From: Sricharan R <sricharan@codeaurora.org>
To: Abhishek Sahu <absahu@codeaurora.org>
Cc: mark.rutland@arm.com, robh@kernel.org, sboyd@codeaurora.org,
linux-kernel@vger.kernel.org, devicetree@vger.kernel.org,
catalin.marinas@arm.com, will.deacon@arm.com,
linux@armlinux.org.uk, bjorn.andersson@linaro.org,
david.brown@linaro.org, robh+dt@kernel.org,
linux-arm-msm@vger.kernel.org, andy.gross@linaro.org,
linux-soc@vger.kernel.org, linux-arm-msm-owner@vger.kernel.org,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH 05/15] ARM: dts: ipq4019: Add ipq4019-ap-dk01-c2 board file
Date: Tue, 6 Feb 2018 11:25:43 +0530 [thread overview]
Message-ID: <508a5777-a009-15d9-6d5a-bed1b1bfa1e7@codeaurora.org> (raw)
In-Reply-To: <9afb20e560a7ebbcefcb801e7447a983@codeaurora.org>
Hi Abhishek,
On 2/3/2018 4:25 PM, Abhishek Sahu wrote:
> On 2018-01-29 10:41, Sricharan R wrote:
>> The board has a spi-nand interface on spi0 bus chipselect1.
>>
>> Signed-off-by: Sricharan R <sricharan@codeaurora.org>
>> ---
>> arch/arm/boot/dts/Makefile | 1 +
>> arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1-c2.dts | 25
>> +++++++++++++++++++++++++
>> 2 files changed, 26 insertions(+)
>> create mode 100644 arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1-c2.dts
>>
>> diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
>> index d0381e9..21ed56d 100644
>> --- a/arch/arm/boot/dts/Makefile
>> +++ b/arch/arm/boot/dts/Makefile
>> @@ -724,6 +724,7 @@ dtb-$(CONFIG_ARCH_QCOM) += \
>> qcom-apq8084-ifc6540.dtb \
>> qcom-apq8084-mtp.dtb \
>> qcom-ipq4019-ap.dk01.1-c1.dtb \
>> + qcom-ipq4019-ap.dk01.1-c2.dtb \
>> qcom-ipq8064-ap148.dtb \
>> qcom-msm8660-surf.dtb \
>> qcom-msm8960-cdp.dtb \
>> diff --git a/arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1-c2.dts
>> b/arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1-c2.dts
>> new file mode 100644
>> index 0000000..e3442da
>> --- /dev/null
>> +++ b/arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1-c2.dts
>> @@ -0,0 +1,25 @@
>> +// SPDX-License-Identifier: GPL-2.0
>> +// Copyright (c) 2017, The Linux Foundation. All rights reserved.
>> +
>> +#include "qcom-ipq4019-ap.dk01.1.dtsi"
>> +
>> +/ {
>> + model = "Qualcomm Technologies, Inc. IPQ40xx/AP-DK01.1-C2";
>
> s/IPQ40xx/IPQ4019
>
ok
>> +
>> + soc {
>> + spi_0: spi@78b5000 { /* BLSP1 QUP1 */
>> + status = "ok";
>> + cs-gpios = <&tlmm 54 0>, <&tlmm 59 0>;
>
> the base dk01 file has pinmux for 54 only.
> for 59 pin, we need to add pinmux entry also.
>
ok. btw, infact think that 59 should be removed.
