From: Jiri Benc <jbenc@redhat.com>
To: Simon Horman <simon.horman@netronome.com>
Cc: pravin shelar <pshelar@ovn.org>,
Linux Kernel Network Developers <netdev@vger.kernel.org>,
ovs dev <dev@openvswitch.org>
Subject: Re: [PATCH v9 net-next 7/7] openvswitch: use ipgre tunnel rather than gretap tunnel
Date: Fri, 6 May 2016 11:15:11 +0200 [thread overview]
Message-ID: <20160506111511.5eecb505@griffin> (raw)
In-Reply-To: <20160506065400.GA15277@penelope.isobedori.kobe.vergenet.net>
On Fri, 6 May 2016 15:54:02 +0900, Simon Horman wrote:
> -int ovs_netdev_send_raw_tun(struct sk_buff *skb)
> -{
> - if (skb->mac_len)
> - skb->protocol = ntohs(ETH_P_TEB);
> + if (dev->type != ARPHRD_ETHER && skb->mac_len) {
> + skb->protocol = htons(ETH_P_TEB);
> + } else if (dev->type == ARPHRD_ETHER && !skb->mac_len) {
> + kfree_skb(skb);
> + return -EINVAL;
> + }
This was something I was missing in your patches (sorry, did not get to
the full review yet).
You'll also need to enable ARPHRD_NONE and ARPHRD_IPGRE interfaces in
ovs_netdev_link.
Jiri
prev parent reply other threads:[~2016-05-06 9:15 UTC|newest]
Thread overview: 43+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-05-04 7:36 [PATCH v9 net-next 0/7] openvswitch: support for layer 3 encapsulated packets Simon Horman
2016-05-04 7:36 ` [PATCH v9 net-next 1/7] net: add skb_vlan_deaccel helper Simon Horman
2016-05-04 7:36 ` [PATCH v9 net-next 2/7] openvswitch: set skb protocol when receiving on internal device Simon Horman
2016-05-04 7:36 ` [PATCH v9 net-next 3/7] openvswitch: add support to push and pop mpls for layer3 packets Simon Horman
[not found] ` <1462347393-22354-4-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-05 17:35 ` pravin shelar
2016-05-06 4:33 ` Simon Horman
2016-05-04 7:36 ` [PATCH v9 net-next 4/7] openvswitch: add layer 3 flow/port support Simon Horman
[not found] ` <1462347393-22354-5-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-05 17:37 ` pravin shelar
2016-05-06 5:57 ` Simon Horman
2016-05-06 9:25 ` Jiri Benc
2016-05-09 8:04 ` Simon Horman
[not found] ` <20160509080420.GA4470-IxS8c3vjKQDk1uMJSBkQmQ@public.gmane.org>
2016-05-10 12:01 ` Jiri Benc
2016-05-11 1:50 ` Simon Horman
[not found] ` <20160511015009.GB24436-IxS8c3vjKQDk1uMJSBkQmQ@public.gmane.org>
2016-05-11 3:06 ` Simon Horman
2016-05-11 14:09 ` Jiri Benc
2016-05-11 22:46 ` Simon Horman
2016-05-17 14:43 ` Jiri Benc
2016-05-18 2:18 ` Simon Horman
2016-05-11 13:57 ` Jiri Benc
2016-05-06 9:35 ` Jiri Benc
2016-05-09 8:18 ` Simon Horman
2016-05-10 0:16 ` [ovs-dev] " Yang, Yi Y
[not found] ` <79BBBFE6CB6C9B488C1A45ACD284F51913CB6446-0J0gbvR4kTggGBtAFL8yw7fspsVTdybXVpNB7YpNyf8@public.gmane.org>
2016-05-10 12:07 ` Jiri Benc
2016-05-10 12:06 ` Jiri Benc
2016-05-11 3:28 ` Simon Horman
2016-05-11 14:10 ` Jiri Benc
2016-05-17 14:32 ` Jiri Benc
2016-05-20 5:29 ` Simon Horman
2016-05-20 8:00 ` Jiri Benc
2016-05-20 8:11 ` Simon Horman
2016-05-20 8:16 ` Simon Horman
[not found] ` <20160520081611.GB17561-IxS8c3vjKQDk1uMJSBkQmQ@public.gmane.org>
2016-05-20 8:39 ` Jiri Benc
2016-05-20 9:12 ` Simon Horman
2016-05-20 9:20 ` Jiri Benc
2016-05-20 10:14 ` Simon Horman
[not found] ` <1462347393-22354-1-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-04 7:36 ` [PATCH v9 net-next 5/7] openvswitch: add layer 3 support to ovs_packet_cmd_execute() Simon Horman
[not found] ` <1462347393-22354-6-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-17 14:51 ` Jiri Benc
2016-05-18 2:24 ` Simon Horman
2016-05-04 7:36 ` [PATCH v9 net-next 6/7] openvswitch: extend layer 3 support to cover non-IP packets Simon Horman
2016-05-04 7:36 ` [PATCH v9 net-next 7/7] openvswitch: use ipgre tunnel rather than gretap tunnel Simon Horman
[not found] ` <1462347393-22354-8-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-05 21:45 ` pravin shelar
2016-05-06 6:54 ` Simon Horman
2016-05-06 9:15 ` Jiri Benc [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20160506111511.5eecb505@griffin \
--to=jbenc@redhat.com \
--cc=dev@openvswitch.org \
--cc=netdev@vger.kernel.org \
--cc=pshelar@ovn.org \
--cc=simon.horman@netronome.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.