From: Niklas Cassel <niklas.cassel@linaro.org> To: Andy Gross <agross@kernel.org>, Ilia Lin <ilia.lin@kernel.org>, Viresh Kumar <vireshk@kernel.org>, Nishanth Menon <nm@ti.com>, Stephen Boyd <sboyd@kernel.org> Cc: linux-arm-msm@vger.kernel.org, jorge.ramirez-ortiz@linaro.org, bjorn.andersson@linaro.org, ulf.hansson@linaro.org, Niklas Cassel <niklas.cassel@linaro.org>, Rob Herring <robh@kernel.org>, Rob Herring <robh+dt@kernel.org>, Mark Rutland <mark.rutland@arm.com>, linux-pm@vger.kernel.org, devicetree@vger.kernel.org, linux-kernel@vger.kernel.org Subject: [PATCH v2 04/14] dt-bindings: cpufreq: qcom-nvmem: Make speedbin related properties optional Date: Thu, 25 Jul 2019 12:41:32 +0200 Message-ID: <20190725104144.22924-5-niklas.cassel@linaro.org> (raw) In-Reply-To: <20190725104144.22924-1-niklas.cassel@linaro.org> Not all Qualcomm platforms need to care about the speedbin efuse, nor the value blown into the speedbin efuse. Therefore, make the nvmem-cells and opp-supported-hw properties optional. Signed-off-by: Niklas Cassel <niklas.cassel@linaro.org> Reviewed-by: Ilia Lin <ilia.lin@kernel.org> Reviewed-by: Rob Herring <robh@kernel.org> --- Changes since V1: -Picked up tags. Documentation/devicetree/bindings/opp/qcom-nvmem-cpufreq.txt | 4 ++++ 1 file changed, 4 insertions(+) diff --git a/Documentation/devicetree/bindings/opp/qcom-nvmem-cpufreq.txt b/Documentation/devicetree/bindings/opp/qcom-nvmem-cpufreq.txt index 198441e80ba8..c5ea8b90e35d 100644 --- a/Documentation/devicetree/bindings/opp/qcom-nvmem-cpufreq.txt +++ b/Documentation/devicetree/bindings/opp/qcom-nvmem-cpufreq.txt @@ -20,6 +20,10 @@ In 'cpus' nodes: In 'operating-points-v2' table: - compatible: Should be - 'operating-points-v2-kryo-cpu' for apq8096 and msm8996. + +Optional properties: +-------------------- +In 'operating-points-v2' table: - nvmem-cells: A phandle pointing to a nvmem-cells node representing the efuse registers that has information about the speedbin that is used to select the right frequency/voltage -- 2.21.0
next prev parent reply index Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top 2019-07-25 10:41 [PATCH v2 00/14] Add support for QCOM Core Power Reduction Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 01/14] opp: Add dev_pm_opp_find_level_exact() Niklas Cassel 2019-07-26 8:03 ` Viresh Kumar 2019-07-25 10:41 ` [PATCH v2 02/14] dt-bindings: cpufreq: Re-organise kryo cpufreq to use it for other nvmem based qcom socs Niklas Cassel 2019-07-26 8:04 ` Viresh Kumar 2019-07-25 10:41 ` [PATCH v2 03/14] cpufreq: qcom: " Niklas Cassel 2019-08-18 1:06 ` Stephen Boyd 2019-07-25 10:41 ` Niklas Cassel [this message] 2019-07-25 10:41 ` [PATCH v2 05/14] cpufreq: qcom: Refactor the driver to make it easier to extend Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 06/14] dt-bindings: cpufreq: qcom-nvmem: Support pstates provided by a power domain Niklas Cassel 2019-08-16 21:21 ` Rob Herring 2019-08-19 10:09 ` [PATCH v3 " Niklas Cassel 2019-08-19 17:59 ` Stephen Boyd 2019-08-22 10:27 ` Niklas Cassel 2019-08-28 17:52 ` Stephen Boyd 2019-08-30 10:29 ` [PATCH v4 06/14] dt-bindings: opp: " Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 07/14] cpufreq: qcom: Add support for qcs404 on nvmem driver Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 08/14] cpufreq: Add qcs404 to cpufreq-dt-platdev blacklist Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 09/14] dt-bindings: opp: Add qcom-opp bindings with properties needed for CPR Niklas Cassel 2019-08-19 10:12 ` [PATCH v3 " Niklas Cassel 2019-08-19 17:58 ` Stephen Boyd 2019-08-23 12:34 ` Rob Herring 2019-07-25 10:41 ` [PATCH v2 10/14] dt-bindings: power: avs: Add support for CPR (Core Power Reduction) Niklas Cassel 2019-08-17 6:14 ` Stephen Boyd 2019-08-22 10:20 ` Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 11/14] " Niklas Cassel 2019-08-18 1:04 ` Stephen Boyd 2019-11-15 12:20 ` Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 12/14] arm64: dts: qcom: qcs404: Add CPR and populate OPP table Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 13/14] arm64: defconfig: enable CONFIG_QCOM_CPR Niklas Cassel 2019-07-25 10:41 ` [PATCH v2 14/14] arm64: defconfig: enable CONFIG_ARM_QCOM_CPUFREQ_NVMEM Niklas Cassel 2019-07-26 8:08 ` [PATCH v2 00/14] Add support for QCOM Core Power Reduction Viresh Kumar
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20190725104144.22924-5-niklas.cassel@linaro.org \ --to=niklas.cassel@linaro.org \ --cc=agross@kernel.org \ --cc=bjorn.andersson@linaro.org \ --cc=devicetree@vger.kernel.org \ --cc=ilia.lin@kernel.org \ --cc=jorge.ramirez-ortiz@linaro.org \ --cc=linux-arm-msm@vger.kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-pm@vger.kernel.org \ --cc=mark.rutland@arm.com \ --cc=nm@ti.com \ --cc=robh+dt@kernel.org \ --cc=robh@kernel.org \ --cc=sboyd@kernel.org \ --cc=ulf.hansson@linaro.org \ --cc=vireshk@kernel.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: link
Linux-ARM-MSM Archive on lore.kernel.org Archives are clonable: git clone --mirror https://lore.kernel.org/linux-arm-msm/0 linux-arm-msm/git/0.git # If you have public-inbox 1.1+ installed, you may # initialize and index your mirror using the following commands: public-inbox-init -V2 linux-arm-msm linux-arm-msm/ https://lore.kernel.org/linux-arm-msm \ linux-arm-msm@vger.kernel.org public-inbox-index linux-arm-msm Example config snippet for mirrors Newsgroup available over NNTP: nntp://nntp.lore.kernel.org/org.kernel.vger.linux-arm-msm AGPL code for this site: git clone https://public-inbox.org/public-inbox.git