Linux-SPI Archive on lore.kernel.org
 help / color / Atom feed
From: Pratyush Yadav <p.yadav@ti.com>
To: Michael Walle <michael@walle.cc>
Cc: Nishanth Menon <nm@ti.com>, Tero Kristo <kristo@kernel.org>,
	Rob Herring <robh+dt@kernel.org>,
	Tudor Ambarus <tudor.ambarus@microchip.com>,
	Miquel Raynal <miquel.raynal@bootlin.com>,
	Richard Weinberger <richard@nod.at>,
	Vignesh Raghavendra <vigneshr@ti.com>,
	Mark Brown <broonie@kernel.org>,
	<linux-arm-kernel@lists.infradead.org>,
	<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
	<linux-mtd@lists.infradead.org>, <linux-spi@vger.kernel.org>,
	Lokesh Vutla <lokeshvutla@ti.com>
Subject: Re: [RFC PATCH 5/6] spi: cadence-qspi: Tune PHY to allow running at higher frequencies
Date: Fri, 30 Apr 2021 11:12:09 +0530
Message-ID: <20210430054207.gakq7evf47igzcm4@ti.com> (raw)
In-Reply-To: <143b24c61109823f6e616cf91d28d16c@walle.cc>

On 30/04/21 12:48AM, Michael Walle wrote:
> Am 2021-03-11 20:12, schrieb Pratyush Yadav:
> > +	if (of_property_read_u32(np, "cdns,phy-tx-start",
> > &f_pdata->phy_tx_start))
> > +		f_pdata->phy_tx_start = 16;
> > +
> > +	if (of_property_read_u32(np, "cdns,phy-tx-end", &f_pdata->phy_tx_end))
> > +		f_pdata->phy_tx_end = 48;
> > +
> 
> I didn't see a dt-bindings patch for these.

Right. Will add them in the next re-roll.
 
> -michael

-- 
Regards,
Pratyush Yadav
Texas Instruments Inc.

  reply index

Thread overview: 33+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-03-11 19:12 [RFC PATCH 0/6] spi: Add OSPI PHY calibration support for spi-cadence-quadspi Pratyush Yadav
2021-03-11 19:12 ` [RFC PATCH 1/6] spi: spi-mem: Tell controller when device is ready for calibration Pratyush Yadav
2021-03-23 23:07   ` Michael Walle
2021-03-24  8:08     ` Pratyush Yadav
2021-04-29 16:23       ` Michael Walle
2021-04-29 18:41         ` Pratyush Yadav
2021-04-29 22:46           ` Michael Walle
2021-03-11 19:12 ` [RFC PATCH 2/6] mtd: spi-nor: core: consolidate read op creation Pratyush Yadav
2021-03-23 23:17   ` Michael Walle
2021-03-24  8:04     ` Pratyush Yadav
2021-04-08 12:48   ` Michael Walle
2021-03-11 19:12 ` [RFC PATCH 3/6] mtd: spi-nor: core: run calibration when initialization is done Pratyush Yadav
2021-03-11 19:12 ` [RFC PATCH 4/6] spi: cadence-qspi: Use PHY for DAC reads if possible Pratyush Yadav
2021-03-12  9:13   ` Tudor.Ambarus
2021-03-12 10:17     ` Pratyush Yadav
2021-04-29 16:28       ` Michael Walle
2021-04-29 18:19         ` Pratyush Yadav
2021-04-29 22:20           ` Michael Walle
2021-05-10 11:39             ` Pratyush Yadav
2021-03-11 19:12 ` [RFC PATCH 5/6] spi: cadence-qspi: Tune PHY to allow running at higher frequencies Pratyush Yadav
2021-04-29 22:48   ` Michael Walle
2021-04-30  5:42     ` Pratyush Yadav [this message]
2021-03-11 19:12 ` [RFC PATCH 6/6] arm64: dts: ti: k3-j721e-som-p0: Enable PHY calibration Pratyush Yadav
2021-03-12  9:09 ` [RFC PATCH 0/6] spi: Add OSPI PHY calibration support for spi-cadence-quadspi Tudor.Ambarus
2021-03-12 10:10   ` Pratyush Yadav
2021-03-12 10:20     ` Michael Walle
2021-03-12 11:07       ` Pratyush Yadav
2021-03-12 13:26         ` Michael Walle
2021-03-12 11:23     ` Tudor.Ambarus
2021-03-12 18:14       ` Pratyush Yadav
2021-03-12 13:32 ` Michael Walle
2021-03-12 14:59   ` Tudor.Ambarus
2021-03-12 17:00   ` Pratyush Yadav

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20210430054207.gakq7evf47igzcm4@ti.com \
    --to=p.yadav@ti.com \
    --cc=broonie@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=kristo@kernel.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-spi@vger.kernel.org \
    --cc=lokeshvutla@ti.com \
    --cc=michael@walle.cc \
    --cc=miquel.raynal@bootlin.com \
    --cc=nm@ti.com \
    --cc=richard@nod.at \
    --cc=robh+dt@kernel.org \
    --cc=tudor.ambarus@microchip.com \
    --cc=vigneshr@ti.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-SPI Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-spi/0 linux-spi/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-spi linux-spi/ https://lore.kernel.org/linux-spi \
		linux-spi@vger.kernel.org
	public-inbox-index linux-spi

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-spi


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git