Linux-Watchdog Archive on lore.kernel.org
 help / color / Atom feed
* [PATCH] watchdog: clean up the Kconfig file
@ 2021-04-19  0:07 Randy Dunlap
  2021-05-03 19:17 ` Guenter Roeck
  0 siblings, 1 reply; 2+ messages in thread
From: Randy Dunlap @ 2021-04-19  0:07 UTC (permalink / raw)
  To: linux-kernel
  Cc: Randy Dunlap, Wim Van Sebroeck, Guenter Roeck, linux-watchdog

Change a non-working ftp: URL to https:.
Wrap long lines earlier.
Spell "IP" with capital letters.
Change "it`s" to "it's". The backtick (grave accent) is not an apostrophe.

Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Cc: Wim Van Sebroeck <wim@linux-watchdog.org>
Cc: Guenter Roeck <linux@roeck-us.net>
Cc: linux-watchdog@vger.kernel.org
---
 drivers/watchdog/Kconfig |   53 ++++++++++++++++++++-----------------
 1 file changed, 29 insertions(+), 24 deletions(-)

--- linux-next-20210416.orig/drivers/watchdog/Kconfig
+++ linux-next-20210416/drivers/watchdog/Kconfig
@@ -22,9 +22,9 @@ menuconfig WATCHDOG
 
 	  The watchdog is usually used together with the watchdog daemon
 	  which is available from
-	  <ftp://ibiblio.org/pub/Linux/system/daemons/watchdog/>. This daemon can
-	  also monitor NFS connections and can reboot the machine when the process
-	  table is full.
+	  <https://ibiblio.org/pub/Linux/system/daemons/watchdog/>. This daemon
+	  can also monitor NFS connections and can reboot the machine when the
+	  process table is full.
 
 	  If unsure, say N.
 
@@ -302,7 +302,7 @@ config XILINX_WATCHDOG
 	depends on HAS_IOMEM
 	select WATCHDOG_CORE
 	help
-	  Watchdog driver for the xps_timebase_wdt ip core.
+	  Watchdog driver for the xps_timebase_wdt IP core.
 
 	  To compile this driver as a module, choose M here: the
 	  module will be called of_xilinx_wdt.
@@ -404,8 +404,8 @@ config ASM9260_WATCHDOG
 	select WATCHDOG_CORE
 	select RESET_CONTROLLER
 	help
-	  Watchdog timer embedded into Alphascale asm9260 chips. This will reboot your
-	  system when the timeout is reached.
+	  Watchdog timer embedded into Alphascale asm9260 chips. This will
+	  reboot your system when the timeout is reached.
 
 config AT91RM9200_WATCHDOG
 	tristate "AT91RM9200 watchdog"
@@ -548,8 +548,9 @@ config OMAP_WATCHDOG
 	depends on ARCH_OMAP16XX || ARCH_OMAP2PLUS || COMPILE_TEST
 	select WATCHDOG_CORE
 	help
-	  Support for TI OMAP1610/OMAP1710/OMAP2420/OMAP3430/OMAP4430 watchdog.  Say 'Y'
-	  here to enable the OMAP1610/OMAP1710/OMAP2420/OMAP3430/OMAP4430 watchdog timer.
+	  Support for TI OMAP1610/OMAP1710/OMAP2420/OMAP3430/OMAP4430 watchdog.
+	  Say 'Y' here to enable the
+	  OMAP1610/OMAP1710/OMAP2420/OMAP3430/OMAP4430 watchdog timer.
 
 config PNX4008_WATCHDOG
 	tristate "LPC32XX Watchdog"
@@ -1096,13 +1097,16 @@ config SBC_FITPC2_WATCHDOG
 	  This is the driver for the built-in watchdog timer on the fit-PC2,
 	  fit-PC2i, CM-iAM single-board computers made by Compulab.
 
-	  It`s possible to enable watchdog timer either from BIOS (F2) or from booted Linux.
-	  When "Watchdog Timer Value" enabled one can set 31-255 s operational range.
-
-	  Entering BIOS setup temporary disables watchdog operation regardless to current state,
-	  so system will not be restarted while user in BIOS setup.
+	  It's possible to enable the watchdog timer either from BIOS (F2) or
+	  from booted Linux.
+	  When the "Watchdog Timer Value" is enabled one can set 31-255 seconds
+	  operational range.
+
+	  Entering BIOS setup temporarily disables watchdog operation regardless
+	  of current state, so system will not be restarted while user is in
+	  BIOS setup.
 
