Re: [PATCH v2 2/2] gpio: bcm-kona: use platform_irq_count

["Uwe Kleine-König" <u.kleine-koenig@pengutronix.de>]

On Wed, Dec 04, 2019 at 04:20:45AM +0000, Peng Fan wrote:
> From: Peng Fan <peng.fan@nxp.com>
> 
> platform_irq_count() is the more generic way (independent of
> device trees) to determine the count of available interrupts. So
> use this instead.
> 
> As platform_irq_count() might return an error code (which
> of_irq_count doesn't) some additional handling is necessary.
> 
> Signed-off-by: Peng Fan <peng.fan@nxp.com>
> ---
> 
> V2:
>  Update commit log, and add err handling
>  Not tested, just code inspection
> 
>  drivers/gpio/gpio-bcm-kona.c | 12 +++++++++---
>  1 file changed, 9 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/gpio/gpio-bcm-kona.c b/drivers/gpio/gpio-bcm-kona.c
> index 4122683eb1f9..52ff56166263 100644
> --- a/drivers/gpio/gpio-bcm-kona.c
> +++ b/drivers/gpio/gpio-bcm-kona.c
> @@ -19,7 +19,6 @@
>  #include <linux/io.h>
>  #include <linux/gpio/driver.h>
>  #include <linux/of_device.h>
> -#include <linux/of_irq.h>
>  #include <linux/init.h>
>  #include <linux/irqdomain.h>
>  #include <linux/irqchip/chained_irq.h>
> @@ -586,11 +585,18 @@ static int bcm_kona_gpio_probe(struct platform_device *pdev)
>  
>  	kona_gpio->gpio_chip = template_chip;
>  	chip = &kona_gpio->gpio_chip;
> -	kona_gpio->num_bank = of_irq_count(dev->of_node);
> -	if (kona_gpio->num_bank == 0) {
> +	ret = platform_irq_count(pdev);
> +	if (!ret) {
>  		dev_err(dev, "Couldn't determine # GPIO banks\n");
>  		return -ENOENT;
> +	} else if (ret < 0) {
> +		if (ret != -EPROBE_DEFER)
> +			dev_err(dev, "Couldn't determine GPIO banks: %d\n",
> +				ret);

You can use the new %pe feature here:

	dev_err(dev, "Couldn't determine GPIO banks: %pe\n",
		ERR_PTR(ret));

> +		return ret;
>  	}
> +	kona_gpio->num_bank = ret;
> +

Looks otherwise ok.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | https://www.pengutronix.de/ |