Linux-ACPI Archive on lore.kernel.org
 help / color / Atom feed
From: Jonathan Cameron <Jonathan.Cameron@Huawei.com>
To: Ben Widawsky <ben.widawsky@intel.com>
Cc: <linux-cxl@vger.kernel.org>, <linux-pci@vger.kernel.org>,
	<linux-acpi@vger.kernel.org>, <ira.weiny@intel.com>,
	<vishal.l.verma@intel.com>, <alison.schofield@intel.com>,
	<dan.j.williams@intel.com>, <linux-kernel@vger.kernel.org>
Subject: Re: [PATCH 4/7] cxl/mem: Get rid of @cxlm.base
Date: Wed, 14 Apr 2021 10:24:43 +0100
Message-ID: <20210414102443.000071a7@Huawei.com> (raw)
In-Reply-To: <20210413161726.tz7rg46krrekk3lp@intel.com>

On Tue, 13 Apr 2021 09:17:26 -0700
Ben Widawsky <ben.widawsky@intel.com> wrote:

> On 21-04-08 18:26:35, Jonathan Cameron wrote:
> > On Wed, 7 Apr 2021 15:26:22 -0700
> > Ben Widawsky <ben.widawsky@intel.com> wrote:
> >   
> > > @cxlm.base only existed to support holding the base found in the
> > > register block mapping code, and pass it along to the register setup
> > > code. Now that the register setup function has all logic around managing
> > > the registers, from DVSEC to iomapping up to populating our CXL specific
> > > information, it is easy to turn the @base values into local variables
> > > and remove them from our device driver state.
> > > 
> > > Signed-off-by: Ben Widawsky <ben.widawsky@intel.com>  
> > 
> > Patch is basically fine, but I do wonder if you could avoid the
> > nasty casting in and out of __iomem in the error paths.
> > 
> > It's a common enough idiom though so I'm not htat fussed.
> > 
> > Acked-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
> >   
> > > ---
> > >  drivers/cxl/mem.c | 24 +++++++++++-------------
> > >  drivers/cxl/mem.h |  2 --
> > >  2 files changed, 11 insertions(+), 15 deletions(-)
> > > 
> > > diff --git a/drivers/cxl/mem.c b/drivers/cxl/mem.c
> > > index 04b4f7445083..60b95c524c3e 100644
> > > --- a/drivers/cxl/mem.c
> > > +++ b/drivers/cxl/mem.c
> > > @@ -922,11 +922,10 @@ static struct cxl_mem *cxl_mem_create(struct pci_dev *pdev)
> > >  	return cxlm;
> > >  }
> > >  
> > > -static int cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32 reg_hi)
> > > +static void __iomem *cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32 reg_hi)
> > >  {
> > >  	struct pci_dev *pdev = cxlm->pdev;
> > >  	struct device *dev = &pdev->dev;
> > > -	void __iomem *regs;
> > >  	u64 offset;
> > >  	u8 bar;
> > >  	int rc;
> > > @@ -938,20 +937,18 @@ static int cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32 reg_hi)
> > >  	if (pci_resource_len(pdev, bar) < offset) {
> > >  		dev_err(dev, "BAR%d: %pr: too small (offset: %#llx)\n", bar,
> > >  			&pdev->resource[bar], (unsigned long long)offset);
> > > -		return -ENXIO;
> > > +		return (void __iomem *)ERR_PTR(-ENXIO);
> > >  	}
> > >  
> > >  	rc = pcim_iomap_regions(pdev, BIT(bar), pci_name(pdev));
> > >  	if (rc) {
> > >  		dev_err(dev, "failed to map registers\n");
> > > -		return rc;
> > > +		return (void __iomem *)ERR_PTR(rc);  
> > 
> > The casting is fairly horrible, perhaps just pass in
> > a void __iomem ** and pass base back through that?
> >   
> 
> TIL: IOMEM_ERR_PTR. Would that suffice?

Definitely.  Didn't know about that!

Jonathan


  reply index

Thread overview: 22+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-04-07 22:26 [PATCH 0/7] Enumerate HDM Decoder registers Ben Widawsky
2021-04-07 22:26 ` [PATCH 1/7] cxl/mem: Use dev instead of pdev->dev Ben Widawsky
2021-04-08 17:08   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 2/7] cxl/mem: Split creation from mapping in probe Ben Widawsky
2021-04-08 17:13   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 3/7] cxl/mem: Move register locator logic into reg setup Ben Widawsky
2021-04-08 17:27   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 4/7] cxl/mem: Get rid of @cxlm.base Ben Widawsky
2021-04-08 17:26   ` Jonathan Cameron
2021-04-13 16:17     ` Ben Widawsky
2021-04-14  9:24       ` Jonathan Cameron [this message]
2021-05-20 21:29       ` [PATCH v2 " Ben Widawsky
2021-04-07 22:26 ` [PATCH 5/7] cxl/mem: Move device register setup Ben Widawsky
2021-04-08 17:28   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 6/7] cxl/mem: Create a helper to setup device regs Ben Widawsky
2021-04-08 17:33   ` Jonathan Cameron
2021-04-15 22:54   ` Dan Williams
2021-04-07 22:26 ` [PATCH 7/7] cxl: Add HDM decoder capbilities Ben Widawsky
2021-04-08 17:57   ` Jonathan Cameron
2021-04-15 23:27   ` Dan Williams
2021-04-15 23:50     ` Ben Widawsky
2021-04-16  0:25       ` Dan Williams

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20210414102443.000071a7@Huawei.com \
    --to=jonathan.cameron@huawei.com \
    --cc=alison.schofield@intel.com \
    --cc=ben.widawsky@intel.com \
    --cc=dan.j.williams@intel.com \
    --cc=ira.weiny@intel.com \
    --cc=linux-acpi@vger.kernel.org \
    --cc=linux-cxl@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pci@vger.kernel.org \
    --cc=vishal.l.verma@intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ACPI Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-acpi/0 linux-acpi/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-acpi linux-acpi/ https://lore.kernel.org/linux-acpi \
		linux-acpi@vger.kernel.org
	public-inbox-index linux-acpi

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-acpi


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git