Re: [PATCH] cpufreq: Add Kryo CPU scaling driver

[Sudeep Holla <sudeep.holla@arm.com>]

On Tue, May 22, 2018 at 02:29:45PM +0300, Ilia Lin wrote:
> In Certain QCOM SoCs like apq8096 and msm8996 that have KRYO processors,
> the CPU frequency subset and voltage value of each OPP varies
> based on the silicon variant in use. Qualcomm Process Voltage Scaling Tables
> defines the voltage and frequency value based on the msm-id in SMEM
> and speedbin blown in the efuse combination.
> The qcom-cpufreq-kryo driver reads the msm-id and efuse value from the SoC
> to provide the OPP framework with required information.
> This is used to determine the voltage and frequency value for each OPP of
> operating-points-v2 table when it is parsed by the OPP framework.
> 
> Signed-off-by: Ilia Lin <ilialin@codeaurora.org>
> Acked-by: Viresh Kumar <viresh.kumar@linaro.org>

[...]

> +
> +	switch (msm8996_version) {
> +	case MSM8996_V3:
> +		versions = 1 << (unsigned int)(*speedbin);
> +		break;
> +	case MSM8996_SG:
> +		versions = 1 << ((unsigned int)(*speedbin) + 4);
> +		break;
> +	default:
> +		BUG();
> +		break;
> +	}
> +
> +	for_each_possible_cpu(cpu) {
> +		cpu_dev = get_cpu_device(cpu);
> +		if (NULL == cpu_dev) {
> +			ret = -ENODEV;
> +			goto free_opp;
> +		}
> +
> +		opp_tables[cpu] = dev_pm_opp_set_supported_hw(cpu_dev,
> +							      &versions, 1);

Will be not get NULL for all CPUs except 0 ?
I haven't seen the patches from Viresh yet, if that prevents getting NULL
or not.

--
Regards,
Sudeep