From: Rob Herring <robh@kernel.org>
To: Peter Griffin <peter.griffin@linaro.org>
Cc: krzysztof.kozlowski+dt@linaro.org, mturquette@baylibre.com,
conor+dt@kernel.org, sboyd@kernel.org, tomasz.figa@gmail.com,
s.nawrocki@samsung.com, linus.walleij@linaro.org,
wim@linux-watchdog.org, linux@roeck-us.net,
catalin.marinas@arm.com, will@kernel.org, arnd@arndb.de,
olof@lixom.net, cw00.choi@samsung.com, tudor.ambarus@linaro.org,
andre.draszik@linaro.org, semen.protsenko@linaro.org,
soc@kernel.org, devicetree@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-samsung-soc@vger.kernel.org, linux-clk@vger.kernel.org,
linux-gpio@vger.kernel.org, linux-watchdog@vger.kernel.org
Subject: Re: [PATCH 19/21] google/gs101: Add dt overlay for oriole board
Date: Fri, 6 Oct 2023 15:52:04 -0500 [thread overview]
Message-ID: <20231006205204.GA269353-robh@kernel.org> (raw)
In-Reply-To: <20231005155618.700312-20-peter.griffin@linaro.org>
On Thu, Oct 05, 2023 at 04:56:16PM +0100, Peter Griffin wrote:
> The LK bootloader on Pixel6 searches for a dt overlay in the
> dtbo partition with a board_id and board_rev that matches
> what is baked into the device. If this overlay is not present
> then the phone will bootloop in fastboot and you can't boot
> the upstream kernel.
>
> This commit adds a dtbo for the production oriole variant.
> The other pre-production board overlays are not included
> at this time.
>
> Adding the dtbo here allows for a better experience when
> building/booting the upstream kernel on Pixel devices
> as all the DT required to boot the device will be created
> as part of the kernel build process. Rather than having to
> fetch the dtbo from some other repo.
>
> Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
> ---
> arch/arm64/boot/dts/google/Makefile | 1 +
> arch/arm64/boot/dts/google/gs101-oriole.dtso | 21 ++++++++++++++++++++
> 2 files changed, 22 insertions(+)
> create mode 100644 arch/arm64/boot/dts/google/gs101-oriole.dtso
>
> diff --git a/arch/arm64/boot/dts/google/Makefile b/arch/arm64/boot/dts/google/Makefile
> index 6d2026a767d4..3f1761f8daa9 100644
> --- a/arch/arm64/boot/dts/google/Makefile
> +++ b/arch/arm64/boot/dts/google/Makefile
> @@ -2,5 +2,6 @@
>
> dtb-$(CONFIG_ARCH_GOOGLE_TENSOR) += \
> gs101-oriole.dtb \
> + gs101-oriole.dtbo
Overlays in the kernel must be able to be applied to a base DT in the
kernel. Add a rule to apply this (hint: a '-dtbs' variable does this
similar to -objs variables).
> diff --git a/arch/arm64/boot/dts/google/gs101-oriole.dtso b/arch/arm64/boot/dts/google/gs101-oriole.dtso
> new file mode 100644
> index 000000000000..50832fd94204
> --- /dev/null
> +++ b/arch/arm64/boot/dts/google/gs101-oriole.dtso
> @@ -0,0 +1,21 @@
> +// SPDX-License-Identifier: GPL-2.0-only
> +/*
> + * Oriole DVT Device Tree
Doesn't DVT mean pre-production?
Rob
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2023-10-06 20:52 UTC|newest]
Thread overview: 75+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-10-05 15:55 [PATCH 00/21] Add minimal Tensor/GS101 SoC support and Oriole/Pixel6 board Peter Griffin
2023-10-05 15:55 ` [PATCH 01/21] dt-bindings: interrupt-controller: Add gs101 interrupt controller Peter Griffin
2023-10-05 16:04 ` Krzysztof Kozlowski
2023-10-06 21:52 ` Linus Walleij
2023-10-05 15:55 ` [PATCH 02/21] dt-bindings: soc: samsung: exynos-pmu: Add gs101 compatible Peter Griffin
2023-10-05 16:05 ` Krzysztof Kozlowski
2023-10-05 15:56 ` [PATCH 03/21] dt-bindings: clock: Add Google gs101 clock management unit bindings Peter Griffin
2023-10-05 16:06 ` Krzysztof Kozlowski
2023-10-05 15:56 ` [PATCH 04/21] dt-bindings: soc: google: exynos-sysreg: add dedicated SYSREG compatibles to GS101 Peter Griffin
2023-10-05 16:07 ` Krzysztof Kozlowski
2023-10-06 12:41 ` Peter Griffin
2023-10-06 12:43 ` Krzysztof Kozlowski
2023-10-05 15:56 ` [PATCH 05/21] dt-bindings: watchdog: Document Google gs101 & gs201 watchdog bindings Peter Griffin
2023-10-05 16:08 ` Krzysztof Kozlowski
2023-10-05 17:37 ` William McVicker
