Re: [PATCH] arm64: dts: sun50i: sopine-baseboard: Expose serial1, serial2 and serial3

[Alistair Francis <alistair23@gmail.com>]

On Wed, Oct 16, 2019 at 7:54 AM Chen-Yu Tsai <wens@csie.org> wrote:
>
> On Wed, Oct 16, 2019 at 10:49 PM Maxime Ripard <mripard@kernel.org> wrote:
> >
> > Hi,
> >
> > On Sat, Oct 12, 2019 at 01:05:24PM -0700, Alistair Francis wrote:
> > > Follow what the sun50i-a64-pine64.dts does and expose all 5 serial
> > > connections.
> > >
> > > Signed-off-by: Alistair Francis <alistair@alistair23.me>
> > > ---
> > >  .../allwinner/sun50i-a64-sopine-baseboard.dts | 25 +++++++++++++++++++
> > >  1 file changed, 25 insertions(+)
> > >
> > > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
> > > index 124b0b030b28..49c37b21ab36 100644
> > > --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
> > > +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-sopine-baseboard.dts
> > > @@ -56,6 +56,10 @@
> > >       aliases {
> > >               ethernet0 = &emac;
> > >               serial0 = &uart0;
> > > +             serial1 = &uart1;
> > > +             serial2 = &uart2;
> > > +             serial3 = &uart3;
> > > +             serial4 = &uart4;
> > >       };
> > >
> > >       chosen {
> > > @@ -280,6 +284,27 @@
> > >       };
> > >  };
> > >
> > > +/* On Pi-2 connector */
> > > +&uart2 {
> > > +     pinctrl-names = "default";
> > > +     pinctrl-0 = <&uart2_pins>;
> > > +     status = "disabled";
> > > +};
> > > +
> > > +/* On Euler connector */
> > > +&uart3 {
> > > +     pinctrl-names = "default";
> > > +     pinctrl-0 = <&uart3_pins>;
> > > +     status = "disabled";
> > > +};
> > > +
> > > +/* On Euler connector, RTS/CTS optional */
> > > +&uart4 {
> > > +     pinctrl-names = "default";
> > > +     pinctrl-0 = <&uart4_pins>;
> > > +     status = "disabled";
> > > +};
> >
> > Since these are all the default muxing, maybe we should just set that
> > in the DTSI?
>
> Maybe not, since people may want to only use RX/TX, and leave the other
> two pins for GPIO?

I think this makes the most sense for the default.

Alistair

>
> ChenYu