[PATCH 2/7] spi: zynq-qspi: Keep the naming consistent across the driver

From: Miquel Raynal <miquel.raynal@bootlin.com>
To: Mark Brown <broonie@kernel.org>,
	Michal Simek <michal.simek@xilinx.com>,
	Naga Sureshkumar Relli <naga.sureshkumar.relli@xilinx.com>
Cc: Miquel Raynal <miquel.raynal@bootlin.com>,
	Tudor Ambarus <Tudor.Ambarus@microchip.com>,
	linux-arm-kernel@lists.infradead.org,
	Thomas Petazzoni <thomas.petazzoni@bootlin.com>,
	linux-spi@vger.kernel.org
Subject: [PATCH 2/7] spi: zynq-qspi: Keep the naming consistent across the driver
Date: Fri,  8 Nov 2019 11:59:15 +0100	[thread overview]
Message-ID: <20191108105920.19014-3-miquel.raynal@bootlin.com> (raw)
In-Reply-To: <20191108105920.19014-1-miquel.raynal@bootlin.com>

In this driver (and also in a lot of other drivers in drivers/spi/),
the spi_controller structure is sometimes referred as 'ctlr' and
sometimes as 'ctrl'. Grepping there shows that 'ctlr' seems to be more
common so keep the naming consistent in this driver and s/ctrl/ctlr/.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/spi/spi-zynq-qspi.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/spi/spi-zynq-qspi.c b/drivers/spi/spi-zynq-qspi.c
index 8098b5087708..399c3ca33abb 100644
--- a/drivers/spi/spi-zynq-qspi.c
+++ b/drivers/spi/spi-zynq-qspi.c
@@ -309,8 +309,8 @@ static void zynq_qspi_txfifo_op(struct zynq_qspi *xqspi, unsigned int size)
  */
 static void zynq_qspi_chipselect(struct spi_device *spi, bool assert)
 {
-	struct spi_controller *ctrl = spi->master;
-	struct zynq_qspi *xqspi = spi_controller_get_devdata(ctrl);
+	struct spi_controller *ctlr = spi->master;
+	struct zynq_qspi *xqspi = spi_controller_get_devdata(ctlr);
 	u32 config_reg;
 
 	config_reg = zynq_qspi_read(xqspi, ZYNQ_QSPI_CONFIG_OFFSET);
@@ -381,10 +381,10 @@ static int zynq_qspi_config_op(struct zynq_qspi *xqspi, struct spi_device *spi)
  */
 static int zynq_qspi_setup_op(struct spi_device *spi)
 {
-	struct spi_controller *ctrl = spi->master;
-	struct zynq_qspi *qspi = spi_controller_get_devdata(ctrl);
+	struct spi_controller *ctlr = spi->master;
+	struct zynq_qspi *qspi = spi_controller_get_devdata(ctlr);
 
-	if (ctrl->busy)
+	if (ctlr->busy)
 		return -EBUSY;
 
 	clk_enable(qspi->refclk);
-- 
2.20.1
