Re: [PATCH v4 2/6] clk: imx: Mark dram pll on 8mm and 8mn with CLK_GET_RATE_NOCACHE

[Abel Vesa <abel.vesa@nxp.com>]

On 19-11-09 00:39:52, Leonard Crestez wrote:
> DRAM frequency switches are executed in firmware and can change the
> configuration of the DRAM PLL outside linux. Mark these CLKs with
> CLK_GET_RATE_NOCACHE so we always read back the PLL config registers and
> recalculate rates.
> 
> In current DRAM frequency tables on 8mm/8mn only the maximum frequency
> uses the PLL so it's always configured in the same way. However reading
> back the PLL configuration is the correct behavior and allows additional
> setpoints in the future.
> 
> Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com>

This one looks fine.

Reviewed-by: Abel Vesa <abel.vesa@nxp.com>

> ---
>  drivers/clk/imx/clk-imx8mm.c  | 2 +-
>  drivers/clk/imx/clk-imx8mn.c  | 2 +-
>  drivers/clk/imx/clk-pll14xx.c | 7 +++++++
>  drivers/clk/imx/clk.h         | 1 +
>  4 files changed, 10 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/clk/imx/clk-imx8mm.c b/drivers/clk/imx/clk-imx8mm.c
> index c58f988191a5..d500bac3afa1 100644
> --- a/drivers/clk/imx/clk-imx8mm.c
> +++ b/drivers/clk/imx/clk-imx8mm.c
> @@ -326,11 +326,11 @@ static int imx8mm_clocks_probe(struct platform_device *pdev)
>  	clks[IMX8MM_SYS_PLL3_REF_SEL] = imx_clk_mux("sys_pll3_ref_sel", base + 0x114, 0, 2, pll_ref_sels, ARRAY_SIZE(pll_ref_sels));
>  
>  	clks[IMX8MM_AUDIO_PLL1] = imx_clk_pll14xx("audio_pll1", "audio_pll1_ref_sel", base, &imx_1443x_pll);
>  	clks[IMX8MM_AUDIO_PLL2] = imx_clk_pll14xx("audio_pll2", "audio_pll2_ref_sel", base + 0x14, &imx_1443x_pll);
>  	clks[IMX8MM_VIDEO_PLL1] = imx_clk_pll14xx("video_pll1", "video_pll1_ref_sel", base + 0x28, &imx_1443x_pll);
> -	clks[IMX8MM_DRAM_PLL] = imx_clk_pll14xx("dram_pll", "dram_pll_ref_sel", base + 0x50, &imx_1443x_pll);
> +	clks[IMX8MM_DRAM_PLL] = imx_clk_pll14xx("dram_pll", "dram_pll_ref_sel", base + 0x50, &imx_1443x_dram_pll);
>  	clks[IMX8MM_GPU_PLL] = imx_clk_pll14xx("gpu_pll", "gpu_pll_ref_sel", base + 0x64, &imx_1416x_pll);
>  	clks[IMX8MM_VPU_PLL] = imx_clk_pll14xx("vpu_pll", "vpu_pll_ref_sel", base + 0x74, &imx_1416x_pll);
>  	clks[IMX8MM_ARM_PLL] = imx_clk_pll14xx("arm_pll", "arm_pll_ref_sel", base + 0x84, &imx_1416x_pll);
>  	clks[IMX8MM_SYS_PLL1] = imx_clk_fixed("sys_pll1", 800000000);
>  	clks[IMX8MM_SYS_PLL2] = imx_clk_fixed("sys_pll2", 1000000000);
> diff --git a/drivers/clk/imx/clk-imx8mn.c b/drivers/clk/imx/clk-imx8mn.c
> index ca78cb1249a7..9c605ca1b631 100644
> --- a/drivers/clk/imx/clk-imx8mn.c
> +++ b/drivers/clk/imx/clk-imx8mn.c
