Re: [PATCH 1/6] ARM: OMAP2+: Remove board-4430sdp.c

[Russell King - ARM Linux <linux@arm.linux.org.uk>]

On Fri, May 17, 2013 at 12:17:51PM -0700, Tony Lindgren wrote:
> We can now boot with device tree. If you don't want to update u-boot,
> you can boot with appended DTB with the following instructions:
> 
> 1. Make sure you have the appended DTB support in .config
> 
>    CONFIG_ARM_APPENDED_DTB=y
>    CONFIG_ARM_ATAG_DTB_COMPAT=y
>    CONFIG_ARM_ATAG_DTB_COMPAT_CMDLINE_EXTEND=y
> 
> 2. Build the zImage
> 
>    $ ARCH=arm CROSS_COMPILE=... make zImage
> 
> 3. Build the device tree blobs
> 
>    $ ARCH=arm CROSS_COMPILE=... make dtbs
> 
> 4. Append the dtb to zImage
> 
>    $ cat arch/arm/boot/zImage arch/arm/boot/dts/omap4-sdp.dtb > /tmp/appended
> 
> 5. Use mkimage to produce the appended device tree uImage
> 
>    $ mkimage -A arm -O linux -T kernel -C none -a 0x80008000 -e 0x80008000 \
>      -n "Linux" -d /tmp/appended /tmp/uImage
> 
> Signed-off-by: Tony Lindgren <tony@atomide.com>

Okay, I'm removing the 4430SDP from the boot test system once this goes
in, because this will mean rewriting the build system to cope with this
stuff.