Re: [PATCH v5] ASoC: dt-bindings: davinci-mcasp: convert McASP bindings to yaml schema

[Rob Herring <robh@kernel.org>]

On Mon, 03 Jan 2022 13:14:27 +0530, Jayesh Choudhary wrote:
> Convert the bindings for McASP controllers for TI SOCs from txt
> to YAML schema.
> 
> Adds additional properties 'clocks', 'clock-names', 'power-domains',
> '#sound-dai-cells' and 'port' which were missing from the txt file.
> Removes properties 'sram-size-playback' and 'sram-size-capture'
> since they are not used.
> Adds 'dmas' and 'dma-names' in the example which were missing from
> the txt file.
> Changes 'interrupts' and 'interrupt-names' from optional to
> required properties.
> Changes 'op-modes', 'serial-dir' to optional properties as they are
> not needed if the McASP is used only as GPIO.
> Changes 'tdm-slots' to required property only for I2S operation mode.
> 
> Adds the yaml file in the 'MAINTAINERS' under the heading 'TEXAS
> INSTRUMENTS ASoC DRIVERS'
> 
> Signed-off-by: Jayesh Choudhary <j-choudhary@ti.com>
> ---
> Changelog:
> v5:
> - changes the commit message
> - changes description for 'reg', 'op-mode', 'tx-num-evt',
>   'rx-num-evt' and 'interrupts'
> - adds minimum and maximum for 'tdm-slots'
> - removes default from 'serial-dir'
> - removes maxItems from 'tdm-slots', 'tx-num-evt', 'rx-num-evt' and
>   'auxclk-fs-ratio' as they are of type uint32
> - adds 'tdm-slots' as conditionally required property for I2S mode
>   of operation
> 
> v4:
> - changes the commit message
> - adds type and description to relevant properties
> - changes maxItems for 'serial-dir'
> - removes properties 'sram-size-playback' and 'sram-size-capture'
>   as they are not used
> - removes 'function-gpios'
> - removes 'num-serializer'
> - marks 'tdm-slots', 'op-mode' and 'serial-dir' as optional properties
> - adds the yaml file in MAINTAINERS
> 
> v3:
> - remove maxItems from 'clock-names'
> 
> v2:
> - changes the commit message
> - modifies the properties 'clocks', 'clock-names', 'dma-names',
>   'dmas', 'interrupts' and 'interrupt-names' according to the
>   arm SOCs
> - adds 'ports' and 'num-serializer' as node properties
> 
>  .../bindings/sound/davinci-mcasp-audio.txt    |  86 --------
>  .../bindings/sound/davinci-mcasp-audio.yaml   | 201 ++++++++++++++++++
>  MAINTAINERS                                   |   1 +
>  3 files changed, 202 insertions(+), 86 deletions(-)
>  delete mode 100644 Documentation/devicetree/bindings/sound/davinci-mcasp-audio.txt
>  create mode 100644 Documentation/devicetree/bindings/sound/davinci-mcasp-audio.yaml
> 

Running 'make dtbs_check' with the schema in this patch gives the
following warnings. Consider if they are expected or the schema is
incorrect. These may not be new warnings.

Note that it is not yet a requirement to have 0 warnings for dtbs_check.
This will change in the future.

Full log is available here: https://patchwork.ozlabs.org/patch/1574696


mcasp@0: 'num-serializer' does not match any of the regexes: 'pinctrl-[0-9]+'
	arch/arm/boot/dts/am335x-cm-t335.dt.yaml
	arch/arm/boot/dts/am335x-sbc-t335.dt.yaml

mcasp@0: 'rt-num-evt' does not match any of the regexes: 'pinctrl-[0-9]+'
	arch/arm/boot/dts/am335x-wega-rdk.dt.yaml

mcasp@2b00000: 'tdm-slots' is a required property
	arch/arm64/boot/dts/ti/k3-am6528-iot2050-basic.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6528-iot2050-basic-pg2.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6548-iot2050-advanced.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6548-iot2050-advanced-pg2.dt.yaml

mcasp@2b10000: 'tdm-slots' is a required property
	arch/arm64/boot/dts/ti/k3-am6528-iot2050-basic.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6528-iot2050-basic-pg2.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6548-iot2050-advanced.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6548-iot2050-advanced-pg2.dt.yaml

mcasp@2b20000: 'tdm-slots' is a required property
	arch/arm64/boot/dts/ti/k3-am6528-iot2050-basic.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6528-iot2050-basic-pg2.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6548-iot2050-advanced.dt.yaml
	arch/arm64/boot/dts/ti/k3-am6548-iot2050-advanced-pg2.dt.yaml