> @@ -323,11 +323,11 @@ static int imx8mn_clocks_probe(struct platform_device *pdev)
>  	clks[IMX8MN_SYS_PLL3_REF_SEL] = imx_clk_mux("sys_pll3_ref_sel", base + 0x114, 0, 2, pll_ref_sels, ARRAY_SIZE(pll_ref_sels));
>  
>  	clks[IMX8MN_AUDIO_PLL1] = imx_clk_pll14xx("audio_pll1", "audio_pll1_ref_sel", base, &imx_1443x_pll);
>  	clks[IMX8MN_AUDIO_PLL2] = imx_clk_pll14xx("audio_pll2", "audio_pll2_ref_sel", base + 0x14, &imx_1443x_pll);
>  	clks[IMX8MN_VIDEO_PLL1] = imx_clk_pll14xx("video_pll1", "video_pll1_ref_sel", base + 0x28, &imx_1443x_pll);
> -	clks[IMX8MN_DRAM_PLL] = imx_clk_pll14xx("dram_pll", "dram_pll_ref_sel", base + 0x50, &imx_1443x_pll);
> +	clks[IMX8MN_DRAM_PLL] = imx_clk_pll14xx("dram_pll", "dram_pll_ref_sel", base + 0x50, &imx_1443x_dram_pll);
>  	clks[IMX8MN_GPU_PLL] = imx_clk_pll14xx("gpu_pll", "gpu_pll_ref_sel", base + 0x64, &imx_1416x_pll);
>  	clks[IMX8MN_VPU_PLL] = imx_clk_pll14xx("vpu_pll", "vpu_pll_ref_sel", base + 0x74, &imx_1416x_pll);
>  	clks[IMX8MN_ARM_PLL] = imx_clk_pll14xx("arm_pll", "arm_pll_ref_sel", base + 0x84, &imx_1416x_pll);
>  	clks[IMX8MN_SYS_PLL1] = imx_clk_fixed("sys_pll1", 800000000);
>  	clks[IMX8MN_SYS_PLL2] = imx_clk_fixed("sys_pll2", 1000000000);
> diff --git a/drivers/clk/imx/clk-pll14xx.c b/drivers/clk/imx/clk-pll14xx.c
> index 5c458199060a..a6d31a7262ef 100644
> --- a/drivers/clk/imx/clk-pll14xx.c
> +++ b/drivers/clk/imx/clk-pll14xx.c
> @@ -65,10 +65,17 @@ struct imx_pll14xx_clk imx_1443x_pll = {
>  	.type = PLL_1443X,
>  	.rate_table = imx_pll1443x_tbl,
>  	.rate_count = ARRAY_SIZE(imx_pll1443x_tbl),
>  };
>  
> +struct imx_pll14xx_clk imx_1443x_dram_pll = {
> +	.type = PLL_1443X,
> +	.rate_table = imx_pll1443x_tbl,
> +	.rate_count = ARRAY_SIZE(imx_pll1443x_tbl),
> +	.flags = CLK_GET_RATE_NOCACHE,
> +};
> +
>  struct imx_pll14xx_clk imx_1416x_pll = {
>  	.type = PLL_1416X,
>  	.rate_table = imx_pll1416x_tbl,
>  	.rate_count = ARRAY_SIZE(imx_pll1416x_tbl),
>  };
> diff --git a/drivers/clk/imx/clk.h b/drivers/clk/imx/clk.h
> index bc5bb6ac8636..81122c9ab842 100644
> --- a/drivers/clk/imx/clk.h
> +++ b/drivers/clk/imx/clk.h
> @@ -50,10 +50,11 @@ struct imx_pll14xx_clk {
>  	int flags;
>  };
>  
>  extern struct imx_pll14xx_clk imx_1416x_pll;
>  extern struct imx_pll14xx_clk imx_1443x_pll;
> +extern struct imx_pll14xx_clk imx_1443x_dram_pll;
>  
>  #define imx_clk_cpu(name, parent_name, div, mux, pll, step) \
>  	imx_clk_hw_cpu(name, parent_name, div, mux, pll, step)->clk
>  
>  #define clk_register_gate2(dev, name, parent_name, flags, reg, bit_idx, \
> -- 
> 2.17.1
> 

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel