From: Lina Iyer <ilina@codeaurora.org>
To: Linus Walleij <linus.walleij@linaro.org>
Cc: Stephen Boyd <swboyd@chromium.org>,
Evan Green <evgreen@chromium.org>,
Marc Zyngier <marc.zyngier@arm.com>,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
MSM <linux-arm-msm@vger.kernel.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
mkshah@codeaurora.org,
"open list:GPIO SUBSYSTEM" <linux-gpio@vger.kernel.org>,
Rajendra Nayak <rnayak@codeaurora.org>
Subject: Re: [PATCH RFC 09/14] drivers: pinctrl: msm: fix use of deprecated gpiolib APIs
Date: Wed, 11 Sep 2019 10:16:46 -0600 [thread overview]
Message-ID: <20190911161646.GC30053@codeaurora.org> (raw)
In-Reply-To: <CACRpkdbhNY8N=LMG6wwYw9bAnL4HmAqj8WMpsLsqvh8PvaQ52A@mail.gmail.com>
On Wed, Sep 11 2019 at 04:19 -0600, Linus Walleij wrote:
>On Thu, Aug 29, 2019 at 7:35 PM Lina Iyer <ilina@codeaurora.org> wrote:
>
>> Replace gpiochip_irqchip_add() and gpiochip_set_chained_irqchip() calls
>> by populating the gpio_irq_chip data structures instead.
>>
>> Signed-off-by: Lina Iyer <ilina@codeaurora.org>
>
>This is mostly fixed upstream I think, but:
>
>> + chip->irq.fwnode = pctrl->dev->fwnode;
>
>This fwnode assignment is missing though.
>
>Sorry for the constant churn and required rebasing...
>
Not a problem. Will rebase.
next prev parent reply other threads:[~2019-09-11 16:16 UTC|newest]
Thread overview: 41+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-08-29 18:11 [PATCH RFC 00/14] qcom: support wakeup capable GPIOs Lina Iyer
2019-08-29 18:11 ` [PATCH RFC 01/14] irqdomain: add bus token DOMAIN_BUS_WAKEUP Lina Iyer
2019-08-29 18:11 ` [PATCH RFC 02/14] drivers: irqchip: pdc: Do not toggle IRQ_ENABLE during mask/unmask Lina Iyer
2019-09-06 0:39 ` Stephen Boyd
2019-09-11 16:15 ` Lina Iyer
2019-09-20 22:22 ` Stephen Boyd
2019-09-20 22:31 ` Lina Iyer
2019-08-29 18:11 ` [PATCH RFC 03/14] drivers: irqchip: add PDC irqdomain for wakeup capable GPIOs Lina Iyer
2019-08-30 14:50 ` Marc Zyngier
2019-08-30 15:58 ` Lina Iyer
2019-09-02 8:21 ` Marc Zyngier
2019-09-03 22:51 ` Stephen Boyd
2019-08-29 18:11 ` [PATCH RFC 04/14] of: irq: document properties for wakeup interrupt parent Lina Iyer
2019-09-02 13:38 ` Rob Herring
2019-08-29 18:11 ` [PATCH RFC 05/14] dt-bindings/interrupt-controller: pdc: add SPI config register Lina Iyer
2019-09-02 13:38 ` Rob Herring
2019-09-02 13:53 ` Marc Zyngier
2019-09-03 17:07 ` Lina Iyer
2019-09-06 0:03 ` Stephen Boyd
2019-09-13 19:53 ` Lina Iyer
2019-09-17 21:50 ` Lina Iyer
2019-09-20 22:20 ` Stephen Boyd
2019-09-23 6:11 ` Sibi Sankar
[not found] ` <CACRpkdaReFzjb_hcDbQwqMX+whzscLpeZpJPHKqOo+9tANzemA@mail.gmail.com>
2019-09-11 15:19 ` Lina Iyer
2019-08-29 18:11 ` [PATCH RFC 06/14] drivers: irqchip: pdc: additionally set type in SPI config registers Lina Iyer
2019-09-06 0:22 ` Stephen Boyd
2019-08-29 18:11 ` [PATCH RFC 07/14] genirq: Introduce irq_chip_get/set_parent_state calls Lina Iyer
2019-09-06 0:35 ` Stephen Boyd
2019-08-29 18:11 ` [PATCH RFC 08/14] drivers: irqchip: pdc: Add irqchip set/get state calls Lina Iyer
2019-09-06 0:09 ` Stephen Boyd
2019-08-29 18:11 ` [PATCH RFC 09/14] drivers: pinctrl: msm: fix use of deprecated gpiolib APIs Lina Iyer
2019-09-06 0:11 ` Stephen Boyd
2019-09-11 10:19 ` Linus Walleij
2019-09-11 16:16 ` Lina Iyer [this message]
2019-08-29 18:11 ` [PATCH RFC 10/14] drivers: pinctrl: msm: setup GPIO chip in hierarchy Lina Iyer
2019-08-29 18:12 ` [PATCH RFC 11/14] drivers: pinctrl: sdm845: add PDC wakeup interrupt map for GPIOs Lina Iyer
2019-09-06 0:24 ` Stephen Boyd
2019-08-29 18:12 ` [PATCH RFC 12/14] arm64: dts: qcom: add PDC interrupt controller for SDM845 Lina Iyer
2019-09-09 11:26 ` Maulik Shah
2019-08-29 18:12 ` [PATCH RFC 13/14] arm64: dts: qcom: setup PDC as the wakeup parent for TLMM on SDM845 Lina Iyer
2019-08-29 18:12 ` [PATCH RFC 14/14] arm64: defconfig: enable PDC interrupt controller for Qualcomm SDM845 Lina Iyer
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190911161646.GC30053@codeaurora.org \
--to=ilina@codeaurora.org \
--cc=bjorn.andersson@linaro.org \
--cc=evgreen@chromium.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=marc.zyngier@arm.com \
--cc=mkshah@codeaurora.org \
--cc=rnayak@codeaurora.org \
--cc=swboyd@chromium.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).