Re: [PATCH v3 18/30] iio: adc: sun4i-gpadc-iio: rework: support multiple sensors

[Philipp Rossak <embed3d@gmail.com>]

On 02.09.2018 22:11, Jonathan Cameron wrote:
> This feels like a good place to factor out the code into a utility
> function that just does one of them.  That should hopefully
> reduce the indenting etc enough to make the code easier to read.
> 
>> +		info->tzds[i].info = info;
>> +		info->tzds[i].sensor_id = i;
>> +
>> +		info->tzds[i].tzd = thermal_zone_of_sensor_register(
>> +				info->sensor_device,
>> +				i, &info->tzds[i], &sun4i_ts_tz_ops);
>> +		/*
>> +		 * Do not fail driver probing when failing to register in
>> +		 * thermal because no thermal DT node is found.
>> +		 */
>> +		if (IS_ERR(info->tzds[i].tzd) && \
>> +				PTR_ERR(info->tzds[i].tzd) != -ENODEV) {
>> +			dev_err(&pdev->dev,
>> +				"could not register thermal sensor: %ld\n",
>> +				PTR_ERR(info->tzds[i].tzd));
>> +			return PTR_ERR(info->tzds[i].tzd);
>> +		}

So this code above should be placed in a separate function and called by 
the for loop?
Did I understand that right?

Philipp