[PATCH v1 0/8] pinctrl: intel: Move Lynxpoint to pin control umbrella

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

Intel Lynxpoint GPIO is actually half way to the Chassis specification that has
been established starting from Intel Skylake. It has some pin control
properties we may utilize. To achieve this, move the driver under pin control
umbrella and do a bunch of clean ups.

This is the first step. Next step will be to convert it to the actual pin
control driver.

The series has been tested on Harrisbeach Ultrabook where Lynxpoint GPIO is
exposed to the OS.

Andy Shevchenko (8):
  pinctrl: lynxpoint: Move GPIO driver to pin controller folder
  pinctrl: lynxpoint: Use raw_spinlock for locking
  pinctrl: lynxpoint: Correct amount of pins
  pinctrl: lynxpoint: Keep pointer to struct device instead of its
    container
  pinctrl: lynxpoint: Use %pR to print IO resource
  pinctrl: lynxpoint: Switch to memory mapped IO accessors
  pinctrl: lynxpoint: Convert unsigned to unsigned int
  pinctrl: lynxpoint: Move ->remove closer to ->probe()

 MAINTAINERS                                   |   1 -
 drivers/gpio/Kconfig                          |   8 -
 drivers/gpio/Makefile                         |   1 -
 drivers/pinctrl/intel/Kconfig                 |  10 ++
 drivers/pinctrl/intel/Makefile                |   1 +
 .../intel/pinctrl-lynxpoint.c}                | 168 +++++++++---------
 6 files changed, 93 insertions(+), 96 deletions(-)
 rename drivers/{gpio/gpio-lynxpoint.c => pinctrl/intel/pinctrl-lynxpoint.c} (72%)

-- 
2.24.0.rc1