Re: [PATCH v2 1/7] dt-bindings: misc: Add the Lantiq PEF2466 E1/T1/J1 framer

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 20/03/2023 10:46, Herve Codina wrote:
>>
>>> +
>>> +  lantiq,data-rate-bps:
>>> +    $ref: /schemas/types.yaml#/definitions/uint32
>>> +    enum: [2048000, 4096000, 8192000, 16384000]
>>> +    default: 2048000
>>> +    description:
>>> +      Data rate (bit per seconds) on the system highway.  
>>
>> Why do you need it? How is it different from clock? Do you expect some
>> DDR here?
> 
> This is needed to set the data position on the data line.
> If the data line clock (sysclk-rate-hz) is greater than 'data-rate-bps',
> the device interleaves some holes between data in the full frame.
> 
> The exact position of the data and the holes is defined by 'channel-phase'
> 
> So, two information are needed:
> - The number of slots available (deduced from 'lantiq,data-rate-bps')
> - The slot to use in the available slots ('lantiq,channel-phase" property
> 
> lantiq,data-rate-bps is not a clock but a property used to set the frame
> physical setting. ie the correct data position in the frame. 

OK

(...)

>>> +additionalProperties: false
>>> +
>>> +examples:
>>> +  - |
>>> +    #include <dt-bindings/gpio/gpio.h>
>>> +    pef2256@2000000 {  
>>
>> Figure out some generic node name.
> 
> What do you think about 'framer' ?

Sure, I don't have particular proposal.


Best regards,
Krzysztof