Linux-RISC-V Archive on
 help / color / Atom feed
* [PATCH] clk: sifive: restrict Kconfig scope for the FU540 PRCI driver
@ 2019-05-13 20:07 Paul Walmsley
  2019-05-13 20:22 ` Stephen Boyd
  0 siblings, 1 reply; 2+ messages in thread
From: Paul Walmsley @ 2019-05-13 20:07 UTC (permalink / raw)
  To: sboyd, mturquette, pavel
  Cc: linux-riscv, Paul Walmsley, Paul Walmsley, linux-kernel, linux-clk

Restrict Kconfig scope for SiFive clock and reset IP block drivers
such that they won't appear on most configurations that are unlikely
to support them.  This is based on a suggestion from Pavel Machek
<>.  Ideally this should be dependent on
CONFIG_ARCH_SIFIVE, but since that Kconfig directive does not yet
exist, add dependencies on RISCV or COMPILE_TEST for now.

Signed-off-by: Paul Walmsley <>
Signed-off-by: Paul Walmsley <>
Cc: Michael Turquette <>
Cc: Stephen Boyd <>
Cc: Pavel Machek <>
 drivers/clk/sifive/Kconfig | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/clk/sifive/Kconfig b/drivers/clk/sifive/Kconfig
index 8db4a3eb4782..27a8fe531357 100644
--- a/drivers/clk/sifive/Kconfig
+++ b/drivers/clk/sifive/Kconfig
@@ -2,6 +2,7 @@
 menuconfig CLK_SIFIVE
 	bool "SiFive SoC driver support"
+	depends on RISCV || COMPILE_TEST
 	  SoC drivers for SiFive Linux-capable SoCs.
@@ -10,6 +11,7 @@ if CLK_SIFIVE
 	bool "PRCI driver for SiFive FU540 SoCs"
+	depends on RISCV || COMPILE_TEST
 	  Supports the Power Reset Clock interface (PRCI) IP block found in
 	  FU540 SoCs.  If this kernel is meant to run on a SiFive FU540 SoC,

linux-riscv mailing list

^ permalink raw reply	[flat|nested] 2+ messages in thread

end of thread, back to index

Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2019-05-13 20:07 [PATCH] clk: sifive: restrict Kconfig scope for the FU540 PRCI driver Paul Walmsley
2019-05-13 20:22 ` Stephen Boyd

Linux-RISC-V Archive on

Archives are clonable:
	git clone --mirror linux-riscv/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-riscv linux-riscv/ \
	public-inbox-index linux-riscv

Newsgroup available over NNTP:

AGPL code for this site: git clone public-inbox