-	  Once watchdog was enabled the system will be restarted every
+	  Once the watchdog is enabled the system will be restarted every
 	  "Watchdog Timer Value" period, so to prevent it user can restart or
 	  disable the watchdog.
 
@@ -1124,11 +1128,12 @@ config IB700_WDT
 	depends on X86
 	help
 	  This is the driver for the hardware watchdog on the IB700 Single
-	  Board Computer produced by TMC Technology (www.tmc-uk.com). This watchdog
-	  simply watches your kernel to make sure it doesn't freeze, and if
-	  it does, it reboots your computer after a certain amount of time.
+	  Board Computer produced by TMC Technology (www.tmc-uk.com). This
+	  watchdog simply watches your kernel to make sure it doesn't freeze,
+	  and if it does, it reboots your computer after a certain amount of time.
 
-	  This driver is like the WDT501 driver but for slightly different hardware.
+	  This driver is like the WDT501 driver but for slightly different
+	  hardware.
 
 	  To compile this driver as a module, choose M here: the
 	  module will be called ib700wdt.
@@ -1807,10 +1812,10 @@ config PIC32_DMT
 	select WATCHDOG_CORE
 	depends on MACH_PIC32 || (MIPS && COMPILE_TEST)
 	help
-	  Watchdog driver for PIC32 instruction fetch counting timer. This specific
-	  timer is typically be used in misson critical and safety critical
-	  applications, where any single failure of the software functionality
-	  and sequencing must be detected.
+	  Watchdog driver for PIC32 instruction fetch counting timer. This
+	  specific timer is typically be used in mission critical and safety
+	  critical applications, where any single failure of the software
+	  functionality and sequencing must be detected.
 
 	  To compile this driver as a loadable module, choose M here.
 	  The module will be called pic32-dmt.
@@ -2013,8 +2018,8 @@ config PCWATCHDOG
 	  This card simply watches your kernel to make sure it doesn't freeze,
 	  and if it does, it reboots your computer after a certain amount of
 	  time. This driver is like the WDT501 driver but for different
-	  hardware. Please read <file:Documentation/watchdog/pcwd-watchdog.rst>. The PC
-	  watchdog cards can be ordered from <http://www.berkprod.com/>.
+	  hardware. Please read <file:Documentation/watchdog/pcwd-watchdog.rst>.
+	  The PC watchdog cards can be ordered from <http://www.berkprod.com/>.
 
 	  To compile this driver as a module, choose M here: the
 	  module will be called pcwd.

^ permalink raw reply	[flat|nested] 2+ messages in thread

* Re: [PATCH] watchdog: clean up the Kconfig file
  2021-04-19  0:07 [PATCH] watchdog: clean up the Kconfig file Randy Dunlap
@ 2021-05-03 19:17 ` Guenter Roeck
  0 siblings, 0 replies; 2+ messages in thread
From: Guenter Roeck @ 2021-05-03 19:17 UTC (permalink / raw)
  To: Randy Dunlap; +Cc: linux-kernel, Wim Van Sebroeck, linux-watchdog

On Sun, Apr 18, 2021 at 05:07:03PM -0700, Randy Dunlap wrote:
> Change a non-working ftp: URL to https:.
> Wrap long lines earlier.
> Spell "IP" with capital letters.
> Change "it`s" to "it's". The backtick (grave accent) is not an apostrophe.
> 
> Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
> Cc: Wim Van Sebroeck <wim@linux-watchdog.org>
> Cc: Guenter Roeck <linux@roeck-us.net>
> Cc: linux-watchdog@vger.kernel.org

Reviewed-by: Guenter Roeck <linux@roeck-us.net>

Guenter

^ permalink raw reply	[flat|nested] 2+ messages in thread

end of thread, back to index

Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2021-04-19  0:07 [PATCH] watchdog: clean up the Kconfig file Randy Dunlap
2021-05-03 19:17 ` Guenter Roeck

Linux-Watchdog Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-watchdog/0 linux-watchdog/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-watchdog linux-watchdog/ https://lore.kernel.org/linux-watchdog \
		linux-watchdog@vger.kernel.org
	public-inbox-index linux-watchdog

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-watchdog


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git