Re: [PATCH v13 10/10] arm64: dts: qcom: sa8540-ride: Enable first port of tertiary usb controller

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 10/7/23 17:48, Krishna Kurapati wrote:
> From: Andrew Halaney <ahalaney@redhat.com>
> 
> There is now support for the multiport USB controller this uses so
> enable it.
> 
> The board only has a single port hooked up (despite it being wired up to
> the multiport IP on the SoC). There's also a USB 2.0 mux hooked up,
> which by default on boot is selected to mux properly. Grab the gpio
> controlling that and ensure it stays in the right position so USB 2.0
> continues to be routed from the external port to the SoC.
> 
> Co-developed-by: Andrew Halaney <ahalaney@redhat.com>
> Signed-off-by: Andrew Halaney <ahalaney@redhat.com>
> [Krishna: Rebased on top of usb-next]
> Co-developed-by: Krishna Kurapati <quic_kriskura@quicinc.com>
> Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
> ---
>   arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 21 +++++++++++++++++++++
>   1 file changed, 21 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> index b04f72ec097c..6904a4c201ff 100644
> --- a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> +++ b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> @@ -503,6 +503,18 @@ &usb_2_qmpphy0 {
>   	status = "okay";
>   };
>   
> +&usb_2 {
> +	pinctrl-0 = <&usb2_en_state>;
> +	pinctrl-names = "default";
> +
> +	status = "okay";
> +};
> +
> +&usb_2_dwc3 {
These additions are not quite sorted alphabetically, it seems

> +	phy-names = "usb2-port0", "usb3-port0";
> +	phys = <&usb_2_hsphy0>, <&usb_2_qmpphy0>;
property
property-names

With that:

Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>

Konrad