Re: Device tree binding for DVFS table

[Rob Herring <robherring2@gmail.com>]

On 07/11/2012 07:56 AM, Prashant Gaikwad wrote:
> Hi,
> 
> I am working on DT binding for Tegra DVFS.
> 
> For Tegra, DVFS node mainly consists of frequency and voltage pairs.
> Frequency in the pair may change for different process. E.g. for process
> 1 CPU clock frequency could be 900MHz at 1V while for process 2 it could
> be 1GHz at 1V.
> Tegra uses vendor specific ids to identify the correct frequency table.
> 
> Following is the proposed binding for voltage and frequency tables used
> in DVFS. Looking for comments/suggestions to make it generic.
> 
> ====DVFS table node=========> This node defines the voltage configuration for the DVFS which includes
> the regulator and voltage array.
> 
> Required properties:
> 
> reg_id : <regulator phandle>;
> voltage-table : <voltage array, values in mV>;
> 
> #address-cells and #size-cells : To identify correct frequency table
> using process id (or some other vendor specific way).
> 
> ====Frequency table node=======> 
> This node defines frequency configuration for the device DVFS.
> 
> Required properties:
> 
> In device node need a reference to the DVFS table node.
> 
> dvfs : the phandle for the DVFS table node
> 
> frequency-table@n
>        reg = <n>; dependent on address-cells and size-cells in DVFS
> table node.
>        frequencies = <frequency array, values in MHz>;

You are storing u32 values, why limit the resolution to MHz.

Put the unit in the property names.

> }
> 
> Example:
> -------------------------------------------------------------------------
> 
> cpu-dvfs-table : dvfs-table {

This should be located with the node that the frequencies correspond to.

>               compatible = "nvidia,tegra30-dvfs-table";
>               reg_id = <&sm0>;
>               #address-cells = <1>;
>               #size-cells = <0>;
>               voltage-array = <750 775 800 825 850 875 900 925 950 975
> 1000 1025 1050 1100 1125>;

The SOC is really characterized at all these voltages?

> };
> 
> device {
>              dvfs = <&cpu-dvfs-table>;
>              frequency-table@102 {
>                       reg = <0x102>;
>                       frequencies = <314 314 314 456 456 456 608 608 608
> 760 817 817 912 1000>;

I don't see the point of repeating frequencies.

>              };
>              frequency-table@002 {
>                       reg = <0x002>;
>                       frequencies = <598 598 750 750 893 893 1000>;
>              };

How do you determine the voltage for a frequency on table 2?

I'd expect a single property with freq/volt pairs or 2 properties for
freq and voltage where there is a 1:1 relationship (freq N uses voltage N).

Rob

> };
> 
> Thanks & Regards,
> Prashant G
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel