM in high memory
range.

Delete this code block as it has been unused for a long time.

Reported-by: kernel test robot <ying.huang@linux.intel.com>
Link: https://lkml.org/lkml/2016/4/1/608
Signed-off-by: Toshi Kani <toshi.kani@hpe.com>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: Ingo Molnar <mingo@kernel.org>
Cc: H. Peter Anvin <hpa@zytor.com>
Cc: Borislav Petkov <bp@suse.de>
Cc: David Vrabel <david.vrabel@citrix.com>
---
This patch is based on -tip.
v2: Change to remove the code block.
---
 arch/x86/mm/pat.c |   19 -------------------
 1 file changed, 19 deletions(-)

diff --git a/arch/x86/mm/pat.c b/arch/x86/mm/pat.c
index c4c3ddc..fb0604f 100644
--- a/arch/x86/mm/pat.c
+++ b/arch/x86/mm/pat.c
@@ -778,25 +778,6 @@ int phys_mem_access_prot_allowed(struct file *file, unsigned long pfn,
 	if (file->f_flags & O_DSYNC)
 		pcm = _PAGE_CACHE_MODE_UC_MINUS;
 
-#ifdef CONFIG_X86_32
-	/*
-	 * On the PPro and successors, the MTRRs are used to set
-	 * memory types for physical addresses outside main memory,
-	 * so blindly setting UC or PWT on those pages is wrong.
-	 * For Pentiums and earlier, the surround logic should disable
-	 * caching for the high addresses through the KEN pin, but
-	 * we maintain the tradition of paranoia in this code.
-	 */
-	if (!pat_enabled() &&
-	    !(boot_cpu_has(X86_FEATURE_MTRR) ||
-	      boot_cpu_has(X86_FEATURE_K6_MTRR) ||
-	      boot_cpu_has(X86_FEATURE_CYRIX_ARR) ||
-	      boot_cpu_has(X86_FEATURE_CENTAUR_MCR)) &&
-	    (pfn << PAGE_SHIFT) >= __pa(high_memory)) {
-		pcm = _PAGE_CACHE_MODE_UC;
-	}
-#endif
-
 	*vma_prot = __pgprot((pgprot_val(*vma_prot) & ~_PAGE_CACHE_MASK) |
 			     cachemode2protval(pcm));
 	return 1;

_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xen.org
http://lists.xen.org/xen-devel

^ permalink raw reply related	[flat|nested] 3+ messages in thread