All of lore.kernel.org
 help / color / mirror / Atom feed
From: Jiri Benc <jbenc@redhat.com>
To: Simon Horman <simon.horman@netronome.com>
Cc: pravin shelar <pshelar@ovn.org>,
	Linux Kernel Network Developers <netdev@vger.kernel.org>,
	ovs dev <dev@openvswitch.org>, Lorand Jakab <lojakab@cisco.com>,
	Thomas Morin <thomas.morin@orange.com>
Subject: Re: [PATCH v9 net-next 4/7] openvswitch: add layer 3 flow/port support
Date: Fri, 6 May 2016 11:25:14 +0200	[thread overview]
Message-ID: <20160506112514.47f6e9dc@griffin> (raw)
In-Reply-To: <20160506055705.GA9276@penelope.isobedori.kobe.vergenet.net>

On Fri, 6 May 2016 14:57:07 +0900, Simon Horman wrote:
> On Thu, May 05, 2016 at 10:37:08AM -0700, pravin shelar wrote:
> > On transmit side you are using mac_len to detect l3 packet, why not do
> > same while extracting the key?

I agree. The skb should be self-contained, i.e. it should be obvious
whether it has the MAC header set or not just from the skb itself at
any point in the packet processing. Otherwise, I'd expect things like
recirculation to break after push/pop of eth header.

> Unfortunately mac_len can't be relied on here, emprically it has the same
> value (28 in my tests) for both the TEB and layer3 case above.

That's strange, it looks like there's something setting the mac header
unconditionally in ovs code. We should find that place and change it.

The ARPHRD_NONE interfaces don't even set mac_header and mac_len, this
will need to be set by ovs upon getting frame from such interface. 

> Perhaps that could be changed by futher enhancements in the tunneling code
> but I think things are symetric as they stand:
> 
> * On recieve skb->protocol can be read to distinguish TEB and layer3 packets
> * On transmit skb->protocol should be set to distinguish TEB and layer3 packets

Yes, but you need to act upon this directly after receiving the
frame/just before sending the frame and set up an internal flag that
will be used throughout the code. That way, the packet can be handed
over to different parts of the code, recirculated, etc. without
worries. skb->mac_len is probably a good candidate for such flag.

 Jiri

  reply	other threads:[~2016-05-06  9:25 UTC|newest]

Thread overview: 43+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2016-05-04  7:36 [PATCH v9 net-next 0/7] openvswitch: support for layer 3 encapsulated packets Simon Horman
2016-05-04  7:36 ` [PATCH v9 net-next 1/7] net: add skb_vlan_deaccel helper Simon Horman
2016-05-04  7:36 ` [PATCH v9 net-next 2/7] openvswitch: set skb protocol when receiving on internal device Simon Horman
2016-05-04  7:36 ` [PATCH v9 net-next 3/7] openvswitch: add support to push and pop mpls for layer3 packets Simon Horman
     [not found]   ` <1462347393-22354-4-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-05 17:35     ` pravin shelar
2016-05-06  4:33       ` Simon Horman
2016-05-04  7:36 ` [PATCH v9 net-next 4/7] openvswitch: add layer 3 flow/port support Simon Horman
     [not found]   ` <1462347393-22354-5-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-05 17:37     ` pravin shelar
2016-05-06  5:57       ` Simon Horman
2016-05-06  9:25         ` Jiri Benc [this message]
2016-05-09  8:04           ` Simon Horman
     [not found]             ` <20160509080420.GA4470-IxS8c3vjKQDk1uMJSBkQmQ@public.gmane.org>
2016-05-10 12:01               ` Jiri Benc
2016-05-11  1:50                 ` Simon Horman
     [not found]                   ` <20160511015009.GB24436-IxS8c3vjKQDk1uMJSBkQmQ@public.gmane.org>
2016-05-11  3:06                     ` Simon Horman
2016-05-11 14:09                       ` Jiri Benc
2016-05-11 22:46                         ` Simon Horman
2016-05-17 14:43                           ` Jiri Benc
2016-05-18  2:18                             ` Simon Horman
2016-05-11 13:57                   ` Jiri Benc
2016-05-06  9:35   ` Jiri Benc
2016-05-09  8:18     ` Simon Horman
2016-05-10  0:16       ` [ovs-dev] " Yang, Yi Y
     [not found]         ` <79BBBFE6CB6C9B488C1A45ACD284F51913CB6446-0J0gbvR4kTggGBtAFL8yw7fspsVTdybXVpNB7YpNyf8@public.gmane.org>
2016-05-10 12:07           ` Jiri Benc
2016-05-10 12:06       ` Jiri Benc
2016-05-11  3:28         ` Simon Horman
2016-05-11 14:10           ` Jiri Benc
2016-05-17 14:32   ` Jiri Benc
2016-05-20  5:29     ` Simon Horman
2016-05-20  8:00       ` Jiri Benc
2016-05-20  8:11         ` Simon Horman
2016-05-20  8:16           ` Simon Horman
     [not found]             ` <20160520081611.GB17561-IxS8c3vjKQDk1uMJSBkQmQ@public.gmane.org>
2016-05-20  8:39               ` Jiri Benc
2016-05-20  9:12                 ` Simon Horman
2016-05-20  9:20                   ` Jiri Benc
2016-05-20 10:14                     ` Simon Horman
     [not found] ` <1462347393-22354-1-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-04  7:36   ` [PATCH v9 net-next 5/7] openvswitch: add layer 3 support to ovs_packet_cmd_execute() Simon Horman
     [not found]     ` <1462347393-22354-6-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-17 14:51       ` Jiri Benc
2016-05-18  2:24         ` Simon Horman
2016-05-04  7:36 ` [PATCH v9 net-next 6/7] openvswitch: extend layer 3 support to cover non-IP packets Simon Horman
2016-05-04  7:36 ` [PATCH v9 net-next 7/7] openvswitch: use ipgre tunnel rather than gretap tunnel Simon Horman
     [not found]   ` <1462347393-22354-8-git-send-email-simon.horman-wFxRvT7yatFl57MIdRCFDg@public.gmane.org>
2016-05-05 21:45     ` pravin shelar
2016-05-06  6:54       ` Simon Horman
2016-05-06  9:15         ` Jiri Benc

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20160506112514.47f6e9dc@griffin \
    --to=jbenc@redhat.com \
    --cc=dev@openvswitch.org \
    --cc=lojakab@cisco.com \
    --cc=netdev@vger.kernel.org \
    --cc=pshelar@ovn.org \
    --cc=simon.horman@netronome.com \
    --cc=thomas.morin@orange.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.