From: Pratyush Yadav <p.yadav@ti.com>
To: u-boot@lists.denx.de
Subject: [PATCH v9 09/28] mtd: spi-nor-core: Fix address width on flash chips > 16MB
Date: Wed, 5 May 2021 15:11:19 +0530 [thread overview]
Message-ID: <20210505094138.30805-10-p.yadav@ti.com> (raw)
In-Reply-To: <20210505094138.30805-1-p.yadav@ti.com>
If a flash chip has more than 16MB capacity but its BFPT reports
BFPT_DWORD1_ADDRESS_BYTES_3_OR_4, the spi-nor framework defaults to 3.
The check in spi_nor_scan() doesn't catch it because addr_width did get
set. This fixes that check.
Ported from Kernel commit 324f78dfb442b82365548b657ec4e6974c677502.
Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
---
drivers/mtd/spi/spi-nor-core.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/drivers/mtd/spi/spi-nor-core.c b/drivers/mtd/spi/spi-nor-core.c
index a6625535a7..db918fc06f 100644
--- a/drivers/mtd/spi/spi-nor-core.c
+++ b/drivers/mtd/spi/spi-nor-core.c
@@ -2602,7 +2602,11 @@ int spi_nor_scan(struct spi_nor *nor)
/* already configured from SFDP */
} else if (info->addr_width) {
nor->addr_width = info->addr_width;
- } else if (mtd->size > SZ_16M) {
+ } else {
+ nor->addr_width = 3;
+ }
+
+ if (nor->addr_width == 3 && mtd->size > SZ_16M) {
#ifndef CONFIG_SPI_FLASH_BAR
/* enable 4-byte addressing if the device exceeds 16MiB */
nor->addr_width = 4;
@@ -2616,8 +2620,6 @@ int spi_nor_scan(struct spi_nor *nor)
if (ret < 0)
return ret;
#endif
- } else {
- nor->addr_width = 3;
}
if (nor->addr_width > SPI_NOR_MAX_ADDR_WIDTH) {
--
2.30.0
next prev parent reply other threads:[~2021-05-05 9:41 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-05-05 9:41 [PATCH v9 00/28] mtd: spi-nor-core: add xSPI Octal DTR support Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 01/28] spi: spi-mem: allow specifying whether an op is DTR or not Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 02/28] spi: spi-mem: allow specifying a command's extension Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 03/28] spi: spi-mem: export spi_mem_default_supports_op() Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 04/28] spi: spi-mem: add spi_mem_dtr_supports_op() Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 05/28] spi: cadence-qspi: Do not calibrate when device tree sets read delay Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 06/28] spi: cadence-qspi: Add a small delay before indirect writes Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 07/28] spi: cadence-qspi: Add support for octal DTR flashes Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 08/28] arm: mvebu: x530: Use tiny SPI NOR Pratyush Yadav
2021-05-05 9:41 ` Pratyush Yadav [this message]
2021-05-05 9:41 ` [PATCH v9 10/28] mtd: spi-nor-core: Add a ->setup() hook Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 11/28] mtd: spi-nor-core: Move SFDP related declarations to top Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 12/28] mtd: spi-nor-core: Introduce flash-specific fixup hooks Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 13/28] mtd: spi-nor-core: Rework hwcaps selection Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 14/28] mtd: spi-nor-core: Do not set data direction when there is no data Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 15/28] mtd: spi-nor-core: Add support for DTR protocol Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 16/28] mtd: spi-nor-core: prepare BFPT parsing for JESD216 rev D Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 17/28] mtd: spi-nor-core: Get command opcode extension type from BFPT Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 18/28] mtd: spi-nor-core: Parse xSPI Profile 1.0 table Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 19/28] mtd: spi-nor-core: Prepare Read SR and FSR for Octal DTR mode Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 20/28] mtd: spi-nor-core: Enable octal DTR mode when possible Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 21/28] mtd: spi-nor-core: Do not make invalid quad enable fatal Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 22/28] mtd: spi-nor-core: Detect Soft Reset sequence support from BFPT Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 23/28] mtd: spi-nor-core: Perform a Soft Reset on shutdown Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 24/28] mtd: spi-nor-core: Perform a Soft Reset on boot Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 25/28] mtd: spi-nor-core: allow truncated erases Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 26/28] mtd: spi-nor-core: Add non-uniform erase for Spansion/Cypress Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 27/28] mtd: spi-nor-core: Add support for Cypress Semper flash Pratyush Yadav
2021-05-05 9:41 ` [PATCH v9 28/28] mtd: spi-nor-core: Allow using Micron mt35xu512aba in Octal DTR mode Pratyush Yadav
2021-05-10 13:20 ` [PATCH v9 00/28] mtd: spi-nor-core: add xSPI Octal DTR support Pratyush Yadav
2021-05-26 17:05 ` Jagan Teki
2021-05-27 16:23 ` Pratyush Yadav
2021-06-14 15:10 ` Pratyush Yadav
2021-06-23 12:02 ` Jagan Teki
2021-06-24 11:13 ` Pratyush Yadav
2021-06-25 15:32 ` Jagan Teki
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20210505094138.30805-10-p.yadav@ti.com \
--to=p.yadav@ti.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).