Regards,
Sricharan
--
"QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2018-02-06 5:55 UTC|newest]
Thread overview: 30+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-01-29 5:11 [PATCH 00/15] ARM: dts: ipq: updates to enable a few peripherals Sricharan R
2018-01-29 5:11 ` [PATCH 01/15] firmware: qcom: scm: Add ipq4019 soc compatible Sricharan R
2018-02-05 6:07 ` Rob Herring
2018-02-06 4:46 ` Sricharan R
2018-01-29 5:11 ` [PATCH 02/15] ARM: dts: ipq4019: Add a few peripheral nodes Sricharan R
2018-01-29 5:11 ` [PATCH 03/15] ARM: dts: ipq4019: Change the max opp frequency Sricharan R
2018-01-29 5:11 ` [PATCH 04/15] ARM: dts: ipq4019: Update ipq4019-dk01.1 board data Sricharan R
2018-01-29 5:11 ` [PATCH 05/15] ARM: dts: ipq4019: Add ipq4019-ap-dk01-c2 board file Sricharan R
[not found] ` <1517202689-14212-6-git-send-email-sricharan-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-03 10:55 ` Abhishek Sahu
2018-02-06 5:55 ` Sricharan R [this message]
2018-01-29 5:11 ` [PATCH 06/15] ARM: dts: ipq4019: Add ipq4019-ap.dk04.dtsi Sricharan R
[not found] ` <1517202689-14212-7-git-send-email-sricharan-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-03 11:17 ` Abhishek Sahu
2018-02-06 6:01 ` Sricharan R
2018-01-29 5:11 ` [PATCH 07/15] ARM: dts: ipq4019: Add ipq4019-ap.dk04.1-c1 board file Sricharan R
[not found] ` <1517202689-14212-8-git-send-email-sricharan-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-03 11:30 ` Abhishek Sahu
[not found] ` <6821d93c282c8337b2a58c5c9337a008-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-06 6:18 ` Sricharan R
[not found] ` <1517202689-14212-1-git-send-email-sricharan-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-01-29 5:11 ` [PATCH 08/15] ARM: dts: ipq4019: Add qcom-ipq4019-ap.dk04.1-c5 " Sricharan R
[not found] ` <1517202689-14212-9-git-send-email-sricharan-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-03 11:33 ` Abhishek Sahu
2018-01-29 5:11 ` [PATCH 09/15] ARM: dts: ipq4019: Add qcom-ipq4019-ap.dk04.1-c3 " Sricharan R
2018-02-03 11:37 ` Abhishek Sahu
[not found] ` <4a173ff2a74ed7d1555d52674cf64ddd-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-06 6:27 ` Sricharan R
2018-01-29 5:11 ` [PATCH 10/15] ARM: dts: ipq4019: Add ipq4019-ap.dk07.1 common data Sricharan R
2018-01-29 5:11 ` [PATCH 11/15] ARM: dts: ipq4019: Add qcom-ipq4019-ap.dk07.1-c1 board file Sricharan R
2018-01-29 5:11 ` [PATCH 12/15] ARM: dts: ipq4019: Add qcom-ipq4019-ap.dk07.1-c2 " Sricharan R
2018-02-03 12:13 ` Abhishek Sahu
[not found] ` <033a420e14f090258e4c8f14b7ba89a7-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2018-02-07 4:00 ` Sricharan R
2018-01-29 5:11 ` [PATCH 13/15] ARM: dts: ipq8074: Add peripheral nodes Sricharan R
2018-01-29 5:11 ` [PATCH 14/15] ARM: dts: ipq8074: Add pcie nodes Sricharan R
2018-02-01 0:51 ` kbuild test robot
2018-01-29 5:11 ` [PATCH 15/15] ARM: dts: ipq8074: Enable few peripherals for hk01 board Sricharan R
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=508a5777-a009-15d9-6d5a-bed1b1bfa1e7@codeaurora.org \
--to=sricharan@codeaurora.org \
--cc=absahu@codeaurora.org \
--cc=andy.gross@linaro.org \
--cc=bjorn.andersson@linaro.org \
--cc=catalin.marinas@arm.com \
--cc=david.brown@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm-owner@vger.kernel.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-soc@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=mark.rutland@arm.com \
--cc=robh+dt@kernel.org \
--cc=robh@kernel.org \
--cc=sboyd@codeaurora.org \
--cc=will.deacon@arm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).