linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: Peng Fan <peng.fan@nxp.com>
To: bjorn.andersson@linaro.org, mathieu.poirier@linaro.org,
	o.rempel@pengutronix.de, robh+dt@kernel.org
Cc: devicetree@vger.kernel.org, Peng Fan <peng.fan@nxp.com>,
	festevam@gmail.com, s.hauer@pengutronix.de,
	linux-remoteproc@vger.kernel.org, linux-kernel@vger.kernel.org,
	linux-imx@nxp.com, kernel@pengutronix.de, shawnguo@kernel.org,
	linux-arm-kernel@lists.infradead.org
Subject: [PATCH 06/10] remoteproc: imx_rproc: add load hook
Date: Fri, 24 Jul 2020 16:08:09 +0800	[thread overview]
Message-ID: <20200724080813.24884-7-peng.fan@nxp.com> (raw)
In-Reply-To: <20200724080813.24884-1-peng.fan@nxp.com>

To i.MX8, we not able to see the correct data written into TCM when
using ioremap_wc, so use ioremap.

However common elf loader using memset.

To arm64, "dc      zva, dst" is used in memset.
Per ARM DDI 0487A.j, chapter C5.3.8 DC ZVA, Data Cache Zero by VA,

"If the memory region being zeroed is any type of Device memory,
this instruction can give an alignment fault which is prioritized
in the same way as other alignment faults that are determined
by the memory type."

On i.MX platforms, when elf is loaded to onchip TCM area, the region
is ioremapped, so "dc zva, dst" will trigger abort.

So add i.MX specific loader to address the TCM write issue.

The change not impact i.MX6/7 function.

Signed-off-by: Peng Fan <peng.fan@nxp.com>
---
 drivers/remoteproc/imx_rproc.c | 76 ++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 76 insertions(+)

diff --git a/drivers/remoteproc/imx_rproc.c b/drivers/remoteproc/imx_rproc.c
index aee790efbf7b..c23726091228 100644
--- a/drivers/remoteproc/imx_rproc.c
+++ b/drivers/remoteproc/imx_rproc.c
@@ -4,6 +4,7 @@
  */
 
 #include <linux/clk.h>
+#include <linux/elf.h>
 #include <linux/err.h>
 #include <linux/interrupt.h>
 #include <linux/kernel.h>
@@ -15,6 +16,9 @@
 #include <linux/regmap.h>
 #include <linux/remoteproc.h>
 
+#include "remoteproc_internal.h"
+#include "remoteproc_elf_helpers.h"
+
 #define IMX7D_SRC_SCR			0x0C
 #define IMX7D_ENABLE_M4			BIT(3)
 #define IMX7D_SW_M4P_RST		BIT(2)
@@ -247,10 +251,82 @@ static void *imx_rproc_da_to_va(struct rproc *rproc, u64 da, size_t len)
 	return va;
 }
 
+static int imx_rproc_elf_load_segments(struct rproc *rproc, const struct firmware *fw)
+{
+	struct device *dev = &rproc->dev;
+	const void *ehdr, *phdr;
+	int i, ret = 0;
+	u16 phnum;
+	const u8 *elf_data = fw->data;
+	u8 class = fw_elf_get_class(fw);
+	u32 elf_phdr_get_size = elf_size_of_phdr(class);
+
+	ehdr = elf_data;
+	phnum = elf_hdr_get_e_phnum(class, ehdr);
+	phdr = elf_data + elf_hdr_get_e_phoff(class, ehdr);
+
+	/* go through the available ELF segments */
+	for (i = 0; i < phnum; i++, phdr += elf_phdr_get_size) {
+		u64 da = elf_phdr_get_p_paddr(class, phdr);
+		u64 memsz = elf_phdr_get_p_memsz(class, phdr);
+		u64 filesz = elf_phdr_get_p_filesz(class, phdr);
+		u64 offset = elf_phdr_get_p_offset(class, phdr);
+		u32 type = elf_phdr_get_p_type(class, phdr);
+		void *ptr;
+
+		if (type != PT_LOAD)
+			continue;
+
+		dev_dbg(dev, "phdr: type %d da 0x%llx memsz 0x%llx filesz 0x%llx\n",
+			type, da, memsz, filesz);
+
+		if (filesz > memsz) {
+			dev_err(dev, "bad phdr filesz 0x%llx memsz 0x%llx\n",
+				filesz, memsz);
+			ret = -EINVAL;
+			break;
+		}
+
+		if (offset + filesz > fw->size) {
+			dev_err(dev, "truncated fw: need 0x%llx avail 0x%zx\n",
+				offset + filesz, fw->size);
+			ret = -EINVAL;
+			break;
+		}
+
+		if (!rproc_u64_fit_in_size_t(memsz)) {
+			dev_err(dev, "size (%llx) does not fit in size_t type\n",
+				memsz);
+			ret = -EOVERFLOW;
+			break;
+		}
+
+		/* grab the kernel address for this device address */
+		ptr = rproc_da_to_va(rproc, da, memsz);
+		if (!ptr) {
+			dev_err(dev, "bad phdr da 0x%llx mem 0x%llx\n", da,
+				memsz);
+			ret = -EINVAL;
+			break;
+		}
+
+		/* put the segment where the remote processor expects it */
+		if (filesz)
+			memcpy_toio(ptr, elf_data + offset, filesz);
+	}
+
+	return ret;
+}
+
 static const struct rproc_ops imx_rproc_ops = {
 	.start		= imx_rproc_start,
 	.stop		= imx_rproc_stop,
 	.da_to_va       = imx_rproc_da_to_va,
+	.load		= imx_rproc_elf_load_segments,
+	.parse_fw	= rproc_elf_load_rsc_table,
+	.find_loaded_rsc_table = rproc_elf_find_loaded_rsc_table,
+	.sanity_check	= rproc_elf_sanity_check,
+	.get_boot_addr	= rproc_elf_get_boot_addr,
 };
 
