Re: [PATCH v4 3/3] mtd: spi-nor: Add support for IS25LX256 operating in 1S-8S-8S octal read mode

From: Tudor Ambarus <tudor.ambarus@linaro.org>
To: Nathan Barrett-Morrison <nathan.morrison@timesys.com>
Cc: greg.malysa@timesys.com,
	Tudor Ambarus <tudor.ambarus@microchip.com>,
	Pratyush Yadav <pratyush@kernel.org>,
	Michael Walle <michael@walle.cc>,
	Miquel Raynal <miquel.raynal@bootlin.com>,
	Richard Weinberger <richard@nod.at>,
	Vignesh Raghavendra <vigneshr@ti.com>,
	"open list:SPI NOR SUBSYSTEM" <linux-mtd@lists.infradead.org>,
	open list <linux-kernel@vger.kernel.org>
Subject: Re: [PATCH v4 3/3] mtd: spi-nor: Add support for IS25LX256 operating in 1S-8S-8S octal read mode
Date: Mon, 26 Dec 2022 10:04:20 +0200	[thread overview]
Message-ID: <9927a8c3-40cf-2c69-46c6-f660ff2422b1@linaro.org> (raw)
In-Reply-To: <20221202135539.271936-4-nathan.morrison@timesys.com>

Hi, Nathan,

The series is starting to look good, but I'll need another version,
please.

On 02.12.2022 15:55, Nathan Barrett-Morrison wrote:
> This adds the IS25LX256 chip into the ISSI flash_info parts table

Describe your changes in imperative mood, e.g. "Add support for
S25LX256" instead of "This adds ..."

It may worth to re-read
https://www.kernel.org/doc/html/latest/process/submitting-patches.html
once in a while.

> 
> Signed-off-by: Nathan Barrett-Morrison <nathan.morrison@timesys.com>
> ---
>   drivers/mtd/spi-nor/issi.c | 32 ++++++++++++++++++++++++++++++++
>   1 file changed, 32 insertions(+)
> 
> diff --git a/drivers/mtd/spi-nor/issi.c b/drivers/mtd/spi-nor/issi.c
> index 89a66a19d754..362bc3603d8f 100644
> --- a/drivers/mtd/spi-nor/issi.c
> +++ b/drivers/mtd/spi-nor/issi.c
> @@ -29,6 +29,35 @@ static const struct spi_nor_fixups is25lp256_fixups = {
>   	.post_bfpt = is25lp256_post_bfpt_fixups,
>   };
>   
> +static int
> +is25lx256_post_bfpt_fixups(struct spi_nor *nor,
> +			   const struct sfdp_parameter_header *bfpt_header,
> +			   const struct sfdp_bfpt *bfpt)
> +{
> +	/*
> +	 * IS25LX256 supports both 1S-1S-8S and 1S-8S-8S.
> +	 * However, the BFPT does not contain any information denoting this
> +	 * functionality, so the proper fast read opcodes are never setup.
> +	 * We're correcting this issue via the fixup below.  Page program
> +	 * commands are detected and setup properly via the 4BAIT lookup.
> +	 */
> +	params->hwcaps.mask |= SNOR_HWCAPS_READ_1_1_8;

add a reference to params, the build fails here.

> +	spi_nor_set_read_settings(&params->reads[SNOR_CMD_READ_1_1_8],
> +				  0, 8, SPINOR_OP_READ_1_1_8,
> +				  SNOR_PROTO_1_1_8);
> +
> +	params->hwcaps.mask |= SNOR_HWCAPS_READ_1_8_8;
> +	spi_nor_set_read_settings(&params->reads[SNOR_CMD_READ_1_8_8],
> +				  0, 16, SPINOR_OP_READ_1_8_8,
> +				  SNOR_PROTO_1_8_8);
> +
> +	return 0;
> +}
> +
> +static const struct spi_nor_fixups is25lx256_fixups = {
> +	.post_bfpt = is25lx256_post_bfpt_fixups,
> +};
> +
>   static void pm25lv_nor_late_init(struct spi_nor *nor)
>   {
>   	struct spi_nor_erase_map *map = &nor->params->erase_map;
> @@ -74,6 +103,9 @@ static const struct flash_info issi_nor_parts[] = {
>   		NO_SFDP_FLAGS(SECT_4K | SPI_NOR_DUAL_READ | SPI_NOR_QUAD_READ)
>   		FIXUP_FLAGS(SPI_NOR_4B_OPCODES)
>   		.fixups = &is25lp256_fixups },
> +	{ "is25lx256", INFO(0x9d5a19, 0, 0, 0)
> +		PARSE_SFDP
> +		.fixups = &is25lx256_fixups },

For every new flash addition or update, we ask contributors to do some
little tests. Would you please run the commands from below and send us
the output?

# dd if=/dev/urandom of=./qspi_test bs=1M count=6
6+0 records in
6+0 records out

# mtd_debug write /dev/mtd4 0 6291456 qspi_test
Copied 6291456 bytes from qspi_test to address 0x00000000 in flash

# mtd_debug erase /dev/mtd4 0 6291456
Erased 6291456 bytes from address 0x00000000 in flash

# mtd_debug read /dev/mtd4 0 6291456 qspi_read
Copied 6291456 bytes from address 0x00000000 in flash to qspi_read

# hexdump qspi_read
0000000 ffff ffff ffff ffff ffff ffff ffff ffff
*

0600000

# mtd_debug write /dev/mtd4 0 6291456 qspi_test
Copied 6291456 bytes from qspi_test to address 0x00000000 in flash

# mtd_debug read /dev/mtd4 0 6291456 qspi_read
Copied 6291456 bytes from address 0x00000000 in flash to qspi_read

# sha1sum qspi_test qspi_read
57f8d4fee65622104e24276e865f662844f12242  qspi_test
57f8d4fee65622104e24276e865f662844f12242  qspi_read

# cat /sys/bus/spi/devices/spi0.0/spi-nor/partname
is25wp256

# cat /sys/bus/spi/devices/spi0.0/spi-nor/jedec_id
9d7019

# cat /sys/bus/spi/devices/spi0.0/spi-nor/manufacturer
issi

# xxd -p /sys/bus/spi/devices/spi0.0/spi-nor/sfdp
53464450060101ff00060110300000ff9d05010380000002ffffffffffff
ffffffffffffffffffffffffffffffffffffe520f9ffffffff0f44eb086b
083b80bbfeffffffffff00ffffff44eb0c200f5210d800ff234ac90082d8
11cecccd68467a757a75f7aed55c4a422cfff030faa9ffffffffffffffff
ffffffffffffffff501950169ff9c0648fefffff

# md5sum /sys/bus/spi/devices/spi0.0/spi-nor/sfdp
ba14818b9ec42713f24d94d66bb90ba0  /sys/bus/spi/devices/spi0.0/spi-nor/sfdp