[PATCH v12 00/13] Add tested id switch and vbus connect detect support for Chipidea

[marex@denx.de (Marek Vasut)]

Hi Peter,

> This patchset adds tested otg id switch function and
> vbus connect and disconnect detection for chipidea driver.
> And fix kinds of bugs found at chipidea drivers after enabling
> id and vbus detection.
> 
> This patch is fully tested at imx6 sabresd platform.
> My chipidea repo: https://github.com/hzpeterchen/linux-usb.git
> 
> Changes for v12:
> - Rebased greg's usb-next tree (3.10.0-rc7+)
> - Split more small patches for single function and fix.

I tested the patchset. Here are the results:

- VBUS switching

I'm no longer getting any ID interrupts at all when I apply the patch below. The 
board stays in HOST mode all the time. If I configure it as peripheral, it works 
as peripheral. Note with [1], I was able to switch from Peripheral->Host , not 
the other way around.

--- a/arch/arm/boot/dts/imx28-m28evk.dts
+++ b/arch/arm/boot/dts/imx28-m28evk.dts
@@ -240,6 +240,8 @@
 
        ahb at 80080000 {
                usb0: usb at 80080000 {
+                       dr_mode = "otg";
+                       phy_mode = "utmi";
                        vbus-supply = <&reg_usb0_vbus>;
                        pinctrl-names = "default";
                        pinctrl-0 = <&usbphy0_pins_a>;

---------------------------

- MX23 UDC issue

I found a workaround. Now running 'dmesg' via telnet through USB CDC link no 
longer hangs the USB driver, but works as expected. I applied this small patch 
that enables the streaming mode. Works on MX23EVK. It's surprising this issue 
doesn't manifest on MX28, maybe MX28 contains a new revision of the controller. 
I remember there was some discussion about the streaming mode on MXS some time 
ago.

diff --git a/drivers/usb/chipidea/ci_hdrc_imx.c 
b/drivers/usb/chipidea/ci_hdrc_imx.c
index d06355e..bba8e25 100644
--- a/drivers/usb/chipidea/ci_hdrc_imx.c
+++ b/drivers/usb/chipidea/ci_hdrc_imx.c
@@ -92,8 +92,7 @@ static int ci_hdrc_imx_probe(struct platform_device *pdev)
                .name           = "ci_hdrc_imx",
                .capoffset      = DEF_CAPOFFSET,
                .flags          = CI_HDRC_REQUIRE_TRANSCEIVER |
-                                 CI_HDRC_PULLUP_ON_VBUS |
-                                 CI_HDRC_DISABLE_STREAMING,
+                                 CI_HDRC_PULLUP_ON_VBUS,
        };
        struct resource *res;
        int ret;

[1] 
http://git.pengutronix.de/?p=mgr/linux.git;a=shortlog;h=refs/heads/v3.10/topic/usb-
peterchen

Best regards,
Marek Vasut