 static int imx_rproc_addr_init(struct imx_rproc *priv,
-- 
2.16.4


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply	other threads:[~2020-07-24  7:57 UTC|newest]

Thread overview: 38+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-07-24  8:08 [PATCH 00/10] remoteproc: imx_rproc: support iMX8M and early boot Peng Fan
2020-07-24  8:08 ` [PATCH 01/10] dt-bindings: remoteproc: imx_rproc: add i.MX8MQ/M Peng Fan
2020-07-31 20:14   ` Rob Herring
2020-07-24  8:08 ` [PATCH 02/10] remoteproc: imx_rproc: correct err message Peng Fan
2020-08-11 19:56   ` Mathieu Poirier
2020-07-24  8:08 ` [PATCH 03/10] remoteproc: imx: use devm_ioremap Peng Fan
2020-07-27  6:23   ` Oleksij Rempel
2020-07-27  6:28     ` Peng Fan
2020-07-27  6:41       ` Oleksij Rempel
2020-07-27  6:51         ` Peng Fan
2020-07-27  7:37           ` Oleksij Rempel
2020-07-27  8:11             ` Peng Fan
2020-07-28  7:20               ` Oleksij Rempel
2020-07-24  8:08 ` [PATCH 04/10] remoteproc: imx_rproc: make syscon optional Peng Fan
2020-08-11 22:40   ` Mathieu Poirier
2020-08-18 21:43   ` Mathieu Poirier
2020-08-19  0:51     ` Peng Fan
2020-08-19 19:45       ` Mathieu Poirier
2020-08-20  2:04         ` Peng Fan
2020-08-20 19:27           ` Mathieu Poirier
2020-07-24  8:08 ` [PATCH 05/10] remoteproc: imx_rproc: make clk optional Peng Fan
2020-07-24  8:08 ` Peng Fan [this message]
2020-07-27  5:20   ` [PATCH 06/10] remoteproc: imx_rproc: add load hook Oleksij Rempel
2020-08-11 21:40   ` Mathieu Poirier
2020-07-24  8:08 ` [PATCH 07/10] remoteproc: imx_rproc: add i.MX specific parse fw hook Peng Fan
2020-08-11 21:56   ` Mathieu Poirier
2020-07-24  8:08 ` [PATCH 08/10] remoteproc: imx_rproc: support i.MX8MQ/M Peng Fan
2020-07-24  8:08 ` [PATCH 09/10] remoteproc: imx_proc: enable virtio/mailbox Peng Fan
2020-07-24  8:08 ` [PATCH 10/10] remoteproc: imx_rproc: support coproc booting before Linux Peng Fan
2020-08-11 22:36   ` Mathieu Poirier
2020-07-27  6:38 ` [PATCH 00/10] remoteproc: imx_rproc: support iMX8M and early boot Oleksij Rempel
2020-07-27  6:44   ` Peng Fan
2020-07-27  7:54     ` Oleksij Rempel
2020-07-27  9:18       ` Peng Fan
2020-07-28  7:26         ` Oleksij Rempel
2020-07-28  7:50           ` Peng Fan
2020-07-28  7:55             ` Oleksij Rempel
2020-07-28  9:36               ` Peng Fan

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200724080813.24884-7-peng.fan@nxp.com \
    --to=peng.fan@nxp.com \
    --cc=bjorn.andersson@linaro.org \
    --cc=devicetree@vger.kernel.org \
    --cc=festevam@gmail.com \
    --cc=kernel@pengutronix.de \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-imx@nxp.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-remoteproc@vger.kernel.org \
    --cc=mathieu.poirier@linaro.org \
    --cc=o.rempel@pengutronix.de \
    --cc=robh+dt@kernel.org \
    --cc=s.hauer@pengutronix.de \
    --cc=shawnguo@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).