2023-10-05 15:56 ` [PATCH 06/21] dt-bindings: arm: google: Add bindings for Google ARM platforms Peter Griffin
2023-10-06 20:44 ` Rob Herring
2023-10-05 15:56 ` [PATCH 07/21] dt-bindings: pinctrl: samsung: add google,gs101-pinctrl compatible Peter Griffin
2023-10-05 16:10 ` Krzysztof Kozlowski
2023-10-05 15:56 ` [PATCH 08/21] dt-bindings: pinctrl: samsung: add gs101-wakeup-eint compatible Peter Griffin
2023-10-05 16:10 ` Krzysztof Kozlowski
2023-10-05 15:56 ` [PATCH 09/21] dt-bindings: clock: gs101: Add cmu_top clock indices Peter Griffin
2023-10-05 16:11 ` Krzysztof Kozlowski
2023-10-08 22:48 ` Chanwoo Choi
2023-10-05 15:56 ` [PATCH 10/21] dt-bindings: clock: gs101: Add cmu_apm " Peter Griffin
2023-10-05 16:11 ` Krzysztof Kozlowski
2023-10-05 15:56 ` [PATCH 11/21] dt-bindings: clock: gs101: Add cmu_misc " Peter Griffin
2023-10-05 15:56 ` [PATCH 12/21] clk: samsung: clk-pll: Add support for pll_{0516,0517,518} Peter Griffin
2023-10-05 17:39 ` William McVicker
2023-10-08 22:51 ` Chanwoo Choi
2023-10-05 15:56 ` [PATCH 13/21] clk: samsung: clk-gs101: Add cmu_top registers, plls, mux and gates Peter Griffin
2023-10-05 17:42 ` William McVicker
2023-10-05 17:45 ` Krzysztof Kozlowski
2023-10-06 4:16 ` kernel test robot
2023-10-14 6:37 ` kernel test robot
2023-10-05 15:56 ` [PATCH 14/21] clk: samsung: clk-gs101: add CMU_APM support Peter Griffin
2023-10-05 17:43 ` William McVicker
2023-10-05 17:45 ` William McVicker
2023-10-05 15:56 ` [PATCH 15/21] clk: google: gs101: Add support for CMU_MISC clock unit Peter Griffin
2023-10-06 5:20 ` kernel test robot
2023-10-05 15:56 ` [PATCH 16/21] pinctrl: samsung: Add gs101 SoC pinctrl configuration Peter Griffin
2023-10-06 6:33 ` Krzysztof Kozlowski
2023-10-09 7:49 ` Peter Griffin
2023-10-05 15:56 ` [PATCH 17/21] watchdog: s3c2410_wdt: Add support for Google tensor SoCs Peter Griffin
2023-10-05 18:58 ` Guenter Roeck
2023-10-09 11:56 ` Peter Griffin
2023-10-05 15:56 ` [PATCH 18/21] arm64: dts: google: Add initial Google gs101 SoC support Peter Griffin
2023-10-05 16:21 ` Krzysztof Kozlowski
2023-10-05 17:59 ` William McVicker
2023-10-05 18:05 ` Greg KH
2023-10-05 19:18 ` Krzysztof Kozlowski
2023-10-05 19:23 ` Greg KH
2023-10-05 19:29 ` Krzysztof Kozlowski
2023-10-05 23:19 ` William McVicker
2023-10-06 6:06 ` Krzysztof Kozlowski
2023-10-06 8:48 ` Arnd Bergmann
2023-10-06 16:33 ` William McVicker
2023-10-07 14:34 ` Krzysztof Kozlowski
2023-10-09 16:10 ` William McVicker
2023-10-05 19:21 ` Krzysztof Kozlowski
2023-10-05 19:22 ` Krzysztof Kozlowski
2023-10-05 19:26 ` William McVicker
2023-10-09 12:01 ` Tudor Ambarus
2023-10-05 15:56 ` [PATCH 19/21] google/gs101: Add dt overlay for oriole board Peter Griffin
2023-10-05 16:33 ` Krzysztof Kozlowski
2023-10-09 20:03 ` William McVicker
2023-10-06 7:08 ` Geert Uytterhoeven
2023-10-06 20:52 ` Rob Herring [this message]
2023-10-10 12:09 ` Peter Griffin
2023-10-05 15:56 ` [PATCH 20/21] arm64: defconfig: Enable Google Tensor SoC Peter Griffin
2023-10-05 15:56 ` [PATCH 21/21] MAINTAINERS: add entry for " Peter Griffin
2023-10-05 16:32 ` [PATCH 00/21] Add minimal Tensor/GS101 SoC support and Oriole/Pixel6 board Krzysztof Kozlowski
2023-10-09 11:39 ` Peter Griffin
2023-10-09 11:10 ` Krzysztof Kozlowski
2023-10-09 11:40 ` Peter Griffin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20231006205204.GA269353-robh@kernel.org \
--to=robh@kernel.org \
--cc=andre.draszik@linaro.org \
--cc=arnd@arndb.de \
--cc=catalin.marinas@arm.com \
--cc=conor+dt@kernel.org \
--cc=cw00.choi@samsung.com \
--cc=devicetree@vger.kernel.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-samsung-soc@vger.kernel.org \
--cc=linux-watchdog@vger.kernel.org \
--cc=linux@roeck-us.net \
--cc=mturquette@baylibre.com \
--cc=olof@lixom.net \
--cc=peter.griffin@linaro.org \
--cc=s.nawrocki@samsung.com \
--cc=sboyd@kernel.org \
--cc=semen.protsenko@linaro.org \
--cc=soc@kernel.org \
--cc=tomasz.figa@gmail.com \
--cc=tudor.ambarus@linaro.org \
--cc=will@kernel.org \
--cc=wim@linux-watchdog.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).