[PATCH 09/14] net: axienet: Add mii-tool support

[Andre Przywara <andre.przywara@arm.com>]

mii-tool is useful for debugging, and all it requires to work is to wire
up the ioctl ops function pointer.
Add this to the axienet driver to enable mii-tool.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
---
 drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
index 7a747345e98e..64f799f3d248 100644
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
@@ -1152,6 +1152,16 @@ static void axienet_poll_controller(struct net_device *ndev)
 }
 #endif
 
+static int axienet_ioctl(struct net_device *dev, struct ifreq *rq, int cmd)
+{
+	struct axienet_local *lp = netdev_priv(dev);
+
+	if (!netif_running(dev))
+		return -EINVAL;
+
+	return phylink_mii_ioctl(lp->phylink, rq, cmd);
+}
+
 static const struct net_device_ops axienet_netdev_ops = {
 	.ndo_open = axienet_open,
 	.ndo_stop = axienet_stop,
@@ -1159,6 +1169,7 @@ static const struct net_device_ops axienet_netdev_ops = {
 	.ndo_change_mtu	= axienet_change_mtu,
 	.ndo_set_mac_address = netdev_set_mac_address,
 	.ndo_validate_addr = eth_validate_addr,
+	.ndo_do_ioctl = axienet_ioctl,
 	.ndo_set_rx_mode = axienet_set_multicast_list,
 #ifdef CONFIG_NET_POLL_CONTROLLER
 	.ndo_poll_controller = axienet_poll_controller,
-- 
2.17.1