From: Vignesh Raghavendra <vigneshr@ti.com>
To: Pratyush Yadav <p.yadav@ti.com>,
Tudor Ambarus <tudor.ambarus@microchip.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Richard Weinberger <richard@nod.at>,
<linux-mtd@lists.infradead.org>, <linux-kernel@vger.kernel.org>
Cc: Boris Brezillon <boris.brezillon@collabora.com>,
Sekhar Nori <nsekhar@ti.com>
Subject: Re: [PATCH v16 14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash
Date: Sat, 7 Nov 2020 13:28:58 +0530 [thread overview]
Message-ID: <7d058da8-90ef-8f71-fe86-cc0b27a2895a@ti.com> (raw)
In-Reply-To: <20201005153138.6437-15-p.yadav@ti.com>
Hi,
[...]
On 10/5/20 9:01 PM, Pratyush Yadav wrote:
> +static int spi_nor_cypress_octal_dtr_enable(struct spi_nor *nor, bool enable)
> +{
> + struct spi_mem_op op;
> + u8 *buf = nor->bouncebuf;
> + int ret;
> +
> + if (enable) {
> + /* Use 24 dummy cycles for memory array reads. */
> + ret = spi_nor_write_enable(nor);
> + if (ret)
> + return ret;
> +
> + *buf = SPINOR_REG_CYPRESS_CFR2V_MEMLAT_11_24;
> + op = (struct spi_mem_op)
> + SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WR_ANY_REG, 1),
> + SPI_MEM_OP_ADDR(3, SPINOR_REG_CYPRESS_CFR2V,
> + 1),
> + SPI_MEM_OP_NO_DUMMY,
> + SPI_MEM_OP_DATA_OUT(1, buf, 1));
> +
> + ret = spi_mem_exec_op(nor->spimem, &op);
> + if (ret)
> + return ret;
> +
> + ret = spi_nor_wait_till_ready(nor);
> + if (ret)
> + return ret;
> +
> + nor->read_dummy = 24;
> + }
> +
> + /* Set/unset the octal and DTR enable bits. */
> + ret = spi_nor_write_enable(nor);
> + if (ret)
> + return ret;
> +
> + if (enable)
> + *buf = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_EN;
> + else
> + *buf = SPINOR_REG_CYPRESS_CFR5V_OCT_DTR_DS;
> +
> + op = (struct spi_mem_op)
> + SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WR_ANY_REG, 1),
> + SPI_MEM_OP_ADDR(enable ? 3 : 4,
> + SPINOR_REG_CYPRESS_CFR5V,
> + 1),
> + SPI_MEM_OP_NO_DUMMY,
> + SPI_MEM_OP_DATA_OUT(1, buf, 1));
> +
> + if (!enable)
> + spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
> +
> + ret = spi_mem_exec_op(nor->spimem, &op);
> + if (ret)
> + return ret;
> +
> + /* Give some time for the mode change to take place. */
> + usleep_range(1000, 1500);
> +
This delay is no longer needed right? I can drop it while applying, if
you confirm.
Tudor: Could you provide your R-by?
Regards
Vignesh
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
next prev parent reply other threads:[~2020-11-07 7:59 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-10-05 15:31 [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg, write_reg, erase}() Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 03/15] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 04/15] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 05/15] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-10-27 9:58 ` Tudor.Ambarus
2020-10-05 15:31 ` [PATCH v16 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 07/15] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 08/15] mtd: spi-nor: Introduce SNOR_F_IO_MODE_EN_VOLATILE Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 09/15] mtd: spi-nor: Parse SFDP SCCR Map Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 10/15] mtd: spi-nor: core: enable octal DTR mode when possible Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 12/15] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 13/15] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-11-07 7:58 ` Vignesh Raghavendra [this message]
2020-11-09 11:45 ` Pratyush Yadav
2020-11-09 13:28 ` Tudor.Ambarus
2020-10-05 15:31 ` [PATCH v16 15/15] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-10-06 8:11 ` Tudor.Ambarus
2020-10-28 7:53 ` [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support Tudor.Ambarus
2020-10-28 12:49 ` Pratyush Yadav
2020-10-28 15:21 ` Tudor.Ambarus
2020-10-28 20:02 ` Pratyush Yadav
2020-10-29 6:26 ` Vignesh Raghavendra
2020-11-09 17:25 ` Vignesh Raghavendra
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=7d058da8-90ef-8f71-fe86-cc0b27a2895a@ti.com \
--to=vigneshr@ti.com \
--cc=boris.brezillon@collabora.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=nsekhar@ti.com \
--cc=p.yadav@ti.com \
--cc=richard@nod.at \
--cc=tudor.ambarus@microchip.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).